Seismic Surveys Equipment For Monitoring And Testing Available In Sweden
-
Manufactured by MoHo s.r.l.based in ITALY
TROMINO is an ideal solution in Engineering Geology for seismic site effect assessment, seismic microzonation, Vs30 estimates, passive seismic stratigraphy, bedrock mapping. Supporting geologists, geophysicists and geotechnical engineers in their daily activities. TROMINO was specifically conceived and designed for the dynamic characterization of subsoils with the highest accuracy and the lowest ...
-
Manufactured by Geodevicebased in FRANCE
DAQLink-4 is a cutting-edge performance portable multichannel 24-bit digital seismograph. It can operate as a stand-alone unit for small and fast near-surface surveys, acquisition system for larger projects with online monitor and data quality control, as well as passive monitoring and automated event ...
-
Manufactured by MoHo s.r.l.based in ITALY
Bringing the past of multichannel seismographs to a new life. SOILSPY is the MoHo’s multichannel digital system for active and passive seismic surveys. A number of unique features make it a very special seismograph. The signal is amplified and digitized where it is produced and not at the end of long cables: this ensures better recording quality and, allied to a lightweight system, forms a ...
-
Manufactured by M.A.E. Advanced Geophysics Instrumentsbased in ITALY
3 components accelerometer sensor for structural and environmental seismic monitoring, accuracy of 100 mV/g, housed in an aluminum IP-67 protection rate case with embedded fixing flaps; ideal for installation in hard environments, it is supplied with IP-67 12 male Amphenol connector with protective cap and orange polish PUR cable. Aluminum mounting bracket is supplied together with sensor, in ...
-
Manufactured by VERIPOS, part of Hexagonbased in UNITED KINGDOM
The LD8 is a high-precision GNSS receiver from Hexagon | Veripos that provides reliable and accurate positioning. The compact and lightweight receiver offers industry-leading GNSS multi-constellation heading and positioning data for dynamic environments. L-band signals can be received on multiple channels providing access to the worldwide correction services offered by ...
-
Manufactured by M.A.E. Advanced Geophysics Instrumentsbased in ITALY
3 components accelerometer sensor for structural and environmental seismic monitoring, accuracy of 1 V/g, housed in an aluminum IP-67 protection rate case with embedded fixing flaps; ideal for installation in hard environments, it is supplied with IP-67 12 male Amphenol connector with protective cap and orange polish PUR cable. Aluminum mounting bracket is supplied together with sensor, in order ...
-
Manufactured by M.A.E. Advanced Geophysics Instrumentsbased in ITALY
3D seismic surface sensor, 4,5 hz frequency geophones, aluminum case, support bases to use on floor or to be fixed into ground, level bubble, transport handle. 3D surface sensor manufactured according to highest quality standard, 10 mm aluminum case which can ensure stable positioning of internal components, external oxidation for a finishing that facilitates cleaning after field use. This sensor ...
-
Manufactured by MoHo s.r.l.based in ITALY
TROMINO is an ideal solution in Civil Engineering for the operational modal analysis of structures, vibration monitoring and soil-structure interaction studies. Supporting engineers and architects in the design, monitoring, modelling and retrofitting of structures. TROMINO, originally conceived for the dynamic characterization of subsoils, has been increasingly used for the operational modal ...
-
Manufactured by Olson Instruments, Inc.based in USA
Parallel Seismic is more accurate, more versatile than other nondestructive surface techniques for determination of unknown foundation depths. Parallel Seismic (PS) systems are designed to determine the length and integrity of foundations when the top is not accessible or when the pile is too long and slender to test with echo techniques, or below a buried pile cap. Ultimately, Parallel Seismic ...
-
Manufactured by DMT GmbH & Co. KGbased in GERMANY
The SUMMIT X One represents the latest generation of DMT’s long-standing successful SUMMIT product line of field seismographs. Ultra small one-channel remote units linking to a lightweight SUMMIT line cable via the new optimized SUMMIT SNAP-ON technology result in the world’s most flexible wired seismic acquisition system. ...
-
Manufactured by Avalon Sciences Ltdbased in UNITED KINGDOM
The GeochainSlim is the next development of the field proven VSP and hydraulic fracture monitoring. This system has been designed for use in open or cased holes with all locking arms opening simultaneously to reduce survey time. A maximum bandwidth of 1600Hz, very low electronic noise levels and slim size make the system ideal for hydraulic fracture surveys. The established extra high sensitivity ...
-
Manufactured by Avalon Sciences Ltdbased in UNITED KINGDOM
Geochain EHP is one of the latest evolutionary branches of the established Geochain VSP digital seismic system. It is capable of operating with up to 62 satellites for maximum logging and recording efficiency within the most hostile of high pressure environments. The Geochain EHP system is fully compatible with all standard Geochain electronics and sensor modules in addition to all standard ...
-
Manufactured by Geofrost ASbased in NORWAY
Ground freezing was required to get through a rock depression filled with permeable glaciofluvial material, with crown 120 m below sea level. GEOFROST had the full responsibility for all the activities from design to procurement, construction, commissioning and hand over of the frozen ...
-
Manufactured by Zhaofeng Sensor Equipment Co., Ltd.based in CHINA
For marine seismic acquisition towing the nodal, customized interval and moveable clip ...
-
Manufactured by M.A.E. Advanced Geophysics Instrumentsbased in ITALY
24 bit seismograph for seismic prospecting with refraction, reflection survey, active and passive MASW (Re.Mi.), SASW, Down-hole, Cross-hole methods. Unit is equipped with 24 bit resolution acquisition board and is available in 12 channels version expandable to 24. Two 24 pole connectors for seismic cables of 12 channels each, starter connector, 12V charging takeout and USB interface (optional) ...
-
Manufactured by aae technologies Ltd.based in UNITED KINGDOM
The Delta Sparker is the most powerful sparker available in the applied acoustics range and is intended for deeper penetration sub-bottom profiling. As a multi-tip sparker array, the Delta can be used in UHR multi-channel seismic surveys, utilising 24 or 48 channel streamers during geohazard assessment, construction projects or shallow target 2D ...
-
Manufactured by Deep Ocean Engineering, Inc.based in USA
A Powerful and Manueverable Inspection Class Vehicle. The Phantom S-Series is a portable, high-performance ROV that combines superior power, telemetry, and payload with ease of use, ruggedness and reliability. It can be configured with six or eight magnetically-coupled brushless Tecnadyne® thrusters to provide agressive lift capabilities at depths up to 1,000m. It delivers a powerful overall ...
-
Manufactured by Geodevicebased in FRANCE
Jack energy sources ensure the operation of sparker and electrodynamic sources used in geophysical surveys in boreholes by methods of crosshole seismic testing (CST), vertical seismic profiling (VSP), vertical seismoacoustic profiling (VSaP) and ...
-
Manufactured by Olson Instruments, Inc.based in USA
Olson's Best Selling Nondestructive Testing System to Test Newly Placed Shaft Foundations. The Crosshole Sonic Logging system is the most accurate and reliable technique for assessing the integrity of deep foundation elements constructed on-site from concrete or grout. The system is designed for Quality Assurance (QA) testing of newly placed critical drilled shaft foundations and auger cast ...
-
Manufactured by M.A.E. Advanced Geophysics Instrumentsbased in ITALY
3D seismic sensor designed according to highest quality standard, with case for outdoor installation and maximum protection of internal components. It can be connected to Mae instruments for Seismic Monitoring and building continuous monitoring. Rapid and practical fixing due to fins with predetermined holes, in case of fixing on vertical walls it is possible to use L mounting bracket supplied ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you