Refrigerant Gas Monitoring Equipment For Monitoring And Testing Near Madagascar
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
For determination of moisture Moisture is the most important criteria for the determination of the gas quality. This device has been designed specially for SF6 moisture measurements. It also shows a higher resistance against contamination and SF6 decomposition products than conventional moisture sensors and even minimises the usual long-time drifting. The integrated electronic flow meter supports ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The central management, supply and control unit displays the measured values and messages of the connected Sensors which measure the concentration of different gases in ambient air. The Monitor allows to display and record the measured values as well as to register messages. The potential-free relays serve for controlling further warning systems. Up to 32 Sensors can be controlled and monitored. ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
With atmospheric test chambers it is not necessary to evacuate air before the test process. Test chambers of this construction type can be manufactured at significantly lower cost with a significantly larger volume than vacuum chambers. We build these chambers with a chamber volume of up to 50 m³ as standard. This allows for reliable testing of even larger units and ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
During the operation of gas insulated switchgear decomposition products might occur after a breakdown which has a negative impact on the gas quality in the circuit breaker as well as on the insulation properties. For this reason the measurement of decomposition products is very important. The measurement can be carried out easily by means of test tubes and plastic ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The Mirror-Analyser SF6 uses the physical dew point mirror measuring principle which is characterised by its high precision and utmost reliability in order to measure the moisture content. By cooling the integrated mirror the moisture content of the gas is determined by measuring the temperature depending on the condensation or icing of the mirror. The other parameters of SF6 quality are ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
With its innovative equipment and intuitive user interface, the MultiAnalyser SF6 meets the user’s requirements and is ready for operation immediately after switching on. High-quality manufacture and ergonomic design guarantee the quality standards for a compact and maintenance-friendly measuring device with high measuring accuracy. This multi-functional measuring device allows the ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
These tanks offer sufficient volume to store or withdraw even large gas quantities in gaseous or liquid form – special feature of this type series: for withdrawal of liquid gas, the entire gas content can be withdrawn all at once without having to heat the tank. The tanks are equipped with digital weighing scales. These weighing scales enable to determine the filling weight with an accuracy ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
Vacuum testing of smaller components (without gas handling): This model range with a chamber volume of approx. 50 - 500 l is the ideal solution for testing smaller components where gas handling can take place outside the test ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The electronic bottle scales allow quick and easy determination of the filling quantity of a gas bottle. The large weighing platform and the supporting chain provide additional stability of the gas bottle. The weight is indicated on the illuminated display which switches off automatically if the scales are not used for a certain time. Thanks to the tare function gas inputs and outputs can be ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The weighing scales have been developed specially for large containers used for example in GIS production or in large substations. The weighing range of the device is up to 2,000 kg. The determined weight is indicated on the display immediately. The integrated serial interface is a special feature allowing data communication with other DILO devices. Thus, not only the weight can be read on the ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
DensiControl IN with connecting kit and 6 m long measuring hose. The F-gas regulation (EU) 517/2014 stipulates regular verification of density monitors installed in switchgear. In combination with a DILO lock valve it is possible to quickly check whether the density monitor switching points are triggered in time without disassembling the density monitor. Thus, the DensiControl IN allows very ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The test pressure for gas analysis in medium voltage switchgear is often too low. For this reason the compressor unit is needed to compress the gas to be measured so that there is sufficient pressure for the gas measuring devices connected downstream from the compressor unit. As the device is leak-tested there are no SF6 emissions. The oilfree compression avoids the SF6 test gas from being ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The unique combination of mass flow meter and fi lling device facilitates the SF6 gas monitoring considerably. This device does not only enable the registration of the quantities filled in, but allows the automatic filling of a gas compartment at the same time. Thus the operator can select the indication of the gas quantity required or the preset filling value. After having pressed the start key, ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
For quick detection and quantification of small SF6 leaks The cordless battery-operated LeakSpySF6 precisely measures SF6 concentrations in air by means of a non-dispersive infrared sensor (NDIR sensor) and indicates the value on a graphic display in ppmv. The device allows precise localisation of leaks by searching the highest SF6 concentration. Thanks to the high accuracy and the low detection ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
B152R41 / B152R41S15: Mass flow measuring system with an additional resettable, adding and subtracting counter. B152R51: Mass flow measuring system ( battery-operated with charge indicator). Battery operation enables an application independent of the power supply. With this device, gas monitoring is just that simple. Gas quantities which are filled in and recovered are registered and can be ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The cordless battery operated device measures in seven levels of sensitivity within a short response time. Even after the detection of large leaks the device returns to zero position quickly. The SF6 LeakPointer is easy to operate with one hand. Leakages can be easily detected via the clearly visible LED display or the audible signal (can be switched off). Continuous operation of the device is ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The F-gas regulation (EU) 517/2014 stipulates regular verification of density monitors installed in switchgear. The DensiControl DA allows quick checking to see whether the density monitor switching points are triggered in time. This device allows precise, quick and easy verification of the switching points. The density monitor type to be checked is selected in the data base and is then installed ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
For measurement of the SO2 concentration in gas mixtures. Before maintenance works are carried out it is absolutely necessary to know the gas quality. This special equipment allows precise measurement of SO2 in gas mixtures. Furthermore, this device is very resistant against contamination and SF6 decomposition products and is therefore a reliable instrument for each revision of circuit ...
-
PremiumManufactured by DILO Armaturen und Anlagen GmbHbased in GERMANY
The device is used to monitor and record the quality of the SF6 gas in a gas compartment. The following quality parameters can be determined with only one measurement: SF6 volume percentage (%). Moisture concentration (°C atmosphere, °C pressure, °F atmosphere, °F pressure, ppmv, ppmw). SO2-Concentration ...
-
Manufactured by Bacharach, Inc.based in USA
The MGS-150 Gas Detector can meet almost any gas detection need with multiple sensor options for real-time monitoring of refrigerants, oxygen, combustible and toxic gases. It includes user-selectable current or volt analog outputs, allowing connectivity to most BMS, SCADA or central control systems. Status LEDs and a buzzer are integrated for local alarming while an onboard relay with ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you