Only show results available in Virginia? Ok

Gas Dilution Sampling Applications

  • Premium

    Aerosol and particle technology for pressure & temperature industries

    The reproducibility of the devices has been approved by worldwide use. In order to avoid the condensation or vaporization of the particles during the particle measurement, the isothermal and isobaric particle generation and measurement is necessary.

    By Palas GmbH based in Karlsruhe, GERMANY.

  • Premium

    High quality gas sensor solutions for mining

    Fast, accurate and reliable measurement of CH4. The extraction of coal releases methane gas, which can mix with the air in a mine to form a hazard due to its flammability. Ventilation with fresh air from the surface is used to dilute the methane and reduce the risk of explosion. Monitoring of the methane content of the stale air exiting the mine allows the amount of ventilation to be controlled. Although our sensors are not ATEX approved for use in potentially explosive atmospheres they are suitable for monitoring air containing methane concentrations below the lower explosive limit. Our OEM products can be built into equipment which is approved for use in the monitoring of mine exhaust gas and similar applications.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Premium

    Measurement solution for high NH3 monitoring from wastewater

    Protea was asked to supply a high level ammonia (NH3) measurement system for a waste water treatment plant. The reflux drums at the inlet to two ammonia stripping towers needed to be measured continuously. Protea designed a solution based around our Solus TDLAS analyser platform and a high level dilution system. The Solus analyser was configured for NH3 measurements in the range 0-500ppm. A dilution system incorporating special dilution probe and 19` control panel was installed before the analyser. This gave a dilution level of 600:1, enabling the NH3 analyser to measure in the range 0-30% Volume.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Continuous Emissions Monitoring Calibration Systems (CEMCS)

    The Environics Series Continuous Emissions Monitoring Calibration Systems (CEMCS) have been used in CEM vans and laboratories for over twenty years. They meet or exceed the performance requirements of the United States EPA 40 CFR Part 51 Method 205 Appendix M. Our systems are custom built, computerized, mass flow controller based gas calibration systems which allow you to dilute a single high concentration cylinder of span gas to low levels for the calibration of gas analyzers.

    By Environics, Inc. based in Tolland, CONNECTICUT (USA).

  • Premium

    Aerosol and particle technology for filter testing industry

    Nearly 100 test rigs for the quality assurance and the development of filters are being used worldwide with great success.

    By Palas GmbH based in Karlsruhe, GERMANY.

  • Premium


    Durable regenerative thermal oxidizer (RTO) technology is at the core of our systems. MEGTEC designs and engineers system solutions to meet your special requirements, ranging from energy-efficient treatment of dilute volatile organic compound (VOC) flows, such as tank ventilation, to demanding applications utilizing VOC energy for secondary heat recovery; for example, in the form of process streams. This can include pre- and tail gas treatment systems, and could handle hazardous components such as sulphurous or chlorinated hydrocarbons. For special requirements, we can offer FTO (flameless thermal oxidation) and we can design systems operating safely on oxygen contents below 5%.

    By Babcock & Wilcox MEGTEC based in De Pere, WISCONSIN (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you