Gas Calibration Applications available in Ukraine
-
Premium
Ambient air quality monitoring solutions for urban air quality monitoring
To measure air quality in the ambient air is a challenge. The monitoring site needs to be representative and not dependant on changes in local traffic. A large number of gaseous components need to be measured with high accuracy and high ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Premium gas generators and calibration solutions for inductively coupled plasma (ICP) sector
LNI Swissgas supplies gas generators for ICP ...
By LNI Swissgas based in Versoix, SWITZERLAND.
-
Premium
Premium gas generators and calibration solutions for sample evaporation sector
Check our LNI Swissgas range of gas generators for Sample Evaporation ...
By LNI Swissgas based in Versoix, SWITZERLAND.
-
Premium
Premium gas generators and calibration solutions for gas chromatography (GC) sector
LNI Swissgas provides a large range of innovative gas generators for Gas Chromatography ...
By LNI Swissgas based in Versoix, SWITZERLAND.
-
Premium
Continuous emissions monitoring solutions for mineral wool production
Process control and emissions monitoring in a mineral wool plant is a challenge due to the presence of phenol and formaldehyde. To use an extractive system in this environment will demand a lot of maintenance. The OPSIS DOAS system is different and provides plants with an accurate analyser that will operate with a minimum of maintenance. The OPSIS DOAS system is based on a non-contact method using an optical measurement path that can operate across the ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring solutions for chemical industry
Process control and emissions monitoring in a chemical plant is a challenge due to corrosive gases, high dust load, and high temperatures. To use an extractive system in this environment will demand a lot of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous Emissions Monitoring Calibration Systems (CEMCS)
The Environics Series Continuous Emissions Monitoring Calibration Systems (CEMCS) have been used in CEM vans and laboratories for over twenty years. They meet or exceed the performance requirements of the United States EPA 40 CFR Part 51 Method 205 Appendix M. Our systems are custom built, computerized, mass flow controller based gas calibration systems which allow you to dilute a single high concentration cylinder of span gas to low levels for the calibration of gas analyzers. ...
By Environics, Inc. based in Tolland, CONNECTICUT (USA).
-
Premium
Gas analyzers for odor: bad smell
The aim: analysis of H2S ppb and mercaptans with the TRSMEDOR because of the bad smell of ...
By Chromatotec Group based in Val de Virvée, FRANCE.
-
Premium
Continuous emissions monitoring solutions for fertilizer industry
Process control and emissions monitoring in a fertilizer plant is a challenge due to the high concentrations of HF. To use an extractive system in this environment will demand a lot of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Gas flow management solutions for food packaging (MAP) sector
Equilibrium Modified Atmosphere Packaging and Other Food Packaging Applications. More and more food packaging companies are utilizing Modified Atmosphere Packaging (MAP) or Equilibrium Modified Atmosphere Packaging (EMAP) to preserve the shelf life and/or appearance of their packed food. At Environics, we know it is essential that your MAP/EMAP gases be consistent and accurate in order to guarantee the desired quality in the end ...
By Environics, Inc. based in Tolland, CONNECTICUT (USA).
-
Premium
Refineries and hazardous areas gas analyzers for industrial air monitoring
Chromatotec can propose for hazardous areas (for instance refineries) specific boxes for our analysers : category 1 IIc T4 for ...
By Chromatotec Group based in Val de Virvée, FRANCE.
-
Premium
Continuous emissions monitoring for sulphuric acid production plants
The process control of a sulphuric acid plant needs good and reliable detection of gas phase sulphur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring for brick plants
Process control and emissions monitoring in a brick plant is a challenge due to the high concentrations of HF. The HF is generated in the process and gas phase HF can reach 50 mg/m3 or more. To use an extractive system in this environment will demand a lot of ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring solutions for steel plants
The nature of steel manufacturing processes places severe limitations on the monitoring methods that can be used. Aggressive environments combined with high levels of particulates and gases make the choice very ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Premium gas generators and calibration solutions for microwave plasma-atomic emission spectrometer (MP-AES) sector
LNI Swissgas provides a large range of innovative gas generators for Microwave Plasma-Atomic Emission Spectrometer (MP-AES) ...
By LNI Swissgas based in Versoix, SWITZERLAND.
-
Premium
Premium gas generators and calibration solutions for liquid chromatography (LC; LC-MS) sector
LNI Swissgas is a leading manufacturer of innovative gas generators designed to meet all gas requirements for LC/MS ...
By LNI Swissgas based in Versoix, SWITZERLAND.
-
Premium
Continuous emissions monitoring solutions for mining & smelting
OPSIS non-contact monitoring solutions, based on either DOAS or TDL techniques, are very well suited for applications in the mining and smelting Industries, as the flue gas conditions often involve high temperatures and high dust ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Premium gas generators and calibration solutions for liquid chromatography (LC; LC-MS) sector
LNI Swissgas is a leading manufacturer of innovative gas generators designed to meet all gas requirements for LC/MS ...
By LNI Swissgas based in Versoix, SWITZERLAND.
-
Premium
Continuous emissions monitoring solutions for sulfuric acid production plants
The process control of a sulfuric acid plant needs good and reliable detection of gas phase sulfur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Continuous emissions monitoring solutions for waste to energy plants
Process control and emission monitoring in a waste to energy plant is a challenge. A large number of gaseous components need to be measured with high accuracy. Almost 100% uptime is required and the monitoring system needs to be easy to maintain and fast to calibrate. The OPSIS system is tested and approved to have the best performance and longest calibration intervals, and provides the waste to energy plant with an accurate analyser that will operate with a minimum of ...
By OPSIS AB based in Furulund, SWEDEN.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you