Laboratory Gas Generators Applications

23 Results found
Only show results in Virginia?
OK
  • Category: Monitoring & Testing ×

  • Subcategory: Laboratory Gas Generators ×

Oxygen Generating Systems for Sewage Treatment

by Oxygen Generating Systems Intl. (OGSI)     based in North Tonawanda, NEW YORK (USA)

Using Oxygen to Solve Waste Water Problems Lack of oxygen can cause inadequate purification or even anaerobic decomposition, as well as offensive odors. Injecting oxygen into sludge beds &/or piping allows you to: * Reduce nitrogen levels * Meet peak O2 demands * Have a back up to your aeration system * Pre-purify waste water * Control odors * Deter corrosion damage * Meet increased requirements regarding waste water purification

Nitrogen generation for the Marine, Oil & Gas industry

by Oxymat A/S     based in Helsinge, DENMARK

Marine conditions pose a number of challenges and issues. Size, weight, rough sea conditions, corrosion, high temperatures, cargo needing protection, just to name a few.Oxymat’s Marine, Oil & Gas division produces nitrogen PSA generator systems to the marine industry with the necessary experience and know-how to address these issues. Compared to a traditional membrane based system, PSA systems significantly decrease redundancy and can cut energy consumption with up to 30%. In addition, a PSA system can produce 5% or lower oxygen levels.With the highest quality in components, PSA systems are extremely reliable with at least 48.000 running hours before CMS replacement is needed.

Oxygen Generating Systems for Waste Gas Treatment in the Semiconductor, PV and LED Industries

by Oxygen Generating Systems Intl. (OGSI)     based in North Tonawanda, NEW YORK (USA)

Waste gas treatment is an often overlooked but important function of Semiconductor, PV and LED fabrication. Several serious accidents have taken place in factories where no abatement was installed. Even today waste treatment is often seen as a cost rather than a safety issue. There are three main reasons why waste gas treatment is installed in factories: health and safety, environmental factors, and quality control.

Measurement solution for AD-211 VOC speciation in natural gas, syngas & gasification

by Protea Limited     based in Middlewich, UNITED KINGDOM

Composition of Natural Gas, Syngas via VOC Speciation

The composition of fuel gas is important in order to determine calorific value and also to detect any unwanted contaminants in the gas. Online analysis is important in order to give real-time and direct action on issues.

Measurement solution for accurate continuous formaldehyde measurement formaldehyde in emissions and ambient air applications

by Protea Limited     based in Middlewich, UNITED KINGDOM

Formaldehyde (HCHO) is the simplest aldehyde species and is present, or generated by, many sources (both natural and industrial). It is classed as a substance that is toxic and harmful to human health.

Environmental data managament & compliance reporting for the manufacturing industry

by enVirSys LLC.     based in Littleton, COLORADO (USA)

Environmental data allows organizations to manage and monitor their compliance with greenhouse gas regulations, the Clean Air Act, the Clean Water Act, the Resource Conservation and Recovery Act, and many others. Additionally, many companies must generate and report environmental data to uphold permits which allow them to conduct their business.

Oxygen generation for ozone industry

by Oxymat A/S     based in Helsinge, DENMARK

Ozone is a highly effective method for bacteriological treatment and useful in a variety of everyday situations from removing odor to ensuring clean, high quality drinking water from the tap. But O3 is more than just effective. It is also environmentally safe, which makes it highly suitable for treating water in enormous quantities; both drinking water and industrial waste water, i.e. in industrial slaughterhouses.

Energy from biogas and natural gas for agriculture

by Dreyer & Bosse Kraftwerke GmbH     based in Gorleben, GERMANY

You are a farmer and would like to make money from generating electricity and heat? Then you have come to the right place. Within just a few years Dreyer & Bosse Kraftwerke GmbH have advanced to become one of the leading manufacturers of combined heat and power stations on biogas basis - we have available a complete product portfolio for energy applications of biogases or biomethane.

Agitation and mixing solutions for chemical

by National Oilwell Varco     based in Dayton, OHIO (USA)

Applications within the Chemical Processing Industry (CPI) are extensive.  Thousands of products are produced, synthesized, reacted, and treated to help produce a variety of products.

Laboratory Solutions for the energy industry

by Accelerated Technology Laboratories, Inc.     based in West End, NORTH CAROLINA (USA)

Been exploring for a LIMS solution that can better manage data, samples, testing, reporting and real-time monitoring? Put ATL on your crew. Our LIMS for the energy sector gives labs a truly user-friendly, reliable and scalable data-management and reporting solution - exactly what your company needs to power up to new levels of profitability.

