Environmental Sampling Applications

34 Results found
Only show results in Virginia?
OK
  • Category: Monitoring & Testing ×

  • Subcategory: Environmental Sampling ×

Particulates PM10 PM2.5 TSP monitoring

by Ecotech Pty Ltd     based in Knoxfield, AUSTRALIA

Sampling dust and particulate matter is important as dust and particulate matter can affect the health of human populations, as well as the natural environment. Dust and particulate matter can cause respiratory problems when breathed in by humans. Dust and particulates above 10 micrometer (PM10) are filtered and generally do not enter the lungs.

Saran Bag application

by Analytical Specialties, Inc.     based in Elburn, ILLINOIS (USA)

Title : Preliminary Sampling Methodology and Analytical Procedures for Ambient Sulfur Hexafluoride, Corporate Author : ARMY MEDICAL ENVIRONMENTAL ENGINEERING RESEARCH UNIT EDGEWOOD ARSENAL MD Personal Author(s) : Luckan,Susan K. ; Cooper,William J. Report Date : JAN 1973 Pagination or Media Count : 23 Abstract : A preliminary evaluation of techniques of sampling and gas chromatographic analysis for low levels of sulfur hexafluoride was conducted to determine the most feasible method for available equipment. Using a Tracor MT-150 gas chromatograph equipped with Nickel 63 electron capture detector and polarized dc voltable, it was possible to detect sulfur hexafluoride at a concentration of 0.06 ppb with a 5A molecular sieve column and nitrogen carrier gas, without preconcentration of the sample. Also, a comparison of glass and Saran sampling materials proved that no detectable loss of the tracer gas resulted with the Saran bags (between 6 ppm and 0.06 ppb SF6

Data analysis and visualization tools for monitoring well decommissioning

by C Tech Development Corporation     based in Henderson, NEVADA (USA)

Contaminated groundwater sites worldwide are engaged in regular sampling of monitoring wells at a typical cost of $1,500 per well-sampling event. On most sites, many wells are redundant or geostatistically insignificant and can be decommissioned.
EVS-PRO and MVS`s Well Decommission module analyses all available data and quantifies the impact on site assessment quality associated with removing each well. The impact of removing a well is quantified in terms of its impact on the geostatistical plume extent.
During remediation plumes are shrinking and may drift. This can necessitate decommissioning of some wells and adding new wells. C Tech`s well decommissioning and DrillGuide© technology provide the tools to properly monitor and guide the remediation efforts at the lowest possible cost.

Sampling and drilling equipments for the mining industry

by Art’s Manufacturing and Supply, Inc. (AMS Inc.)     based in American Falls, IDAHO (USA)

AMS, Inc. has been a leading provider of high quality sampling equipment since 1942. AMS sampling equipment is primarily used for environmental, geotechnical, and remediation uses as well as soil, soil gas, and groundwater monitoring. In addition, AMS makes PowerProbe direct push/hollowstem auger drill rigs for environmental and geotechnical drilling activities. AMS also manufactures and offers direct push tooling, drilling equipment, accessories, and expendables for soil sampling, groundwater sampling and monitoring well installations.

Sampling and drilling equipments for the agriculture industry

by Art’s Manufacturing and Supply, Inc. (AMS Inc.)     based in American Falls, IDAHO (USA)

Farmers and researchers in the agricultural industry have used AMS sampling equipment for over 50 years. The AMS Step Probe, Soil Recovery Probes, and a variety of one and two-piece augers are used in the agricultural sampling market to obtaining disturbed samples at or near the surface and for boring to depths where more precise samples can be obtained. AMS now offers a variety of nematode sampling equipment, ATV-mounted PowerProbe rigs, and one and two-piece open-faced augers.

Parallel evaporation in environmental consultancy

by BÜCHI Labortechnik AG     based in Postfach, SWITZERLAND

For a fast and effcient sample concentration in order to monitor de pollution of the environment

Air sampling & monitoring systems for defense/military sector

by HI-Q Environmental Products Company     based in San Diego, CALIFORNIA (USA)

From portable hand held battery operated to rugged field deployable, military organizations worldwide rely of HI-Q air sampling systems & accessories during research, development, test and evaluation (RDT&E) and for reliable protection of personnel from Nuclear Biological Chemical Threats. HI-Q’s emergency response air sampling kits have offered the Defense & Military Industries a way of recognizing, determining and identifying the presence of harmful Biological & Nuclear Threats.

PTR-MS systems for biological research

by Ionicon Analytik Ges.m.b.H.     based in Innsbruck, AUSTRIA

Real-time measurement of plant defense and leaf wounding reactions. Measurement of VOCs in dynamic biological systems with low detection limit and without sample preparation.

Air sampling & monitoring systems for government sector

by HI-Q Environmental Products Company     based in San Diego, CALIFORNIA (USA)

HI-Q serves the needs of various government agencies with a wide range of application-specific, customized air sampling products. HI-Q works directly with governmental agencies such as the Environmental Protection Agency (EPA), Department of Energy (DOE), Department of Defense (DOD) & Department of Homeland Security (DHS) to develop situation specific, cutting edge air sampling products to help recognize potential threats. Since September 11, 2001, HI-Q continues to have an ongoing relationship with the EPA & DHS by continually working on government-funded projects for the development of airborne biohazard collection systems.

