Continuous Emissions Monitoring (CEMS) Applications in Bahrain

  • Premium

    Emissions Monitoring

    The Opsis monitoring solution in aluminium smelters is based on either DOAS or laser diode technique. The on-line, open-path systems are used for monitoring HF and sulphur dioxide in potrooms, in fence-line applications and in continuous emissions monitoring. Opsis has long experience of monitoring in aluminium smelters.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for mercury monitoring

    Waste incinerators, cement plants and power plants need good and reliable measurements of total gaseous mercury. The measurement of total gaseous mercury is a challenge due to chemical reactions and contamination. The installed systems will often require a lot of maintanence still not giving reliable results.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for glass manufacturing industries

    Process control and emissions monitoring in a glass manufacturing plant is a challenge due to high temperature in the flue gas. The OPSIS DOAS system provides the glass industry with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method that uses an optical path to measure across the duct. A single OPSIS system will measure all relevant gas componensts such as NOX, SO2, CO, CO2, H2O, O2, and others.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for brick plants

    Process control and emissions monitoring in a brick plant is a challenge due to the high concentrations of HF. The HF is generated in the process and gas phase HF can reach 50 mg/m3 or more. To use an extractive system in this environment will demand a lot of maintanence.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for cement industry

    Process control and emissions monitoring in cement plants, can be a challenge due to the dusty and corrosive environment. OPSIS provides an accurate system that will operate with high performance and a minimum of maintenance.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for sulphuric acid production plants

    The process control of a sulphuric acid plant needs good and reliable detection of gas phase sulphur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every day.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Emissions Monitoring for Steel Mills

    Steel mills include a multitude of activities that generate gaseous emissions. Besides continuous emissions stack monitoring, the applications in a steel mill also include process mesaurements that provides important data to the operators in order to optimize the steel making process.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Fence-Line Monitoring of Fugitive Emissions

    The Opsis open path monitoring system is an excellent tool for monitoring air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan software.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for aluminium smelters

    Process control and emissions monitoring in an aluminium smelter is a challenge due to the high concentrations of HF. To use an extractive system in this environment will demand a lot of maintenance.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Emissions Monitoring for Airports

    Opsis systems provide high-performance monitoring of the emission activities within an airport. The rapid system allows on-line monitoring of the emissions from each aircraft at take-offs and landings, monitoring of fugitive emissions from stationary sources and differing of the airport sources from the surrounding pollution sources.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for power plants

    OPSIS offers fully automated system solutions for continuous monitoring in power plants. The monitoring systems have been tested and approved by the German TÜV and the U.S. EPA among others, for the best performance and longest calibration interval.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for mineral wool production

    Process control and emissions monitoring in a mineral wool plant is a challenge due to the presence of phenol and formaldehyde. To use an extractive system in this environment will demand a lot of maintenance. The OPSIS DOAS system is different and provides plants with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method using an optical measurement path that can operate across the duct.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Premium

    Continuous emissions monitoring for CO2 capture

    The process control of a CO2 capture plant needs good and reliable detection of gas phase NH3 and CO2. Measuring NH3 is a challenge due to the corrosive environment and high concentrations of NH3. Several places in the process needs to be monitored and to transport the sample is difficult. A large dynamic range is needed as the NH3 concentration can vary between 15% volume and a few mg/m3.

    By Opsis AB Distributor in Manama, BAHRAIN.

  • Measurement solution for accurate continuous formaldehyde measurement formaldehyde in emissions and ambient air applications

    Formaldehyde (HCHO) is the simplest aldehyde species and is present, or generated by, many sources (both natural and industrial). It is classed as a substance that is toxic and harmful to human health.

    By Protea Limited Distributor in Manama, BAHRAIN.

  • Measurement solution for WID Emissions Monitoring

    Protea is the most experienced company in the UK in using FTIR gas analyser to measure emissions. Through running a UKAS-accredited test house and being a manufacturer of gas analysers, we have been involved in FTIR as a supplier and end-user for 10 years.

    By Protea Limited Distributor in Manama, BAHRAIN.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you