Only show results in Virginia? Ok

Oxygen Analyzers Applications

  • Premium

    Gas monitoring instruments and systems for nitric acid process

    Modern production method of nitric acid production may lead to generation of several different gaseous emission components, such as nitrogen oxides (NOx), ammonia NH3 and nitrous oxide N2O. Nitrogen monoxide is an intermediate gaseous product in manufacturing of nitric acid HNO3. NO is formed in a catalytic reaction between ammonia and molecular oxygen O2. But undesirable side reactions may result in formation of nitrogen dioxide NO2 and nitrous oxide N2O. The NO and NO2 emissions can be reduced by use of...

    By Gasmet Technologies Oy based in Helsinki, FINLAND.

  • Premium

    Gas monitoring and dust monitoring for the iron / steel industry

    • Blast furnace offgas, combustion control, CO, CO2, O2
    • Converter (Basic oxygen furnace BOF)
      • CO gas recovery
      • O2 measurement for explosion prevention
    • Electric arc furnace offgas, combustion control, CO, O2, H2O
    • Reheating furnaces, O2
    • Coking plant
      • CO analysis in oven offgas
      • O2 analysis for explosion prevention in raw coke gas or after tar precipitator
      • NH3 measurement after scrubber
      • H2S...

    By NEO Monitors AS based in Skedsmokorset, NORWAY.

  • Premium

    Continuous emissions monitoring for chemical industry

    Process control and emissions monitoring in a chemical plant is a challenge due to corrosive gases, high dust load, and high temperatures. To use an extractive system in this environment will demand a lot of maintenance.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Continuous emissions monitoring for steel plant

    The nature of steel manufacturing processes places severe limitations on the monitoring methods that can be used. Aggressive environments combined with high levels of particulates and gases make the choice very limited.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    Continuous emissions monitoring for sulphuric acid production plants

    The process control of a sulphuric acid plant needs good and reliable detection of gas phase sulphur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every day.

    By Opsis AB based in Furulund, SWEDEN.

  • Permeability Testing of Medical and Pharmaceutical Packaging Industry

    The measurement of oxygen and water vapor permeation is often critical in medical and pharmaceutical applications; to prevent contamination, to extend the shelf life and potency of drugs and to ensure powders do not clog. Systech`s permeation analyzers and corresponding software conform to 21CFR Part 11.

    By Systech Instruments Ltd based in Thame, UNITED KINGDOM.

  • Medical Gas Analysis for Process Industry

    USP37 Medical Gas requires a specific, selective and positive identification test using a paramagnetic signal. Regular analysis of medical gas is required to ensure that the oxygen concentration is NLT 99.0% volume. Following the appropriate United States Pharmacopeia standards, in this case specifically USP37, requires an analyzer which uses a paramagnetic based technology.  The Systech Illinois Paramagnetic Oxgyen Analyzer PM700 is perfectly suited for this medical gas analysis application.

    By Systech Instruments Ltd based in Thame, UNITED KINGDOM.

  • Oxygen Permeation Analyzers & Water Vapor Permeation Analyzers for Packaging Industry

    Systech Illinois` comprehensive permeation range includes the recently acquired Lyssy and PermMate product lines which offer precision oxygen and water vapor analysis of packaging film barriers.

    By Systech Instruments Ltd based in Thame, UNITED KINGDOM.

  • Gas detection solutions for the commercial diving industry

    We are proud to be the world leader in gas analysis provision to the amazing world of commercial diving. We created our first commercial diving monitor in the early 1980s, the Analox 100. We started to work with customers including Divex (now known as JFD), Advanced Marine and Amron... and the rest is history. Our life-supporting oxygen, carbon dioxide, carbon monoxide and hydrocarbon analysers can be found on almost every diving system in the world. Our vast range of products includes the SDA range which...

    By Analox Sensor Technology based in Stokesley, UNITED KINGDOM.

