Only show results in Texas? Ok

Pollution Monitoring Applications

  • Premium

    Parallel evaporation in environmental consultancy

    For a fast and effcient sample concentration in order to monitor de pollution of the environment

    By BÜCHI Labortechnik AG based in Postfach, SWITZERLAND.

  • Premium

    Hand-Held & process control water testing instrument for Circuit board cleanliness testing industry

    Contamination of circuit boards can bring about severe degradation of insulation resistance and dielectric strength. Cleanliness of completed circuit boards is, therefore, of vital interest. For those companies who have established circuit board cleaning procedures, the MIL Spec P-28809 has been used as a guideline for control. Now a simple `on line` test for the relative measurement of ionic contamination has been developed. This fast and economical method for testing circuit board cleanliness uses a Myron L...

    By Myron L Company based in Carlsbad, CALIFORNIA (USA).

  • Premium

    Chromatography laboratory instrumentation for food & beverage industry

    Effective measures against food fraud, efficient and healthy food processing and the development of functional food and neutraceuticals are just few of many challenges in modern Food and Beverage production and analysis. BUCHI offers classical reference methods and near infrared spectroscopy for food analysis, but also visualization of production processes using spray drying and encapsulation.

    By BÜCHI Labortechnik AG based in Postfach, SWITZERLAND.

  • Premium

    Metallurgical industry online monitoring solutions

    Poorly controlled the concentration of gases such as CO, CO2, CH4 in the metallurgical industry cause poisoning, explosions and other accidents, and pose a serious threat to the safety in production. So it is essential to check the content of these gases for energy conservation, increase productivity, reduce energy consumption and protect the safety of life and product. The company`s gas analysis technology can accurately and reliably measure various industrial gas content, to provide a complete.

    By Hangzhou Zetian Technology Co., Ltd. based in Hangzhou, CHINA.

  • Premium

    Premium gas generators and calibration solutions for air pollution monitoring sector

    The measurement of pollutants such as O3, NO, NO2, CO, SO2 and HC to ppb’s and ppm’s require very sensitive analysers. Over the time or according regulations and devices requirements, calibration operations are required for each measured compound. As low concentration gas standards are expensive, may be unstable or not storable, like for ozone, on-site reference gas generation with Sonimix calibrators reduce costs, logistics troubles and keep analysers performances at their higher level.

    By LNI Swissgas based in Versoix, SWITZERLAND.

  • Premium

    Low level measurement of aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring.

    The Series 8900 BTEX Analyzer with a high-sensitivity PID provides direct low level measurement of Benzene, Toluene, Ethylbenzene, and Xylene`s in ambient air. This instrument is utilized in ambient air networks around metropolitan areas and fence-line monitoring at industrial sites.

    By AMETEK MOCON - Baseline based in Lyons, COLORADO (USA).

  • Premium

    Measuring aromatic hydrocarbons (BTEX) for pollution control and environmental monitoring

    The Series 8900 BTEX Analyzer provides direct measurement of Benzene, Toluene, Ethylbenzene, and Xylenes in ambient air. This instrument is utilized in ambient air networks around metropolitan areas and fence-line monitoring at industrial sites. The Series 8900 BTEX Analyzer employs a photoionization detector (PID) as the sensing element. This detector is specific to volatile organic compounds. The Benzene, Toluene, Ethylbenzene, and Xylene`s in the gas sample are physically separated using proprietary GC columns.

    By AMETEK MOCON - Baseline based in Lyons, COLORADO (USA).

  • Premium

    Gas monitoring instruments and systems for stack testing according to EPA test method 320

    The United States Environmental Protection Agency (EPA) has two stack testing methods for FTIR gas analyzers. Method 320 is an FTIR method for measuring wide range of organic and inorganic pollutants. Method 321 is a specific version for measuring hydrogen chloride HCl at cement kilns producing Portland cement. These methods define a quality assurance and control processes for verifying the accuracy of the results. The requirements for analytical equipment and software are defined on 40 CFR Part 60 Appendix B...

    By Gasmet Technologies Oy based in Vantaa, FINLAND.

  • Premium

    Tunnel solutions for the extractive areas

    In some countries they do not allow tunnel atmosphere monitors to be mounted on the tunnel wall; also, where there is a single bore it is very difficult to gain access for maintenance purposes. The TunnelTech 400 series are extractive gaseous pollutant and visibility monitors and extract a gas and dust sample from the tunnel bore and carry to a remote analyser. This allows maintenance to take place without affecting tunnel traffic flow.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Determination of TOC in stack

    PROBLEM: The industrial chimney's emissions of Volatile Organic Compounds (VOCs) are becoming issues of global importance and to have an accurate knowledge about how to test VOC turns into a strategic issue. VOC emissions are quantified and monitored according to standard EN 12619, using FID analyser which uses hydrogen and other reference gases in pressurized cylinder. Operators must then approach the sampling point, often placed several meters from the ground, climbing chimneys of industrial settlements with...

