hazardous gas detection Equipment

136 Results found
Only show results in Virginia?
OK
  • Category: Monitoring & Testing ×

  • Subcategory: Gas Detection ×

  • Keyword: hazardous gas detection ×

ChemSight - Hazardous Gas Detection System

by Avir Sensors     based in Charlottesville, VIRGINIA (USA)

The ChemSight detector is an infrared (IR), line of sight, sensing system for point of entry, fixed security, fence line and perimeter protection that utilizes a simple, non-contact, spectral analysis of the atmosphere. The use of optical line-of-sight detection and avoidance of direct contact with chemicals provides the following advantages ...

ACME - Model CEW4 Series - Wireless Multiset Gas Detection and Control System

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The CEW4Quadset system monitors up to 4 remote sensors wirelessly over a 900MHz or 2.4GHz network. This results in substantial savings in labor and material costs during installation. While typically used for enclosed parking facilities where CO and NO2 (for Diesel fumes) are the gases detected, the CEW4 can monitor other toxic gases such as ...

ACME - Model CEW Series - Wireless MultiSet Gas Detection and Control System

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The CEW Series centralized detection and control system can monitor up to 32 remote detectors via a wireless RS-485 communication link at 900MHz or 2.4GHz, reducing installation costs. While typically used for enclosed vehicular facilities where CO and NO2 (for Diesel fumes) are the gases detected, the panel can also be configured to monitor CO2, ...

ACME - Model TW-ECH - Twinset Stand-Alone Dual Gas Monitor

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The TwinSet is a stand-alone dual-gas detection unit. In its standard configuration the TwinSet wil have (1) built-in CO sensor and (1) remote sensor that can be for any one of the three gases listed, namely, CO, NO2 or Combustible gas (CH4 C3H8). The TwinSet is a 'system-in-a-box' that provides dry contacts for the activation of fans, dampers and ...

ACME - Model ECH-ST Series - Gaspost Toxic Gas Sensor / Transmitter

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The Acme Gaspost toxic gas sensor/transmitter measures the concentration of the target gas in an enclosed area and produces a proportional analog output signal. The 4-20mA transmitter is designed for standard 2-wire loop-powered operation where the output is supplied via the same pair of wires as the power supply.

ACME - Model UN-ECH Series - Uniset Stand-Alone Gas Monitor

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

UNISET is a single-point stand-alone gas monitor for a number of toxic and flammable gases as well as oxygen deficiency. It utilizes state-of-the art sensor technology: electrochemical for toxic gases and oxygen; catalytic bead for combustibles. The UNISET has up to four SPDT relay outputs fully user-configurable to operate at different thresholds ...

ACME - Model WS Series - Wireless Sensors/Transmitters

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The ACME WS Series toxic or combustible gas sensor/transmitter measures the concentration of the target gas in an enclosed area and transmits this value to the control panel via a 900 MHz or 2.4 GHz wireless medium.The WS Sensor / Transmitter includes a high gain antenna concealed inside the enclosure as well as a built-in battery pack that can be ...

ACME - Model CEL(LS) Series - MultiSet Gas Detection and Control System

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The ACME CEL(LS) MultiSet series is a microprocessor-based multipoint multigas detection and control system that can be used with a wide variety of toxic, combustible, refrigerant & oxygen gas sensors. The sensors can be grouped in any combination. The wiring between the Control Panel and the remote sensor-transmitters is accomplished via ...

ACME - Model CEW(LS) Series - Wireless MultiSet Gas Detection and Control System

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

Scalable system using Wireless Sensor-Transmitters communicating with a central Control Panel as well as Remote Wireless Relay Modules to operate ventilation equipment & Remote Alarms. FCC/IC/ETSI/CE approved RF modules for up to 256 remote sensor-transmitters & up to 96 Remote Relay Modules.- Minimal installation cost - virtually no field ...

ACME - Model CEL Series - Multi-Gas Detection and Control System

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The CEL Series centralized detection and control system can monitor up to 32 remote detectors via a 4-wire RS-485 daisy-chain communication link, reducing installation costs. While typically used for enclosed vehicular facilities where CO and NO2 (for Diesel fumes) are the gases detected, the panel can also be configured to monitor CO2, Propane, ...

