sample particulate Downloads
-
Premium
PM162M Automatic, Low Volume, Particulate Sampler - Datasheet
PM162M is a sequential automatic sampling device for particulate matter in the ambient air. The particles are sampled at constant flow rate (1 m3/h or 2.3 m3/h) and collected on filters for gravimetric weighing and possible physicochemical laboratory ...
By ENVEA
-
Premium
Apex - Model SB-47 - Heated Filter Oven - Brochure
The Apex Instruments SB-47 is a heated filter oven that uses a 47 mm glass fiber filter and is specifically designed for isokinetic sampling of low particulate matter (PM) concentrations from stationary sources, such as gas turbines. Particulate is withdrawn isokinetically from the source and collected on the 47 mm glass fiber filter maintained at a temperature of 120 ±14°C (248 ...
-
Premium
Size-Selective Inlets for Use With the Ultrasonic Personal Air Sampler - Brochure
Four interchangeable size-selective particulate matter sampling inlets are available for the Ultrasonic Personal Air Sampler (UPAS): PM2.5 @ 1 L min-1 , PM2.5 @ 2 L min-1 , respirable @ 2 L min-1 , and PM10/ Thoracic @ 2 L min-1 . All inlets are compatible with both the UPAS v2 and UPAS ...
-
Premium
Isokinetic 2013 Catalog 1-1-13 NP
and Temperature. Obtaining a representative sample of particulate matter from a gas stream requires a more ...
-
Thermo Scientific ChemComb - Model 3500 - Speciation Collection Cartridge - Datasheet
The Thermo Scientific ChemComb 3500 Speciation Sampling Cartridge provides a flexible means of sampling particulate matter (PM) and gases from ambient air for analysis in a ...
-
SKC QuickTake - Model 30 - Air Sampling Pump - Datasheet
The QuickTake 30 air sampling pump offers constant flows from 10 to 30 L/min and run times up to 14 hours for sampling particulates. The pump is ideal for use with impactors, microvacuum cassettes, and spore traps. The QuickTake 30 air sampling pump is not UL Listed for intrinsic ...
By SKC
-
Premium
HI-Q - CF-900 Series - Portable Air Sampler - Manual
The CF-900 series high volume air sampling pumps are designed for the sampling air bourne particulate and radioiodine in the environment. The CF-901, comes standard with a 1½” female straight pipe threaded intake which accepts all HI-Q CF-Series holders (excluding 8 x 10). The models CF-902 and CF-903 have a 4" threaded ring installed on the air intake to allow for 4” diameter ...
-
Dust Measuring Methods - Application Note
An air sample enters the system, it travels through the impactor, which captures and removes larger particulates away from the sample. Smaller particulates become electrically charged and deposited on the piezo-crystal. The total mass of the deposited particulates affects the piezo-crystal’s frequency. Since the change in frequency is proportional to the mass of the particulates, the actual ...
-
Premium
SK-3D52 3D Flow Measurement System Manual
Stationary Sources’’ to help ensure appropriate sampling rates throughout a particulate sampling run. ...
-
Premium
PMS - Model APSS-2000 - Liquid Particle Counter for USP 788 - Specification Sheet
The APSS-2000 syringe sampling system sizes and counts suspended particulate matter in a wide range of liquids and meets or exceeds all current USP, EP, and JP requirements. Recipe functions allow the APSS-2000 to adapt to future regulatory changes. The APSS-2000 system consists of an SLS-2000 syringe sampler, a LiQuilaz® II E Series light obscuration spectrometer, and SamplerSight-Pharma ...
-
Premium
Dustroid Brochure
Dustroid is an Online Particulate Monitoring system to measure the concentration of dust particles in the ambient air. It is capable of monitoring various particulate size ranging from 1 micron to 100 microns such as Ultrafine Suspended Particulate Matter (UFPM), Suspended Particulate Matter (SPM), Respiratory Suspended Particulate Matter (RSPM) and Total Suspended Particulates (TSP). It works on ...
-
CPS, Cold Sample Probe Brochure
The CP5 is the revision of the classic not-heated sampling probe for the isokinetic sampling of particulate matter in stack emission ...
-
Model WTS-LV - Large Volume Pump Brochure
The Large Volume Water Transfer System (WTS-LV) is a large volume single-event sampler that collects suspended and dissolved particulate samples in situ into a 142mm membrane filter. The WTS-LV allows for a choice of pump size and filter porosity for a range of specimen collection. The Large Volume Water Transfer System (WTS-LV) is a large volume single-event sampler that collects suspended and ...
-
Dado - Model CP5 - Not-Heated Isokinetic Sampling Probe Brochure
The CP5 is the revision of the classic not-heated sampling probe for the isokinetic sampling of particulate matter in stack emission ...
By Dado Lab SRL
-
Shrouded Probes Brochure
The Shrouded Sampling Probe for extracting particulate matter from stacks and ducts, has several advantages over non-shrouded probes. These include lower internal wall losses, better off-angle performance, lower sensitivity to flow stream turbulence, and the ability to operate in either a fixed flow or variable flow rate ...
-
Acoem MegaVol - Model 3000 - Dust Sampler - Brochure
The MegaVol 3000 particulate sampler performs remote unattended sampling of particulates and is ideal for heavy metal and radiation exposure monitoring. The MegaVol is capable of a very high flow rate (120-150m3/hr) the increased flow rate allows representative particulate samples to be collected in shorter time periods (more samples collected per week) or to collect a larger quantity in the same ...
-
Kanomax Cegrit - Model MK-2 - Automatic Isokinetic Particulate Flyash Sampler - Manual
The original CEGRIT, Automatic Isokinetic Particulate. Sampler, was developed by the South Eastern Division of. the C.E.G.B (Central Electric Generating Board) in March. 1959 to extract fly-ash and dut particles from boiler gas. mixtures. Sensing Precision Limited exclusively continues. to manufacture this unique system. More than 50 years. later and the ‘CEGRIT Mk II’ is still one of ...
-
AirChek - Model XR5000 - Air Sampling Pumps Brochure
Discover the perfect combination of features and power in this compact, lightweight pump that gets the job done. The AirChek® XR5000 personal air sampling pump with Li-Ion battery provides powerful flows for particulate sampling, low flows for gas and vapor sampling, and the long run-times for low-concentration sampling. The AirChek XR5000 air sampling pump is UL Listed for intrinsic safety. ...
-
JCT - Model JF-1 - Sample Gas Particulate Filter - Brochure
Applications: For extractive gas analysis. For emission and process monitoring. For removal of dust and contamination from sample gas. For protection of the analysers. For integration in gas analysis ...
-
ASI - Model DP-049 Series - In-Situ Dilution Probe Brochure
The ASI Model DP-049 Series In-Situ Dilution Probe is designed to function as a sample conditioning and transport system, the Dilution Probe performs four critical functions to prepare the sample from the stack (duct or process) so that it can be measured accurately and precisely by the analyzer (typically an "ambient level" analyzer). The system uses an air driven aspirator which extracts a ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you