Gas Sampling Equipment For Monitoring And Testing In Indiana
-
Manufactured by Proportion-Air, Inc.based in USA
The ISQB series control valve is an electronic pressure regulator designed to precisely and proportionally control the pressure of gases based on an electronic command signal. The ISQB is an FM Approved Intrinsically Safe Valve approved for hazardous loactions. ...
-
Manufactured by Sensit Technologiesbased in USA
Calibration kits are used to verify and set an instrument to a known sample of gas. Calibration is not just making sure the instrument reads zero at turn on. When calibrating, you are adjusting the sensor output to equal the display reading as well as verifying the performance of the product. This should be documented and performed per your company requirements or monthly. Quick check kits are ...
-
Manufactured by Norris Thermal Technologies/Beltomaticbased in USA
Standard Equipment (subject to change): Pre-wired electric panel with main disconnect (3-phase, high or low voltage, 50 or 60 cycle). All motors with thermo overload protection, TEFC. Hollow bore gear reducers. Thermometers. Tubular construction, carbon steel. High temperature limit safety switches. Adjustable pitch vane axial fan. Frequency drive on each conveyor drive. Course weave woven wire ...
-
Manufactured by Dekker Vacuum Technologies, Inc.based in USA
DuraVane lubricated rotary vane vacuum pumps are well-designed, reliable and economically ...
-
Manufactured by AFC International, Inc.based in USA
Draeger X-am 7000 combustible gas detector is an innovative solution for the simultaneous and continuous detection of up to five gases. A combination of more than 25 sensors allows flexible solutions to individual monitoring tasks. The Draeger X-am 7000 also has a photo-ionization detector (PID) that detects volatile organic compounds (VOC) for VOC monitoring and VOC gas detection. ...
-
Manufactured by Tuthill Corporation - Tuthill Vacuum & Blower Systemsbased in USA
Features: Recommended for applications where operating pressure is below 0.1 Torr (0.13 mbar). Achieve lowest possible pressures from mechanical pumps. Rugged and reliable. No metal-to-metal contact between pump piston & cylinder - clearances are filled with oil Unequaled durability, even in dirty applications. KC pumps are air-cooled. Adjustable gas ballast valves are standard for handling ...
-
Manufactured by Proportion-Air, Inc.based in USA
The ISF series control valve is an electronic pressure regulator designed to precisely and proportionally control the pressure of gases based on an electronic signal. The ISF is an FM approved and rated Nonincendive valve designed for hazardous ...
-
Manufactured by Tuthill Corporation - Tuthill Vacuum & Blower Systemsbased in USA
Recommended for applications where operating pressure is below 0.1 Torr (0.13 mbar). Achieve lowest possible pressures from mechanical pumps. Rugged and reliable. No metal-to-metal contact between pump piston & cylinder - clearances are filled with oil. Unequaled durability, even in dirty ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
This state-of-the-art instrument measures Carbon Dioxide (CO2) concentrations in the parts per million (ppm) range and is ideal for applications ranging from conference rooms to ...
-
Manufactured by AMETEK Process Instrumentsbased in USA
The 933 is a unique ultraviolet (UV) photometric analyzer system designed for the low-level measurement of hydrogen sulfide (H2S), carbonyl sulfide (COS), and methyl mercaptan (CH3SH) in natural gas applications. Capable of unattended operation for an extended time period, the 933 consists of a fully integrated analyzer and sample system. It provides a fast response time to increasing or ...
-
Manufactured by Maxtecbased in USA
The UltraMaxO2 analyzer was designed to quickly verify oxygen concentration at a glance, including the flow and outlet pressure of oxygen concentrators. Its advanced design provides high-level performance and reliability. The UltraMaxO2 oxygen analyzer includes the following beneficial ...
-
Manufactured by AMETEK Process Instrumentsbased in USA
The CMFA-P2000 (Combustion Mix Flue Gas Analyzer) is a portable combination premix and flue gas analyzer, specifically designed to meet the dual furnace combustion of glass container manufacturing plants. Two analyzers in one, the CMFA-P2000 is a portable solution designed to measure both excess oxygen and excess fuel in pre-combustion and flue gas applications and provide air/fuel ratio ...
-
Manufactured by Perma Pure LLC - a Halma Companybased in USA
Perma Pure MD-R-Series Membrane Air Dryers use exclusive Nafion selectively permeable membrane tubing to continuously dry gas streams removing only water vapor. These Air Dryers operate over a wide range of temperatures, pressures and flow rates, and dry to dew points as low as ...
-
Manufactured by AMETEK Process Instrumentsbased in USA
The 5812 moisture analyzer is designed specifically to meet the needs of the natural gas industry for reliable, low-maintenance, self-verifying moisture analysis, with a rapid response to moisture changes. A combination of quartz crystal sensing and asymmetrical sampling provides the rugged, reliable and continuous performance demanded by natural gas moisture analysis, and ensures a long sensor ...
-
Manufactured by AMETEK Process Instrumentsbased in USA
Using tunable diode laser absorption spectroscopy, the 5100P is a transportable, easy-to-use analyzer optimized to measure either water vapor (H2O) or carbon dioxide (CO2) in select gas streams. It offers the fast-response, high-accuracy benefits of TDLAS technology in a lightweight, durable and mobile platform that is certified for use in hazardous areas including Class I, Division 2, and both ...
-
Manufactured by Crowcon Detection Instruments Ltdbased in UNITED KINGDOM
Gas-Pro PID gives you full flexibility with a wide range of gas types to choose from. With an optional pump, the Gas-Pro PID is the perfect product addressing the requirements of a wide range of applications. Gas-Pro PID utilises the Photo Ionization Detection technology to allow you to detect hundreds of Volatile Organic Compounds (VOCs). If you are working in an environment that is high in ...
-
Manufactured by Perma Pure LLC - a Halma Companybased in USA
Perma Pure’s Marine-GASS Nafion tubing based Sample Conditioning Systems is the smart solution for Marine CEMS. Designed specifically to handle harsh shipboard applications, the system ensures long term reliability of SO2 measurements according to MEPC 184(59). Because the level of SO2 is so low coming out of the scrubber, a peltier based cooler is unable to condition the sample effectively ...
-
based in USA
The SmartCEMS® Probe is a component of a predictive emission monitoring system (PEMS) that provides for continuous stack gas sampling for pollutants and diluents under U.S. EPA 40 CFR Part 60 and/or U.S. EPA 40 CFR Part 75 regulations. The Probe will meet the requirements for sampling during model development and PEMS QA activity. The Probe is required to connect the sample line and the ...
-
based in USA
The SmartCEMS® Sample Interface Panel is a component of a predictive emission monitoring system (PEMS) that provides for continuous stack gas sampling for pollutants and diluents under U.S. EPA 40 CFR Part 60 and/or U.S. EPA 40 CFR Part 75 regulations. The Sample Interface Panel will meet the requirements for sampling during model development and PEMS QA activity. The Sample Interface Panel ...
-
Manufactured by AMETEK Process Instrumentsbased in USA
Establishing a new standard for clean gas moisture analyzers, the 2850 provides exceptional performance, with virtually no interferences, multi-gas compatibility, and on-board measurement verification. The 2850 uses the most accurate trace moisture measurement technology available to deliver an ultrafast response to both increasing and decreasing moisture ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you