Laboratory Filtration Applications available in Manitoba
-
Premium
Determination of acetic acid (acetate anions) in natural, drinking, and waste water
Introduction The method is used for the determination of acetic acid (as acetate ions) in the samples of natural water, drinking water, and waste water by capillary ...
By Lumex Instruments based in Mission, BRITISH COLUMBIA (CANADA).
-
Premium
Flame Photometer for Measurement of Calcium in Serum & Urine
This method reduces or removes potential interference from sodium, potassium and phosphates normally present in serum and urine by diluting the samples with a diluent containing ethylenediaminetetraacetic acid ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Na, K and Ca in Plant Extracts
The most important ions which naturally occur in plant tissues are sodium, potassium, calcium, magnesium, nitrate, sulphate and phosphate. A sample of 5 g of oven-dried plant material contains on average, 25 mg calcium, 9 mg magnesium, 80 mg potassium and 3 mg sodium. The recommended method for the measurement of calcium is to precipitate the calcium as an oxalate, the precipitate is then dissolved and measurement taken from the resulting solution. Sodium and potassium may be measured directly following an ashing ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Potassium Extraction from Soil
Principle: Potassium was extracted from a soil sample with acidified ammonium lactate to determine plant available potassium ionic concentration present in the ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Calcium and Potassium in Cereals
Commercial cereals vary considerably in composition, both in their formulation and the ingredients added to enrich these products. Sodium is the predominant cation in breakfast cereals, at levels reaching 8mg/g. Potassium and calcium also vary, particularly in wheat-based products and those enriched with milk products or calcium salts. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Sodium and Potassium in Cheese
Cheese was wet ashed with a combination of acid and a high temperature oven to form a dissolvable product ready for analysis via flame ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Lithium Sea Water
The effect of potential interference from other constituents of sea water was studied, including sodium, chloride and potassium. It was found that pre-concentration of the sea water was not necessary prior to analysis. A filtration of the sample was only necessary if sample contained suspended material. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Potassium and Sodium in Meat
Several different techniques can be used for sample digestion and extraction of sodium and/or potassium: oven ashing, perchloric acid ashing, extraction by boiling and acidification with HNO3 as well as extraction by homogenisation in 2% trichloroacetic acid (TCA). ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Sodium and Potassium in Dried Milk
Dried milk was dissolved into an aqueous solution for analysis via flame photometry. The test solutions and reference solutions are measured directly following dilution with deionised distilled ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Calcium in Unashed Plant Leaves
This procedure uses a TCA (trichloroacetic acid) extraction of the tissue to release all of the ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Calcium in Fresh Fruit
In most cases, it was found that flame photometry was well suited for the determination of sodium, potassium and calcium in fresh fruits, using the wet ashing technique as given below. There are significant differences in the composition between different varieties of the same fruit, although these differences are not usually considered to be nutritionally ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Sodium and Potassium in Silicate Rocks
This method for the measurement of sodium and potassium in silicate rocks uses a borate fusion ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Calcium in Biological Samples
A number of methods have been reported for the measurement of calcium in biological materials by flame photometry or titration. This method employs trichloroacetic acid (TCA) to precipitate the proteins and has been found to be adequate to extract all of the calcium from tissue samples. Sodium, potassium and phosphate caused no significant interference and calcium concentration in the range of 0 to 2 µg/ml is readily determined. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Keenan Filters Technology for Marine
Contaminated fuel is the most common cause of diesel engine shut-down! That’s why we have created the first and most complete compact diesel fuel filter and polishing management system. More than just a filter, the New Keenan Filter System gives you all the tools needed to keep your fuel system clean and solve any fuel related problems no matter your location. It even works as a backup fuel pump if ...
By KTI Systems Inc based in Southwick, MASSACHUSETTS (USA).
-
Laboratory filtration for the pharmaceutical industry
By Cytiva based in Marlborough, MASSACHUSETTS (USA).
-
Cleaners for Food and beverage industry
IPC offers a full line of precision cleaners that provide consistent results with every use and leave surfaces completely clean. An economical 1-2% concentration in water is effective in most cleaning applications. Typical uses include removing protein, starch, grease, fat, gum, oil and baked on soil from processing equipment, lines, and filter ...
By International Products Corporation based in Burlington, NEW JERSEY (USA).
-
Microbial testing for metalworking fluids industry
Microbial Contamination Results in Less than 5 minutes! Microbial growth in metalworking fluids presents a major problem. Storage tanks, recirculation lines, filters, and other equipment can become fouled through microbial proliferation and metabolic activity, which results in a myriad of problems. These problems include compromised product quality from microbially influenced corrosion (MIC), equipment and filter plugging, and health risks from bioaerosols. The best solution to these problems is early detection ...
By LuminUltra Technologies Ltd. based in Fredericton, NEW BRUNSWICK (CANADA).
-
Independent particle characterization services for environmental industries
Particle size, particle concentration and other physical characterization analyses are critical to many environmental applications. Regulatory agencies in the environmental sphere demand strict compliance to standards and discharge regulations. Physical testing of samples for parameters such as particle size and concentration can give insight to the process control engineer on how effective and compliant a discharge handling system is operating. Particulate loading from both air emissions and waste water discharge ...
By Particle Technology Labs based in Downers Grove, ILLINOIS (USA).
-
Analytical laboratory instruments and reagents for oil and distillates industry
The Photovolt Aquatest 2010 moisture analyzer provides rapid, accurate, and convenient low level moisture analysis ranging from low ppm to pure water with maximum isolation of solutions from atmospheric moisture. With a range of 1 ppm to 1,000,000, typical applications include low level moisture applications for liquids and dispersed solids, pharmaceutical samples, lubricating oils, chemicals and solvents, resins, lyophilized samples and plastics. The Department of Defense Naval Air Systems Command (NAVAIR) ...
By Photovolt Instruments Inc. based in St. Louis Park, MINNESOTA (USA).
-
Monitoring engineering systems for wastewater treatment industry
Sometimes an 'off the shelf' water quality monitoring product is just not available and it is necessary to engineer a complete bespoke monitoring solution. System integration demands a diverse range of abilities. PPM is experienced in designing the correct suite of instrumentation combining manufactured, distributed and factored ...
By Pollution & Process Monitoring Ltd based in Sevenoaks, UNITED KINGDOM.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you