Calibration Gas Standards Equipment For Monitoring And Testing Near Afghanistan
-
PremiumManufactured by BWB Technologies Ltd.based in UNITED KINGDOM
Finally, a Flame Photometer specific to your needs. The first simultaneous Flame Photometer with built in compressor and configurable element analysis to your requirements. The BWB Flash is the first and only fully configurable up to four channel flame photometer that detects and displays all calibrated ions at the same ...
-
Manufactured by AMETEK Process Instrumentsbased in USA
The 914 is a built-to-order Continuous Emission Monitor (CEM) that includes all the components needed for a compliance monitoring and reporting project. The system uses dry extractive sampling techniques designed to meet government regulations for all types of compliance ...
-
based in UNITED KINGDOM
Markes’ Calibration Solution Loading Rig (CSLR) has been designed for loading sorbent tubes with gas- or liquid-phase standards. It allows you to calibrate the entire TD–GC–MS analytical system for qualitative and quantitative analysis. It is used as part of routine quantitative analysis, or when changing methods and/or analytical conditions. 9.5 mm - pk ...
-
based in UNITED KINGDOM
Markes’ Calibration Solution Loading Rig (CSLR) has been designed for loading sorbent tubes with gas- or liquid-phase standards. It allows you to calibrate the entire TD–GC–MS analytical system for qualitative and quantitative analysis. It is used as part of routine quantitative analysis, or when changing methods and/or analytical conditions. Used to load liquid and gas ...
-
Manufactured by Teledyne Hastings Instrumentsbased in USA
Teledyne Hastings Instruments (THI) products represent over 60 years of experience in the design and manufacture of mass flow products. The all-metal seal 300 Series Metaline is a culmination of this experience with patented technologies that make these instruments the finest flowmeters and controllers available ...
-
Manufactured by AlyTechbased in FRANCE
On-site customized gas standard preparation has never been easier than with the Zephyr – a compact version of GasMix™. Due to its small size and embedded software, the Zephyr can be installed where you need it. With 5″ touch screen and intuitive interface the diluter is very simple in operation and widely used for various applications that involve only 2 gases. For example, the ...
-
Manufactured by General Monitors by MSAbased in USA
The Model S4100C Intelligent Sensor is a microprocessor-based transmitter with integral three-digit readout. It is designed to measure and display concentrations of combustible gases in the 0-100% LEL range, but will continue to display concentrations up to 120% LEL. The sensing element may be incorporated in the transmitter housing or remotely mounted at distances of 600 meters. The S4100C will ...
-
Manufactured by General Monitors by MSAbased in USA
The S4100T Intelligent Sensor is a highly reliable, self-contained, microprocessor-controlled hydrogen sulphide transmitter with integral 3 digit readout. It is designed to measure and display concentrations of H2S in the 0-20 ppm, 0-50 ppm or 0-100 ppm range, but will continue to display concentrations up to 120% FSD. The sensing element may be incorporated in the transmitter housing or remotely ...
-
Manufactured by General Monitors by MSAbased in USA
The Model S4000CH Intelligent Sensor is a microprocessor-based transmitter designed for use with General Monitors' robust catalytic bead sensors. The unit features one person calibration and can virtually self-calibrate by simply activating a magnetic switch and applying gas. It is designed to monitor combustible gases and vapors within the lower explosive limit (LEL) and provide status ...
-
PremiumManufactured by Environics, Inc.based in USA
The Environics Series 4000 UHP Gas Mixing System combines the accuracy and repeatability of the Series 4000 with a welded, Ultra-High-Purity (UHP) construction. All units are optimized for your target gases. With all metal seals, units are commonly used for both research & development and/or production applications, including calibration of analytical tools that detect impurities in ...
-
PremiumManufactured by Environics, Inc.based in USA
Purity of gas blends is assured with the Series 4020UHP Ultra-High Purity Gas Mixing/Dilution System. Manufactured with metal seal MFC’s and orbitally welded joints, the system has minimal dead volume and maintains a low leak rate to prevent atmospheric contamination of gas calibration standards. An ideal system for providing those in the semiconductor, aerospace, research/biotech and ...
-
PremiumManufactured by Environics, Inc.based in USA
The Series 4000 consists of a single chassis now supporting up to eight mass flow controllers. The mass flow controllers are factory calibrated using a primary flow standard traceable to the United States National Institute of Standards and Technology (NIST). Each flow controller utilizes an 11 point calibration table with linear interpolation, to increase accuracy and reduce flow controller ...
-
PremiumManufactured by Environics, Inc.based in USA
Purity of calibration gases is assured with the Series 4040 Ultra-High Purity (UHP) Gas Dilution System. Manufactured with metal seal MFC’s and orbitally welded joints, the system has minimal dead volume and maintains a low leak rate to prevent atmospheric contamination of gas calibration standards. An ideal system for providing those in the semiconductor, aerospace, research/biotech and ...
-
PremiumManufactured by Environics, Inc.based in USA
The Environics® Series 4040 is a computerized gas dilution system that automatically generates precise gas standards for rapid multi-point calibration of analyzers. The gas mixes can be used in generating precise gas calibration standards, creating gaseous atmospheres or producing gas mixes for analytical research or production purposes. The Series 4040 can produce gas concentrations from ...
-
PremiumManufactured by Environics, Inc.based in USA
The Environics® Series 4020 can mix up to seven (7) component gases simultaneously to generate precise gas calibration standards and gaseous atmospheres in a broad dynamic range. The dilution capabilities of the Series 4020 allows dilution ratios from 1:1 to 10,000:1 (with larger ranges possible, depending on the configuration of the system). It provides a low cost, computerized gas ...
-
Manufactured by Alicat Scientific, Inc.based in USA
Control flow in both directions with the world’s first bidirectional mass flow controller. Maintain speed and accuracy at flows as low as 2.5 microliters per minute or as high as 50 slpm. Alicat Scientific proudly introduces the world’s first bidirectional flow controller. Control flows into your process in one direction, and then switch directions. Or control flows into a closed ...
-
Manufactured by Hemaki Lab-Services Pvt. Ltd.based in INDIA
Portable Oxygen Analyser is designed for accurate and reliable measurement of Oxygen in Air, Nitrogen. Argon. Hydrogen etc. These are based on : Electro chemical Oxygen Sensors, and provide fast response. They require no periodic maintenance like replacing electrodes or electrolyte and can be calibrated using ambient air or standard calibration gas. A digital display provides direct percentage ...
-
Manufactured by Hemaki Lab-Services Pvt. Ltd.based in INDIA
The hydrogen purity meter is an electronic device to analyze the purity of Hydrogen gas. It is equipped with 3 ½ inch LED digital display which shows all the calculated readings. It requires calibration gas near sample gas for the readings to be calculated. Additionally, it has imported TCD filament which aids in accurate sensing. Further we can also customize this meter as per the ...
-
Manufactured by Chemtron Science Laboratories Private Limitedbased in INDIA
CSL offers a complete line of gas calibration standards from a single source which allows its customers to save time and money by consolidating vendors and centralizing responsibility. CSL offers certified gas standards which provides the ultimate in accuracy and traceability for the most demanding analytical applications, such as process analyzers in refineries and ...
-
Manufactured by Bronkhorst High-Tech B.Vbased in NETHERLANDS
MASS-VIEW model MV-102 Direct Thermal Mass Flow Meters (MFMs) are suited for precise measurement of flow ranges between 20…200 mln/min and 20…2000 mln/min at operating pressures up to 10 bar(g). The MFM has an integrated graphical OLED display, clearly visible at wide angles, which allows reading of actual flow (value and a bar graph), total flow and type of gas. The display ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you