We couldn't find any soil-water potential equipment suppliers or service providers located in Tennessee

Here is a list of equipment results with suppliers serving Tennessee

soil-water potential Equipment available in Tennessee

  • Premium

    TensioMark - Matric Potential Sensor

    The TensioMark measures the soil water potential or matric potential. The soil matric potential is the pressure it takes to pull water out of the soil and is an indicator of stress to plants and crops, can be used to determine soil water fluxes and available water held in the soil. Water equilibrates with the ceramic tip portion of the sensor ...

    By Stevens Water Monitoring Systems, Inc. based in Portland, OREGON (USA). from Soil Sensors Product line

  • Model SDI12 Sensor - Matric Potential & Soil Temperature pF-Meter

    The new measerment procedure of the pF- meter  is based on the registration of the volumetric heat capacity. A ceramic membran get in balance with the soil tensions. Inside the ceramic membran a special sensor measure continuously the water content, witch is adapted to the hydraulic potential. hereby the matrix potential can be measured  ...

    By GeoPrecision GmbH based in Ettlingen, GERMANY.

  • Premium

    Eijkelkamp - Model 08.65 - Air Permeameter for Soil

    The air permeameter apparatus measures the permeability or conductance of an (undisturbed) soil sample. Air permeability is the property of the soil pore system allowing air to flow through. Generally the pore sizes and their connectivity determine whether a soil has high or low permeability. Air will flow easily through soil with large pores and ...

    By Eijkelkamp Soil & Water based in Giesbeek, NETHERLANDS. from Laboratory Equipment Product line

  • Model SR 1000 - Direct Reading Tensiometer

    Accepted as the way to measure the water potential in soils, the tensiometer has become an easy to use and very handy tool for field research (agronomy) and managing inputs in agriculture (water). The SR 1000 tensiometer is robust as well as cost effective. Measurements are taken with a BOURDON type manometer. This measuring principle, easy to use ...

    By SDEC France based in Tauxigny, FRANCE. from Soil Tensiometers Product line

  • SDEC - Model SMS 2500S - Hand Held Pressure Sensor for Sms Tensiometers

    The measuring technique with the SMS 2500S electronic pressure meter consists in piercing through a silicon bung closing a tensiometer, by means of a hypodermic needle, itself connected to a pressure transducer (or vacuumeter). This type of measure, both very precise and very economical (a unique appliance can be used on a great number of ...

    By SDEC France based in Tauxigny, FRANCE. from Soil Tensiometers Product line

  • SDEC - Model STE 600 - Complete Tensiometer With Pressure Sensor & Manometer

    Designed to reply to need of acquisition of the information, the electronic tensiometer STE 600 replies in all points to this objective.To make this and so as to guarantee the work of a machine without break, the constructor proposes various solutions to obtain a reliable instrument in difficults climatical conditions. The temperature ...

    By SDEC France based in Tauxigny, FRANCE. from Soil Tensiometers Product line

  • Quil - Model 2600 and 2300 - Soil

    GOC released the first version of BAT 506. Since then the product has evolved into the current formula marketed as QuikSoil® 506 in Europe and QuikSoil 2600 and 2300 in the USA. The product has undergone 4 generations of improvements since initial release. New discoveries in microbiology and enzymology have been incorporated in the current ...

    By Global Odor Control Technologies, LLC (GOC) based in Bloomington,, INDIANA (USA). from Compost Treatment Product line

  • Model (SMM) - Soil Moisture Meter

    The Soil Moisture Meter (SMM) is a stand-alone logging instrument for the measurement of volumetric moisture content of soils and other materials. The SMM can support up to 10 x standing wave sensors ( MP406 or MP306 ) or up to 10 x capacitance sensors ( 10HS or EC5 ).The SMM is a fully self-contained unit requiring power input from a 7W or 11W ...

    By ICT International based in Armidale, AUSTRALIA.

  • Pervaide - Non-Ionic Soil

    In order to maximize your yield potential, you must keep the proper air-water-soil mixture throughout your soil profile. It’s simple—plants can grow larger and more efficiently with effective root penetration into properly wetted soil with active soil microorganisms. A deficient air-water-soil ratio – soil that is too wet, too ...

    By Ag Concepts based in Eagle, IDAHO (USA).

  • Transfer Station & Soil Compaction

    Specialized wheels made to meet the demands of the transfer station environment. Designed to increase on-site material reduction and improved machine performance.

    By Caron Compactor Company based in Escalon, CALIFORNIA (USA).

