Sampling Train Equipment For Monitoring And Testing Near Tuvalu
-
PremiumManufactured by Tekran Instruments Corporationbased in CANADA
The Tekran 2600-IO5 system provides a manual approach to ambient air analysis or other non-flammable gasses. Samples are collected onto gold-coated quartz traps, and then analyzed on the 2600-IO5 instrument to determine Hg content. The Tekran Model 2600-IO5 Mercury Analyzer is designed for the analysis of ambient air sampling cartridges. The system contains an atomic fluorescence detector, a dual ...
-
PremiumManufactured by Tekran Instruments Corporationbased in CANADA
The Tekran Model 2030 Heated Cartridge Sampler allows gold coated sampling cartridges to be heated while they are exposed to a variety of gaseous sample matrices (i.e. ambient air, natural gas, or process gases). The performance of gold adsorbent cartridges is greatly enhanced if the cartridges are heated during exposure. This virtually eliminates problems with condensation of passivation of the ...
-
PremiumManufactured by Tekran Instruments Corporationbased in CANADA
Tekran and VE Technology have partnered together to improve the quality of Natural Gas sampling and analysis. Proper sample collection requires precision equipment to assure mercury is quantitatively transported between the source pipeline and the sample collection device. The Tekran 2642 Natural Gas Sampler paired with a Tekran 2600-NG provides a complete sampling and analysis ...
-
Manufactured by Control Instruments Corporation (CIC)based in USA
The Model 650 FID is a high-temperature flame ionization sensor that continuously measures total hydrocarbon concentrations. Industrial Design: Rugged industrial strength assembly suitable for continuous use in harsh environments. Direct Mount: Design eliminates heat-traced sample lines & allows the fastest response time. Fully Heated: To avoid condensation during sampling, the entire sensor ...
-
Manufactured by Control Instruments Corporation (CIC)based in USA
Operating Temperature: 270°C - 518°F. The Model SNR675 is an industrial strength assembly consisting of a heated flame cell and an integrated controller that continuously measures total flammable vapor concentrations from 0 to 100% of the Lower Flammable Limit (LFL) range. Optional modifications allow the SNR675 to sample low oxygen and inert ...
-
Manufactured by Control Instruments Corporation (CIC)based in USA
Operating Temperature: 200deg;C - 392deg;F. The Model SNR674 is an industrial strength assembly consisting of a heated flame cell and an integrated controller that continuously measures total flammable vapor concentrations from 0 to 100% of the Lower Flammable Limit (LFL) range. Optional modifications allow the SNR674 to sample low oxygen and inert ...
-
Manufactured by Control Instruments Corporation (CIC)based in USA
Operating Temperature: 60°C - 140°F. The Model SNR671 is an industrial strength assembly consisting of a heated flame cell and an integrated controller that continuously measures total flammable vapor concentrations from 0 to 100% of the Lower Flammable Limit (LFL) range. Optional modifications allow the SNR671 to sample low oxygen and inert ...
-
Manufactured by Control Instruments Corporation (CIC)based in USA
The CalorVal BTU Analyzer continuously measures the heating value (Calorific Value) of gaseous streams of industrial processes. Real time: Direct measure of calorific value. Fast: Less than 3.5 seconds cell response time. Universal: Highly uniform response to a wide variety of combustibles. Continuous: Ongoing measurement, not batched. Reliable: Not poisoned by process contaminant, water, ...
-
Manufactured by Control Instruments Corporation (CIC)based in USA
Operating Temperature: 120°C - 248°F. The Model SNR672 is an industrial strength assembly consisting of a heated flame cell and an integrated controller that continuously measures total flammable vapor concentrations from 0 to 100% of the Lower Flammable Limit (LFL) range. Optional modifications allow the SNR672 to sample low oxygen and inert ...
-
PremiumManufactured by Apex Instruments, Inc.based in USA
EPA Method 4 is used to determine the moisture content of stack gases. A gas sample is extracted at a constant rate from the source. Moisture is then removed from the sample stream and the condensate is measured either by volume or by ...