ACME - Model CEL4 Series - Multi-Gas Detection and Control System

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The ACME CEL4 Series is a microprocessor-based up to 4 channel multi-gas detection and control system that can be used with a wide variety of ACME toxic, combustible & oxygen gas sensors. The sensors can be grouped in any combination. The wiring between the Control Panel and the remote sensors is accomplished by a 4-wire ...

ACME - Model VOC-3 - Refrigerant Leak Detector

by Acme Engineering Prod. Ltd.     based in Montreal, QUEBEC (CANADA)

The VOC-3 detector is designed for enclosed spaces or mechanical rooms where refrigerant leaks from chillers could pose a danger to personnel. This detector can cover up to 10,000 sq. ft. of clear, open space. It is designed to operate two-speed fans using two dry contacts that close at the appropriate low and high concentration levels for the ...

Model GAS 404 - Channel Direct Gas Monitoring System

by Gas Alarm Systems Ltd     based in Knaresborough, UNITED KINGDOM

The GAS 404 has been designed with features that provide an effective response to the detection of gas hazards in a wide range of environments.

GDS Technologies - Model Gas Net - Addressable Controller System for Gas Detectors

by Ribble Enviro Ltd     based in Gisburn, UNITED KINGDOM

The Gas Net addressable controller system will monitor from 1 ~ 32 gas detectors on a common 4-core cable, the full range of gas detectors are available including infra red detectors, monitoring in any type of environment from commercial premises through to heavy industrial and hazardous area applications. Typical monitoring applications to date ...

Surveillance System Integration

by Det-Tronics - Detector Electronics Corporation     based in Bloomington, MINNESOTA (USA)

Detector Electronics is in business to keep our customers safe and satisfied. By adding surveillance and digital analysis opportunities to an already cutting edge, world class fire and gas system, we enable our customers to be just that – safe and satisfied.

EyeCGas - Infrared Gas Leak Detector

by Opgal Optronic Industries Ltd.     based in Karmiel, ISRAEL

Thermal Imagers are sensitive to the Infrared, which is a band in the electromagnetic spectrum. Gases have their own characteristic absorption lines in the IR spectrum; VOC's and others have these lines in the region of the MWIR. The use of a thermal imager as an infrared gas leak detector adjusted to the region of interest will allow the gases to ...

Fixed Gas Detection

by Concept Controls Inc     based in La Porte, TEXAS (USA)

For some operations, a fixed solution may be the best. Whether your worksite needs protection against a specific hazard or many different types of gases, you need a system that can handle all your needs. Easy installation, minimal maintenance, best protection available.

SensAlert ASI SIL-2 Certified Point Gas Detector - Model Third Party Certified SIL-2 - New Point Gas Monitor for Detection of Combustible and Toxic Gases in Critical Safety Applications

by Sensidyne     based in St. Petersburg, FLORIDA (USA)

SensAlert ASI - Advanced Safety Integrity – The best solution for gas detection in critical safety applications. SensAlert ASI provides enhanced protection and dependability for critical safety applications where personnel, processes, and facilities are at risk. The third-party certified SIL-2 SensAlert ASI offers dependability and versatility ...

Crowcon - Model F-Gas - Infrared Fixed-Point Detector

by Crowcon Detection Instruments Ltd - a Halma company     based in Milton Park, UNITED KINGDOM

A high quality infrared fixed-point detector that delivers dependable detection of freon gases. Available for detecting a range of different refrigerant gases and also sulphur hexafluoride (SF6), the Crowcon F-Gas Detector can be connected to any control system that accepts an analogue signal. Housed within an IP54 rugged enclosure, the F-Gas ...

Touchpoint - Model 4 - Controller

by Honeywell Analytics     based in Hegnau, SWITZERLAND

A controller providing protection from flammable, toxic and Oxygen gas hazards, with up to 4 points of detection. The Touchpoint 4 controller provides protection of personnel and plant from flammable, toxic and Oxygen gas hazards when used with up to four Sensepoint gas detectors. Self-contained, fully user configurable and wall mounted, a ...

Related Terms for hazardous gas detection

Need help finding the right suppliers?

Let the XPRTs do the work for you