EPA Methods Equipment For Monitoring And Testing In USA
-
ShowcaseManufactured by Cooper Environmental / Sailbri Cooper Inc.based in USA
The Xact® 920 system uses reel-to-reel filter tape sampling and nondestructive X-ray fluorescence (XRF) analysis to monitor aqueous samples for user-selected ...
-
PremiumManufactured by Optical Scientific Inc. (OSi)based in USA
The OFS-2000 has a range of 0-40m/sec and is the only flow sensor that gives a true non-contracting cross-stack flow measurement of the process. OSi's patented Optical Flow Sensor (OFS) makes drift-free measurements across the entire stack, duct or pipe diameter and calculates an accurate average flow reading. It is the only flow sensor that gives a true non-contacting cross-stack flow ...
-
PremiumManufactured by Cerex Monitoring Solutions, LLC.based in USA
Measurements: The UV Sentry is a parts per billion (ppb) to percent level chemical detection and quantification open-path UV-DOAS analyzer. It offers high-performing, time-resolved monitoring of a variety of regulated ...
-
PremiumManufactured by CETCObased in USA
SLURRYBOND 2000 G is a powdered inorganic mineral and polymer formula used for the the solidification of high solids drilling slurries. SLURRYBOND 2000 G is made from a non-biodegradable mineral and polymer mixture designed for use on waste slurry that fails to pass a Paint Filter Liquids Test (PFLT) or a slump test. SLURRYBOND 2000 G will solidify waste slurry on the job site and allow waste to ...
-
PremiumManufactured by HI-Q Environmental Products Company, Inc.based in USA
The EPA Clean Air Act of 1987 established a measuring standard to evaluate and monitor the health effects of thoracic inhaleable particles. The standard was set that in order for an environment to be healthy, in terms of these particles, it must have a concentration of less than 150 mg/m3 of particles with aerodynamic diameters less than 10 microns (mm). The standard has been deemed PM-10, ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M 3-800 Portable Heated Total Hydrocarbon Analyzer is a heavy duty FID analyzer to continuously measure the total concentration of hydrocarbons within a gaseous sample. This can be ambient air, exhaust gases from a combustion process e.g. stack emissions, from any type of an industrial vent, from an internal combustion engine, or from any other emission containing hydrocarbons. The 3-800 ...
-
PremiumManufactured by LNI Swissgasbased in SWITZERLAND
The Sonimix 2130 NOx converter tester has been designed to generate a stable NO2 concentration with a small reaction time. It is based on the sonic nozzles technology (ISO 6145-6 technology) and high stability pressure regulators. The NOx converter tester is often used together with a multi-steps gas divider also based on sonic nozzles and high precision pressure regulators. In order to validate ...
-
PremiumManufactured by Apex Instruments, Inc.based in USA
The Apex Instruments Compact Method 23 sampling system is utilized for US EPA Method 23 Determination of Dioxins and Furans from stationary sources. Dioxins and furans are an unwanted by-product of combustion processes such as municipal and industrial waste, wood and oil ...
-
PremiumManufactured by Cerex Monitoring Solutions, LLC.based in USA
The Cerex UV SENTRY is an open-path gas analyzer that specializes in sensitive detection of key hazardous emissions such as Benzene and Chlorine over 1000+ meters of fence-line paths. It sets the industry standard for time-resolved, gap-less fugitive emissions and chemical emergency monitoring across fence lines, around process units, and around tank farms. As the most cost-effective solution ...
-
PremiumManufactured by Cooper Environmental / Sailbri Cooper Inc.based in USA
The Quantitative Aerosol Generator (QAG) creates an aerosol of known concentration by nebulizing a solution. The resulting droplets are carried out of generation area to a drying chamber where they are dried to salt particles. Depending on the application for the salt particles the size can be varied to a number mean between 0.1 and 2 µm in diameter. The aerosol exiting the drying chamber ...
-
PremiumManufactured by Optical Scientific Inc. (OSi)based in USA
The OFS-2000P Particulate and Flow sensors report Air Flow and a general Particulate loading and percent opacity in virtually any operating condition. OSi's patented Optical Flow Sensor (OFS) makes drift-free measurements across the entire stack, duct or pipe diameter and calculates an accurate average flow reading. It is the only flow sensor that gives a true non-contacting cross-stack flow ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M 109L is a heated FID analyzer to continuously and simultaneously measure the Methane concentration, the Total Hydrocarbon concentration and the Non Methane concentration within a gaseous sample. The 109L is a table top or 19 inch rack mount Heated FID analyzer for the NMHC measurement in ambient air, exhaust gases from a combustion process e.g. stack emissions, from any type of an ...
-
PremiumManufactured by Optical Scientific Inc. (OSi)based in USA
The OFS-2000W model is equipped with Automatic Gain Control (AGC) to compensate for variations in opacity caused by particulate matter or moisture carried in the flow. OSi's patented Optical Flow Sensor (OFS) makes drift-free measurements across the entire stack, duct or pipe diameter and calculates a true average flow reading. The OFS 2000-W model is equipped with Automatic Gain Control (AGC) to ...
-
PremiumManufactured by Cerex Monitoring Solutions, LLC.based in USA
Based on years of the success with UV SENTRY, the Harsh Climate model was developed by Cerex’s engineers to meet the demand of open path analyzers that can output reliable data in the midst of extreme environmental conditions. Utilizing the same proprietary technology, the Harsh Climate model features all the benefits of the UV Sentry (Gas-specific parts per trillion detection limits, 1000+ ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M W600 Heated Total Hydrocarbon Analyzer is a very compact wall or panel mount heated FID analyzer to continuously measure the total concentration of hydrocarbons within a gaseous sample. This can be ambient air, exhaust gases from a combustion process e.g. stack emissions, from any type of an industrial vent, from an internal combustion engine, or from any other emission containing ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
The J.U.M Heated Total Hydrocarbon Analyzer Model 3-700 FID is designed to be installed directly upstream of a FTIR analyzer (e.g. Gasmet) to continuously measure the total concentration of hydrocarbons within a gaseous sample. All controls which allow to calibrate the FTIR or FID individually are built in. Sources can be ambient air, exhaust gases from a combustion process e.g. stack emissions, ...
-
PremiumManufactured by Lumex Instrumentsbased in CANADA
Sorbent trapsprovide total mercury measurement as well as speciated mercury measurement (oxidized and elemental mercury phases). The flue gas sample is collected using a heated sample probe and calibrated pumping system. Mercury is captured by adsorption in sorbent traps media. The material in these traps is later analyzed using Zeeman mercury analyzer RA-915M and PYRO-915+ attachment. Traps are ...
-
PremiumManufactured by WTW - a xylem brandbased in GERMANY
Chlorine 3017M - photometric analyzer with large measuring range and a high resolution for free and total chlorine with the DPD method according to the ISO and US ...
-
PremiumManufactured by Lumex Instrumentsbased in CANADA
The OLM30B is a dual train, fully functional sampling system, complete with Mass Flow Controllers, vacuum gauges, a WatLow controller with thermocouple input and probe power ...
-
PremiumManufactured by J.U.M. Engineering GmbHbased in GERMANY
Our transportable model 3-200 fully heated FID is successfully used throughout international markets for over 30 years. Also among other portable gas FIDs, the 3-200 It is the first ever built transportable fully heated FID using our proprietary back purge sample filter. It is widely distributed throughout the industry and the stack testing community and is much liked for its ruggedness, high ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you