  • Measurement solution for measuring total VOC via FTIR

    Current Total VOC Measurements

    The most common, and current standard, method for measuring Total Volatile Organic Compounds (VOC) is the use of a Flamed Ionisation Detector (FID). This gives a representative value of the total carbon content of a gas stream, as the FID cannot tell which specific organic compounds are present.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Water quality monitoring systems for feedwater, storm & condensate industry

    The most important parameters in Water/Steam Cycles such as Cation conductivity, dissolved oxygen and pH are available as pre-assembled and factory tested units. Dedicated analyzers for sodium, silica, phosphate and hydrazine are also factory tested and calibrated for immediate operation.

    By SWAN Analytische Instrumente AG based in Hinwil, SWITZERLAND.

  • Controlled Atmosphere Glove Boxes and Nitrogen Dry Boxes for Process Industry

    Glove boxes are designed for handling both hazardous substances and atmosphere sensitive materials. For controlled atmospheres, nitrogen dry boxes provide an isolated work environment for processing samples or handling air-sensitive materials while maintaining an anaerobic or other gas specific environment within the glove box. For work with hazardous materials, glove boxes provide a leak-tight environment protecting the user from exposure to potentially dangerous materials. Glove box applications include;...

    By Systech Instruments Ltd based in Thame, UNITED KINGDOM.

  • Cement & Lime Industry Emissions Analysis & Monitoring

    A key issue in the measurement of the products of combustion in Cement and Lime industries is the high levels of particulates. The Procal 2000 in situ analyser`s heated probe option is especially suited to this industry as it efficiently deals with variations in process temperature, keeping the probe above the sample dew point and safe from corrosive condensate.

    By Procal - Parker Hannifin Corp based in Peterborough, UNITED KINGDOM.

  • Chemical Oxygen Demand (COD) Analyzer for Craft Brewers

    MANTECH’s innovative PeCOD Analyzer is helping Ontario’s craft brewers manage their wastewater more effectively. PeCOD is an integral part of the Brü Clean System, a specialized wastewater treatment process developed by Econse Water Purification Systems for the craft brewing industry. Together they helped reduce the amount of wastewater for treatment by 75 per cent. “We can accomplish in a few minutes what other companies take weeks or months to do and this lets us move straight to...

    By MANTECH Inc. based in Guelph, ONTARIO (CANADA).

  • Gas detection solutions for the laboratories industry

    Fixed & Portable Gas Detectors for Laboratories: A wide variety of gases are used in labs such as carbon dioxide, argon, helium, nitrogen and oxygen. These gases pose a serious risk should they leak, this risk can occur from fixed piped gas systems or individual cylinders of gases. Analox offer a range of fixed & portable gas detectors suitable for various laboratory processes which use gas and are ideal for detecting gas leaks. From portable oxygen monitors, such as our Aspida, to fixed monitors such...

    By Analox Sensor Technology based in Stokesley, UNITED KINGDOM.

  • Fermentation Off-Gas Analysis

    In pilot plant and production scale fermentors, information relating to yield of product is of high importance. Hiden's gas analysers are configured with a multiport Off-Gas analysis manifold enabling simultaneous sampling from multiple fermentors. Data is used for the calculation of the respiratory quotient, carbon production rate and oxygen uptake rate. The Off-Gas measurement provides the respiratory quotient in a time and space averaged form and with good response time. By comparison data from multiple...

    By Hiden Analytical Ltd. based in Warrington, UNITED KINGDOM.

  • Fermentation Off-Gas Analysis

    In pilot plant and production scale fermentors, information relating to yield of product is of high importance. Hiden's gas analysers are configured with a multiport Off-Gas analysis manifold enabling simultaneous sampling from multiple fermentors. Data is used for the calculation of the respiratory quotient, carbon production rate and oxygen uptake rate. The Off-Gas measurement provides the respiratory quotient in a time and space averaged form and with good response time. By comparison data from multiple...

    By Hiden Analytical Ltd. based in Warrington, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you