    By Pollution S.r.l. based in Budrio (Bologna), ITALY.

  • Premium

    Industrial monitoring solutions for the flow monitoring areas

    Many large combustion plants are now required to monitor mass emissions of major pollutants and to do so requires an accurate measurement of stack gas velocity. The VCEM 5100 is certified to EN 15267 part 3 QAL 1 for all industrial processes including waste incineration. It has several key advantages, firstly the sensors optics are not in contact with the hot and dusty environment, the VCEM 5100 can monitor gases at temperatures exceeding 10000C and the analyser requires minimal maintenance. The VCEM 5100 can be...

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Surface water and water conservancy monitoring solution

    Surface water and water conservancy monitoring is an important foundation work for reasonable utilization and protection of the nation water and soil resources, is a foundation of science management and protection of water ecology, water resources, water safety. The purpose of water quality monitoring is timely, accurate and comprehensive reflection of water environment quality present situation and developing trend, providing scientific basis for water environment monitoring, management, planning, pollution...

    By Hangzhou Zetian Technology Co., Ltd. based in Hangzhou, CHINA.

  • Premium

    Industrial manufacturing solutions for the metal plating line sector

    The metal plating line is the part of the metal finishing process where metal is applied to a substrate. Metal plating involves many complex processes related to reducing contamination of the process bath; ensuring regular monitoring of bath chemistry; wetting agents; anodes; purified water; ventilation and exhaust systems; acid solution regeneration; and spent acid bath reuse.

    By CECO Environmental based in Dallas, TEXAS (USA).

  • Premium

    Tunnel solutions for the gaseous pollutants

    The TunnelTech 200 series are primarily gas monitors with optional Visibility capability. Most use Infra-red absorption technology to monitor gaseous pollutants and those with a visibility channel use optical attenuation for that application. All TunnelTech 200 analysers except the TunnelTech 205 use the same rugged corrosion resistant enclosures and have an optional Data Display unit. As there is only one moving part so reliability levels are very high and maintenance levels very low.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Air pollution, emission and process monitoring systems for natural gas

    Natural gas often contains mercury at concentrations that vary from below 1 to above 10000 µg/m³. Mercury is both toxic and potentially damaging: it can corrode or embrittle common gas plant components. Gas processors require safe, reliable and effective mercury removal process solutions in order to achieve requisite sales gas quality specifications and protect cryogenic equipment. Our monitoring solutions are used to detect and precisely measure mercury levels in natural gas at various locations...

    By ENVEA based in Poissy, FRANCE.

  • Premium

    Air pollution, emission and process monitoring systems for leakage detection

    Your facilities and equipment can cause fugitive emissions, leading to environmental pollution and financial losses for your business. We offer a wide range of gas and particulate analyzers to monitor 24h/day your facility and accurately identify sources of leaks. Odors can thus be immediately linked to your operations, identify system leaks, and act quickly to reduce them for the comfort and the health of all, employees and residents. This proactive approach provides tangible elements in reducing complaints...

    By ENVEA based in Poissy, FRANCE.

  • Premium

    Air pollution, emission and process monitoring systems for odor detection

    Our range of gas monitors and Cairsens micro-sensors are able to measure 24h/day and accurately identify odors in applications such as WWTP, recycling, pulp and paper manufacturing, sewerage treatment facilities, refineries, sargassum algae decomposition, etc. Odors can thus be immediately linked to your operations, identify system leaks, and act quickly to reduce them for the comfort and the health of all, employees and residents. This proactive approach provides tangible elements in reducing complaints bringing...

    By ENVEA based in Poissy, FRANCE.

  • Premium

    Air Quality Monitoring Stations

    Opsis provides complete AQM stations, used for street-level, urban trend and background applications. The monitoring systems have been approved by the German TÜV and the U.S. EPA among others.

    By Opsis AB based in Furulund, SWEDEN.

  • Premium

    NO2 analyzer - For Medical Application

    The new and unique AS32M NO2 analyzer using CAPS (Cavity Attenuated Phase Shift) technology is an ideal solution for medical device applications such as INO (Inhaled Nitric Oxide). Originally designed for NO2 monitoring in roadside pollution surveillance and air quality applications, the AS32M is suitable for numerous other NO2 monitoring applications. For more information on how this unique analyzer, contact Environnement S.A.

    By ENVEA based in Poissy, FRANCE.

  • Premium

    Sludge Flow Measurement in Recirculation Line solutions for Wastewater Treatment Plant - Sludge Treatment

    Application: Pipe with 0.4 m diameter, made of stainless steel. Full filled. High pollution load, up to 1 % dry solids.

    By NIVUS GmbH based in Eppingen, GERMANY.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you