Sample Gas Equipment For Monitoring And Testing Near Malaysia
-
Manufactured by Specac Limitedbased in UNITED KINGDOM
A range of kits for various types and levels of FTIR spectroscopic ...
-
Manufactured by AirMetricsbased in USA
Airmetrics manufactures the MiniVol TAS, which samples ambient air at 5 liters/minute for particulate matter (PM10, PM2.5, TSP). While not a reference method sampler, the MiniVol TAS gives results that closely approximate data from Federal Reference Method samplers. Lightweight and portable, the MiniVol TAS is ideal for remote areas or locations where no permanent site has been ...
-
PremiumManufactured by AMETEK Land Instruments International Ltdbased in UNITED KINGDOM
An advanced carbon monoxide detector designed to provide early warning of spontaneous combustion in coal and biomass storage ...
-
Manufactured by Sigrist-Photometer AGbased in SWITZERLAND
The StackGuard continuously monitors the scatted light intensity of an extracted, withdrawn sample of gas. The laser light source minimized stray light and improves sensitivity to the µg/m³ level, the filtered purge air prevents from window soiling. A calibration check is performed by means of a checking ...
-
PremiumManufactured by Advanced Energy Industries, Inc.based in USA
The Advanced Energy Innova 1409 is a reliable, easy-to-use multipoint sampler for gas sampling of up to 24 different locations. The Innova 1409 is designed to be remotely controlled from a PC using a USB interface in conjunction with an Innova Photoacoustic Gas Monitor to provide a flexible, sensitive, and accurate monitoring ...
-
PremiumManufactured by AMETEK Land Instruments International Ltdbased in UNITED KINGDOM
A compact, reliable multi-gas analyser for measuring flue gas emissions in processes burning natural gas and biomass. The FGA provides accurate, reliable measurement of carbon monoxide, nitric oxide and oxygen in flue gases. It is an integrated solution for Continuous Emissions Monitoring Systems (CEMS) applications in smaller combustion ...
-
Manufactured by Codel - a Forbes Marshall companybased in UNITED KINGDOM
The GCEM40E hot extractive multi-channel gas analyser is CODEL’s industry-proven continuous emissions monitor for difficult applications. Designed exclusively for use on a wide range of applications where the flue gas temperature is abnormally high, low or saturated. Three decades of development, knowledge and practical experience have been utilised to produce this advanced technology gas ...
-
based in USA
The SmartCEMS® Probe is a component of a predictive emission monitoring system (PEMS) that provides for continuous stack gas sampling for pollutants and diluents under U.S. EPA 40 CFR Part 60 and/or U.S. EPA 40 CFR Part 75 regulations. The Probe will meet the requirements for sampling during model development and PEMS QA activity. The Probe is required to connect the sample line and the ...
-
based in USA
The SmartCEMS® Sample Interface Panel is a component of a predictive emission monitoring system (PEMS) that provides for continuous stack gas sampling for pollutants and diluents under U.S. EPA 40 CFR Part 60 and/or U.S. EPA 40 CFR Part 75 regulations. The Sample Interface Panel will meet the requirements for sampling during model development and PEMS QA activity. The Sample Interface Panel ...
-
Manufactured by Industrial Physics Product Integrity Limitedbased in UNITED KINGDOM
Intrinsically safe ATEX-approved EC91 is an unsurpassed oxygen analyzer for all hazardous areas. The EC91 intrinsically safe oxygen analyzer is an online transmitter for ppm and percent oxygen measurements of gas streams in hazardous area installations. It can detect oxygen levels from as low as 1 ppm up to higher percent levels and can be used in most industrial gases and atmospheres. There is ...
-
Manufactured by Codel - a Forbes Marshall companybased in UNITED KINGDOM
The early detection of coal fires in coal handling systems on coal fired power stations is essential to prevent catastrophic damage to expensive plant and serious injury to personnel. The most reliable and accurate method of detecting coal fires or smouldering is to monitor the carbon monoxide levels within the coal handling plant areas such as silos and mills and to detect rapid increases in ...
-
PremiumManufactured by Apex Instruments, Inc.based in USA
EPA Method 4 is used to determine the moisture content of stack gases. A gas sample is extracted at a constant rate from the source. Moisture is then removed from the sample stream and the condensate is measured either by volume or by ...
-
Manufactured by Industrial Physics Product Integrity Limitedbased in UNITED KINGDOM
Portable oxygen analyzer used to measure oxygen levels suitable for hazardous environments. The EC92DIS portable oxygen analyzer can be used in hazardous areas - approved for II 1G Ex ia IIc Ga T4 - Zone 0 (ATEX). It is designed to measure oxygen levels and can detect oxygen levels as low as 1ppm, up to high percent oxygen levels and can be used on most industrial gases and atmospheres. There is ...
-
Manufactured by QED Environmental Systemsbased in USA
Optimize LFG Control, Accuracy and Dependability with QED Accu-Flo Wellheads. QED Accu-Flo wellheads can help prevent landfill gas migration, emissions and subsurface fires. Landfill owners and operators will appreciate the Accu-Flo design that meets the special equirements of landfill gas recovery for environmental compliance and energy production. Easy installation and maintenance of the ...
-
Manufactured by WITT-Gasetechnik GmbH & Co KGbased in GERMANY
OXYBABY O2/CO2 is the practical battery-operated hand held gas analyser for measurement of modified atmospheres in food packages (MAP). The gas analyser OXYBABY is the perfect device for mobile, fast and accurate samples: at the packaging machine, in packages or in the laboratory. The small, high capacity gas analyser features ergonomic design, short sample times, minimal sample gas requirements ...
-
Manufactured by WITT-Gasetechnik GmbH & Co KGbased in GERMANY
Compact analyser for the monitoring of protective atmospheres in food packaging (MAP) and welding. For continuous analysis (inline) and also intermittent sampling via a needle e.g. from food packs. A flexible analyser to guarantee quality and productivity of production processes. Whenever you need a record of your measurement this instrument together with the exclusive OBCC-Software is the ...
-
based in USA
The SmartCEMS Portable Gas Analyzer System is a component of a predictive emission monitoring system (PEMS) that provides for continuous stack gas sampling for pollutants and diluents under U.S. EPA 40 CFR Part 60 and/or U.S. EPA 40 CFR Part 75 regulations. The Portable Gas Analyzer System can test up to 6 gases simultaneously, or swap sensors out for additional parameters. It has an innovative ...
-
based in USA
The SmartCEMS® Shelter CEMS is a complete continuous emission monitoring system (CEMS) contained in a fixed shelter. The Shelter CEMS is without a zone rating such as ATEX II. The Shelter CEMS can be equipped to provide continuous stack gas analysis for pollutants and diluents under U.S. EPA 40 CFR Part 60 and/or U.S. EPA 40 CFR Part 75 regulations. The Shelter CEMS is equipped with analyzers ...
-
Manufactured by Codel - a Forbes Marshall companybased in UNITED KINGDOM
The early detection of coal fires in coal handling systems on coal fired power stations is essential to prevent catastrophic damage to expensive plant and serious injury to personnel. The most reliable and accurate method of detecting coal fires or smouldering is to monitor the carbon monoxide levels within the coal handling plant areas such as silos and mills and to detect rapid increases in ...
-
Manufactured by ION Science Ltd.based in UNITED KINGDOM
Monitor and sample benzene with world leading benzene detection technology. Titan 2 benzene gas monitor incorporates the NEW MiniPID T2 10.0 eV Sensor which offers improved sensitivity, reliability and overall performance. The unique sampling method eliminates interfering gases such as toluene, xylene and methane providing you with accurate benzene concentration readings you can rely ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you