-
Manufactured by Genius5-Instruments GmbHbased in AUSTRIA
Genius5 AiO system developed to support EU Commission implementing decision 2017/1442 and plant operators. Commission implementing decision (EU) 2017/1442 defines very low limit valus for the emission of mercury. Incinerators >= 300 MW have to measure contineously, incinerators <= 300 MW have to measure 4 times a year using EN 13211. The legal limit values for mercury are reduced to 1 - 2 ...
-
PremiumManufactured by Apex Instruments, Inc.based in USA
The Apex Instruments PFAS Sampling System is based on the EPA Other Test Method 45 (OTM-45) and Other Test Method 50 (OTM-50) for the isokinetic collection of PFAS from stationary sources. PFAS stands for per- and polyfluoroalkyl chemicals, which are found in a wide range of consumer products and facilities. PFAS can accumulate in the body and may lead to adverse health effects. Gaseous and ...
-
PremiumManufactured by Apex Instruments, Inc.based in USA
PM 10/PM2.5 Set combines the in-stack measurement of particulate matter (PM) equal to or less than an aerodynamic diameter of nominally 10 (PM10) and 2.5 (PM2.5 ) microns from stationary sources. The sampling train and operation are identical to Method 201A except that the PM2.5 cyclone is inserted between the PM10 cyclone and the 47-mm filter. The PM10 cyclone collects particulate matter ...
-
PremiumManufactured by Apex Instruments, Inc.based in USA
The XC-502 is an all-in-one digital isokinetic source sampler that offers numerous features to increase convenience and efficiency for stack testers. The latest installation in the Apex Instruments Peak 32 series, the XD-502 is powered by the PIC32 microcontroller module and features a sunlight-readable backlit ...
-
Manufactured by Ogawa & Company, USA, Inc.based in USA
Ambient Air Passive Sampler for NO-NO2, NOx, SO2, O3, NH3. The Ogawa Sampler is ideal for low-cost air monitoring programs, personal, outdoors and indoors. The only known method of passive simultaneous monitoring of NO & NO2. The Ogawa Sampler is reusable countless times. Only the pre-coated filter pad is expendable. The same sampler is used for all above shown ...
-
Manufactured by Geophysical Survey Systems, Inc., (GSSI)based in USA
The StructureScan Mini is GSSI’s all-in-one GPR system for concrete inspection. This hand held system locates rebar, conduits, post-tension cables, voids and can be used to determine concrete slab thickness in real-time. The StructureScan Mini safely locates metallic and non-metallic targets within concrete structures up to a depth of 20 inches. The system incorporates an auto target ...
-
Manufactured by Filtronics, Incorporatedbased in USA
To keep your treatment system operating at peak efficiency, call the Filtronics' Parts Pipeline for all of your consumables, replacement parts and supplies. Whether you need preventative maintenance parts or emergency service, Filtronics can help you. ...
-
Manufactured by Geophysical Survey Systems, Inc., (GSSI)based in USA
The StructureScan Mini HR is GSSI’s all-in-one high-resolution GPR system for concrete inspection. With a 2600 MHz antenna, this handheld system locates rebar, conduits and post-tension cables in depths of up to 16 inches (40 cm). The StructureScan Mini HR is available in two models; 2D, for real-time target location and 3D, for an x-ray like image. Ideal for complex areas, the ...
-
Manufactured by Landytop Medical System Co., Ltdbased in CHINA
Testing Mode: Single sample or multiple samples. Sample Tray: Wheel type, 24 sample slots, automatically cleaning, re-usable. Counting Pool Cleaning: powerful water blasting flush in one-way. Needle Cleaning: Sample needle coating with special fluorine, blasting flush for interior, bubbling irrigation for exterior. Environment temp.: 15?~35?. Relative humidity: ≤85%. Atmospheric pr+essure: ...
-
Manufactured by Focused Photonics Inc. (FPI)based in CHINA
SupNIR-2700 series is infrared analyzing equipment; it uses Holographic digital grating and high sensitivity InGaAs detector (TEC constant temperature cooling). The sample is analysis is based on the diffuse reflection model, and the wavelength range covers 1000-2500 nm. With the help of computer software called RIMP, particles, flakes, powder samples, chemical components are rapidly detected ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you