Air pollution control for the natural gas processing industry

by Anguil Environmental Systems, Inc.     based in Milwaukee, WISCONSIN (USA)

The natural gas industry has seen a significant increase in activity with the discovery of new shales located throughout the world. The development of advance drilling technologies allow for extraction of gases deeper in the earth, revolutionizing the industry while creating a new demand for air and water pollution control technologies.

Industrial Solution for metallurgical, mining & chemical

by Macrotek Inc.     based in Markham, ONTARIO (CANADA)

Hydrometallurgical extraction of metals such as Nickel and Cobalt generate emissions of lethal gases such as Hydrogen Sulphide or Hydrogen Chloride. Macrotek has designed and supplied many systems to capture and treat these gases. In most cases the by-product is returned back to the process for reuse. Pyrometallurgical extraction of metals from sulphur containing ores generate large amounts of SO2 and particulate emissions. Macrotek has designed integrated systems to capture particulate and neutralizes SO2.

Filtration systems & solutions for nuclear industry

by Porvair Filtration Group     based in Fareham, UNITED KINGDOM

Within the nuclear industry there are ongoing operational challenges and potential hazards associated with environmental emissions and the protection of the workforce, such as high temperatures, high radioactivity, high solids loads and chemically aggressive environments. Therefore the industry demands exceptional levels of technical expertise and quality, in conjunction with specific skills to solve many of its most intractable problems.

Oxygen Generating Systems for Emergency Response

by Oxygen Generating Systems Intl. (OGSI)     based in North Tonawanda, NEW YORK (USA)

With Oxygen Generating Systems Intl. (OGSI)’s oxygen generating systems, care providers are assured that in the event of a disaster their oxygen supply chain will not be in jeopardy. By filling cylinders at your site, the uncertainty and logistics of delivered oxygen supplies are eliminated. OGSI has products to assist you in times of: Natural Disaster / Accidental Emergencies Terrorism / Epidemic Outbreak / Chemical / Biological Disaster

Computerized instrumentation for the medical gas flow and scientific research

by Environics, Inc.     based in Tolland, CONNECTICUT (USA)

Environics gas mixing, blending and dilution systems provide for precise mixing of gases for a wide variety of clinical applications. Our systems can produce gas concentrations from percent to ppb levels for single or multi-point calibration. The high accuracy of our mixers make them the units of choice for a wide variety of laboratory and research applications. For example, Environics Biological Atmosphere Incubation Mixers provide stable and accurate gas mixes for any laboratory or clinical need. You can generate the specific reduced oxygen environments needed for anerobes as well as the enriched oxygen environments needed in a variety of cellular, viral and high density culture applications. Systems can also be used to create a specific and stable gaseous environment in a clean room. In all cases, the Environics Atmosphere Mixers allow you to use less expensive single-gas cylinders or bulk tanks in place of a high number of expensive blended cylinders.

Evaporators technology for oil & gas industry

by EVALED - Veolia Water Technologies     based in Zoppola (PN), ITALY

The oil & gas industry faces water and wastewater treatment specific challenges. EVALED evaporators represent an effective solution for both downstream (onshore and offshore) and upstream plants, allowing ZLD (Zero Liquid Discharge).

Ozone/UV systems for Industrial, municipal, and residential wastewater treatment

by Lifetech     based in Brno, CZECH REPUBLIC

In 2004-2005 LIFETECH`s laboratory worked out an advanced oxidation process (AOP) for removal of dioxins and furans (PCDD/F), chlorophenols and other contaminants from the BCD process wastewater. Consequently, our technology was installed and from April 2006 successfully used in the `Spolana-Dioxins` Project at SPOLANA a.s. in Neratovice, Czech Republic, as a part of Special Wastewater Treatment Plant. Our supply consisted of an ozone generator with the output of 5 kg O3/h at 10% w/w ozone concentration, two reaction tanks with mixing systems, a vent ozone destructor, and a control system. The world largest project for removal of PCDD/F was managed by BCD CZ a.s., a subsidiary of Thermal and Chemical Soil Remediation Ltd.

Ambient Monitor Gas Calibration with Ozone Generators

by Environics, Inc.     based in Tolland, CONNECTICUT (USA)

Environics® Ambient Monitor Calibrator with Ozone Generators facilitate dynamic calibration of ambient air analyzers. These instruments automatically perform zero, precision, span and multi-point calibrations using NO, NO2, SO2, CO, O3, hydrocarbons and other gases of interest. All ozone generators are factory calibrated using a NIST traceable ozone standard. The Series 6100, Series 6103 and Series 9100 all meet or exceed U.S. Environmental Protection Agency requirements.

Need help finding the right suppliers?

Let the XPRTs do the work for you