Condensate Monitoring Applications

4 Results found
Only show results available in Virginia?
OK
  • Category: Monitoring & Testing ×

  • Subcategory: Condensate Monitoring ×

Water quality monitoring systems for feedwater, storm & condensate industry

by SWAN Analytische Instrumente AG     based in Hinwil, SWITZERLAND

The most important parameters in Water/Steam Cycles such as Cation conductivity, dissolved oxygen and pH are available as pre-assembled and factory tested units. Dedicated analyzers for sodium, silica, phosphate and hydrazine are also factory tested and calibrated for immediate operation.

Wet gas monitoring for refineries

by Kurz Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

Thermal mass flow meters provide excellent measurement capabilities in dry gas flows. They have proven durability, accuracy, and repeatability. However, thermal flow meters are sensitive to liquid droplets in a wet gas stream. For a thermal flow meter to work accurately in a condensing gas environment, the probe must be placed far enough downstream so that the entrained water has condensed onto the pipe wall. In a very wet environment, any condensing liquid (commonly referred to as mist or fog) contacting the sensor probes causes a high reading due to the liquid vaporizing on the heated portion of the sensor. As a result of this deficiency, measurements with conventional thermal meters are largely ignored when moisture levels rise because there is no confidence that the measurements are true.

pH value and conductivity measurement for power plants

by Metrohm AG     based in Herisau, SWITZERLAND

The pH value and the conductivity have to be determined quasi-continuously at numerous locations in a power plant. The pH value is a key parameter to control the amount of lithium hydroxide that has to be added to the primary circuit of a pressurized water reactor; in water steam circuits, the pH value controls the amount of added amines. The conductivity indicates the amount of dissolved minerals. It is a measure of the water purity and is one of the most important parameters for any chemical control program in a power plant. It is determined at numerous sampling points in the power plant, for example, in the cooling water circuit, in feed and makeup water, at the outlet of the condensate pump, and in the primary circuit of a pressurized water reactor.

Clean drinking water monitoring solutions for wastewater treatment industry

by Pollution & Process Monitoring Ltd     based in Sevenoaks, UNITED KINGDOM

Continuous on-line monitoring can be used to alarm unacceptable deviations from established control points and to ensure quality standards are maintained.

Need help finding the right suppliers?

Let the XPRTs do the work for you