portable gas calibrator technology Articles

  • How Often Should Gas Detectors be Calibrated and by Whom?

    Calibration frequency is one of the most commonly asked questions concerning the use of gas detection instruments. Common factors to consider when deciding how frequently to calibrate are: type of sensor, type of gas detector (fixed vs. portable), the required use and accuracy of the detector, manufacturer’s recommendations, how confident you are about the functioning of your instrument ...

  • Fixed Versus Portable Gas Detection – Which Is Better?

    Did you know that workers are needlessly injured every year as a result of leaking toxic or combustible substances? Such incidents are known to involve a wide range of hazardous gases (including ammonia, carbon monoxide, chlorine, hydrogen sulfide, hydrocarbon vapors and so on). The sad reality is that most of these accidents are avoidable if only the workplace is adequately monitored. This leads ...

  • Greenhouse gas emissions and reduction studies using a portable TDL gas monitor

    Boreal Laser's GasFinder is a portable open path gas monitor based on laser technology. GasFinder is uniquely suitable for studies of greenhouse gas emissions. It is specific to the gas of interest, provides one second response and has a broad dynamic range. GasFinder is permanently calibrated and is very small and light (less than 5kg). Alignment is easy and stable. No on-site electronic tuning ...


    By Boreal Laser Inc.

  • G100 portable CO2 incubator analyser for incubators gas readings

    The Geotech G100, which measures CO2 from 0-20%, is used to demonstrate accurate and repeatable CO2 readings of the atmosphere inside incubators. In just a few seconds an embryologist is able to take a reading from various incubators, all of which will have a different means of sampling the air inside an incubator, without fully opening the inner door and adversely affecting the environment. It ...

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • Evaluation of MCM hygrometer and validation system during - Case Study

    Evaluation of an MCM moisture analyser and validation system during start up of Platformer 4 at Shell Bukom, April 2005. Overview Platformer start up requires an accurate knowledge of moisture levels in order too prevent over cracking, help optimise yields and prevent early catalyst damage. The presence of chloride and other contaminants during start up often affect the water ...

  • White Paper & Video on FTIR multigas analysis

    Gasmet Technologies has published a free White Paper and a video on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR. Both the video and the White Paper can be found here at www.gasmet.com or by visiting the Quantitech stand 62/63 at AQE 2017. ...


    By Gasmet Technologies Oy

  • Analyzer underpins growth of container inspection company

    After a career as a customs officer in the Netherlands, Wim van Tienen was well aware of the toxic gas hazards presented by some freight containers, so in 2009 he started a company, Van Tienen Milieuadvies B.V., offering gas analysis and safety advice. The company grew quickly and now employs 23 staff. Wim attributes a large part of this success to the advanced FTIR gas detection and analysis ...


    By Gasmet Technologies Oy

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you