Personal air sampling

by Casella     based in Kempston, UNITED KINGDOM

Bodily worn equipment and associated accessories and sampling media for undertaking personal air samples onto media which is then further analysed. Used for measuring employees` exposure to dusts, fumes, gases or vapours

Air sampling for emergencies

by Casella     based in Kempston, UNITED KINGDOM

Deployable battery operated monitoring systems for measurement of dusts (PM10, PM2.5), gases and vapours. Generally used for measurements of site boundaries or chemical incidents

Gas monitoring instruments and systems for stack testing

by Gasmet Technologies Oy     based in Helsinki, FINLAND

Several EU directives and national laws in European countries set requirements for continuous monitoring of flue gas emissions at power plants. Further requirements are set on the quality assurance of the installed measurement systems at the plants. The relevant standard in this regard is EN 14181:2004, the quality assurance of automated measuring systems. The standard dictates how to determine that the measurement systems installed for continuous emissions monitoring at a plant operate according to the directives and regulations set. Two major parts of this on-going quality assurance cycle are the QAL2 and AST procedures. A test laboratory performs tests on the systems on-site, and determines whether the systems fulfill the set requirements or not.

Measurement solution for HF emissions from brickworks

by Protea Limited     based in Middlewich, UNITED KINGDOM

Brick kilns, as well as other plants such as ceramics manufacturers and fertiliser producers, are a major producer of hydrogen fluoride (HF) emissions. HF is highly reactive gas and seriously damaging to human health, so has strict emissions limits imposed by legislation. In addition to the effects to humans, emissions have been found to damage crops and fruit trees, as well as the general environment. The brick industry strives to reduce the amount of HF emissions and numerous projects have been carried out into the research and development of proposed process modifications that introduce ways to reduce hydrogen fluoride emissions via the latest technology such as filters and scrubbers.

Iron & Steel Industry Emissions Monitoring & Analysis

by Procal - Parker Hannifin Corp     based in Peterborough, UNITED KINGDOM

Procal analysers are used throughout the steel process from initial sintering of ore, coke production, blast furnace emissions through to roll mill reheat furnace emissions.

Substitute fuel sampling system

by Erdwich Zerkleinerungssysteme GmbH     based in Kaufering, GERMANY

A critical eye for every sample! Analytical shredding systems for QA work are a fundamental preliminary component in the production of substitute fuels. With primary fuels and finite resources subject to continuous price increases, the significance of substitute fuels continues to rise unabated. For plant operators, this offers first-class potential and attractive prospects for the future. Businesses that buy in their substitute fuel from external suppliers are faced with two key analytical requirements before putting it to use: pollutant analysis and calorific analysis. To ensure the proper handling of these analyses, a sophisticated sampling system is required.

Carbon Dioxide Monitoring for Indoor Air Quality

by Edinburgh Instruments Ltd     based in Livingston, UNITED KINGDOM

Introduction: Accurate control of critical indoor environmental parameters is not only essential for the well-being and comfort of building occupants, but also has a major impact on energy efficiency. A multitude of parameters can affect indoor air quality (IAQ) from gases such as carbon dioxide, carbon monoxide and volatile organic compounds to particulates, humidity and bacteria such as legionella. Carbon dioxide is one of the greatest variables affecting indoor environmental quality since it is produced by people occupying the building. Carbon dioxide production is a function of the number, size and activity levels of the people present in the building. Local concentrations can therefore vary dramatically – for example when a meeting room is occupied, or while workers are on lunch or coffee breaks.

NOx analyzers for Automotive Mobile Sources

by ECO PHYSICS, INC.     based in Ann Arbor, MICHIGAN (USA)

NOx analyzers for transportation industry exhaust emissions. Options include a heated sample inlet for hot, moist engine exhaust, and AK protocol. View Automotive/Mobile Source Products

US Peroxide Rapid Response

by USP Technologies     based in Atlanta, GEORGIA (US) (USA)

US Peroxide (USP) is uniquely positioned to rapidly respond to your environmental treatment challenges. USP combines experienced applications and equipment field support with a large inventory of storage systems and pumping modules to respond quickly to time sensitive water and wastewater treatment situations. Advantages With considerable inventory of tank and pump systems as well as our partnerships with leading chemical suppliers, USP can mobilize chemicals and equipment quickly to respond to your rapid response needs, often within 24 hours. We offer dosing options are designed to meet all safety requirements and sized to meet your specific process and dosage rates requirements. Our Applications Engineers and Equipment and Engineering Services teams will provide timely and thorough applications assistance and technical support during the entire project. Download the Rapid Response Solutions Brochure (PDF) Sample Applications Examples of where our Rapid Response Program has successfully addressed treatment challenges include the following: Temporary application of hydrogen peroxide as a source of supplemental dissolved oxygen in biological treatment systems during periods of excessive BOD loading Hydrogen peroxide pretreatment of high strength wastewater to reduce toxicity or BOD/COD prior to biological treatment Emergency hydrogen peroxide treatment of lagoons or ponds to control hydrogen sulfide and other odors Shock cleaning of cooling water systems for biofouling and slime control

Need help finding the right suppliers?

Let the XPRTs do the work for you