  • Apogee - Model SO-110 - Soil Response Thermistor Reference Oxygen Sensor

    The SO-110 has a standard response time of 60 seconds and is designed for use in soil applications. It comes with a thermistor temperature sensor to correct for temperature changes and a restive heater to raise the temperature of the membrane approximately two degrees above ambient temperature to keep condensation from occurring on the Teflon ...

    By Apogee Instruments, Inc. based in Logan, UTAH (USA). from Oxygen Sensor Product line

  • BioLiner™ - Biodegradable – Disposable Soil Sampling Liners

    Soil sample liners are similar to bailers.  They are disposable plastic tubes used to collect a soil sample as opposed to a water sample.  The soil sampling liners are used in direct push type rigs to collect a soil profile.  As the sampling tool is driven into the ground the soil is extruded inside the liner.  Once the sample ...

    By ESP, Environmental Service Products based in Rockledge, FLORIDA (USA).

  • Apogee - Model SO-120 - Soil Response Thermocouple Reference Oxygen Sensor

    The SO-120 has a standard response time of 60 seconds and is designed for use in soil applications. It comes with a thermocouple wire to correct for temperature changes and a restive heater to raise the temperature of the membrane approximately two degrees above ambient temperature to keep condensation from occurring on the Teflon membrane and ...

    By Apogee Instruments, Inc. based in Logan, UTAH (USA). from Oxygen Sensor Product line

  • Premium

    Model 14.36 - Oxygen Diffusion Meter

    In plant cultivation it is very important that the soil has proper ventilation. The necessary oxygen supply for the roots and the discharge of the carbon dioxide gas that is formed there, in case of most cultivated growth, takes place via the soil. Also soil chemical processes depend on the presence of oxygen in the soil.

    By Eijkelkamp Soil & Water based in Giesbeek, NETHERLANDS. from Field Measurement Equipment Product line

  • Ex-Situ Chemical Oxidation of Soil & Hazardous Waste System

    ART employs two types of ex-situ soil/sediment chemical oxidation processes: Saturated Soil Contacting - typical contaminant reduction efficiency in range of 50-80%. Soil Oxidation in Slurry Reactors - contaminant reduction greater than 90% up to 99% achievable depending on type of contamination and soil/sediment matrix.

    By ART Engineering, L.L.C. (ART) based in Land O Lakes, FLORIDA (USA).

  • Temperature Sensor

    To measure temperatures in soil, rock or structures, water pressure-tight encapsulated Pt1000 sensors are used. In the case of deformation measurements of structural components (e.g. pile foundations, concrete columns) temperature compensation and thus the temperature measurement of structural components is very important. Air temperatures are ...

    By Solexperts AG based in Mönchaltorf, SWITZERLAND. from Geotechnics Product line

  • Waste Water Treatment System

    The recent World Health Organization Guidelines on safe use of wastewater, excreta and black & grey water opens doors for other reuse opportunities than urban irrigation. This gives an opportunity to re-invent the role of sanitary engineers in the future of sustainable urban development to join with urban planners, developers and policy ma

    By Genoil Inc. based in New York, NEW YORK (USA).

  • Model Nontox - Hydrocarbon Remediation

    Nontox is a breakthrough bio-catalytic composition that leads to a new advancement in the cleaning and remediation of petroleum hydrocarbon pollutants. It works by stimulating and accelerating the natural biological reactions that cause organic substances to rapidly decompose, bio-catalytically breaking the bonds of the molecular structure of ...

    By Bio-Organic Catalyst, Inc. based in Costa Mesa, CALIFORNIA (USA).

  • Potable Water Benefits

    High Density Polyethylene (HDPE) Solid Wall Pipe has been used in Potable Water applications since the '60's, and has been gaining approval and growth in municipalities ever since. HDPE Pipe is specified and/or approved in AWWA C901, AWWA C906, NSF 14, NSF 61 and ASTM International D3035. Some distinctive advantages of HDPE pipe that provide ...

    By Plastics Pipe Institute Inc. (PPI) based in Irving, TEXAS (USA). from Municipal & Industrial Product line

  • OdaLock - Model WP-1 - Industrial use Powdered Mineral Adsorption Technology

    WP-1™ is an innovative water and soil amendment produced by the chemical and physical activation of insoluble clay minerals. WP-1™ is specifically formulated for use in Concentrated Animal Feeding Operations (CAFO’s), industrial waste water and sewage treatment, aquaculture and a variety of natural aquatic systems e.g. ponds, ...

    By Applied Remediation, llc based in Sioux Falls, SOUTH DAKOTA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you