Voltage Monitoring Articles

  • Corporate sustainability: A guide to measuring and improving energy efficiencies

    As environmental scrutiny of global industries continues to grow, governments are seeking to impose energy efficiency targets on companies in order to comply with new directives. One solution is to encourage energy suppliers to become energy service companies, who work with customers to identify potential savings and share the benefits this delivers. For the global food processing industry, this ...


    By TOMRA Sorting GmbH.

  • Nitrogen Refrigerated Trucks a New Trend? An Alternative to Diesel Powered Refrigeration

    Nitrogen Refrigerated Trucks a New Trend? An Alternative to Diesel Powered Refrigeration Thanks to technological innovations, the food distribution industry has a greener way to protect refrigerated food during transit: Nitrogen refrigeration. The existing system relies on diesel-powdered mechanical refrigeration units. Although these units are effective, they release ...

  • Measuring IR Light and Near-IR Light

    Infrared (IR) light emits a broad range of non-visible wavelengths in the electromagnetic spectrum. Applications for infrared, including near-infrared, are defined by the respective IR bands during output. For example, LIDAR (Light Detection and Ranging) equipment uses 1,000 nm and 1,550 nm IR bands while surveying an area. In the military sector, 850 nm, 1,060 nm and 1,500 nm (and up) are used ...


    By Larson Electronics LLC

  • New Maps from Old Photos: Measuring Coastal Erosion

    U.S. Geological Survey scientists and their coauthors from the California Coastal Records Project have found a way to use historical aerial photographs not just to see evidence of coastal erosion, but to accurately measure how much has occurred over time. Applying a low-cost technique called “structure-from-motion” to five sets of oblique aerial photos spanning the years ...

  • Newbuild Power Station in Karlsruhe - Case Study

    EnBW is one of the biggest German energy suppliers. A major new build bituminous coal fired power plant construction project is the new boiler number 8 of the Rheinhafen Dampfkraftwerk (RDK) in Karlsruhe. The new boiler will have a capacity of 912 MWel with a heating capacity of 220 MWth. The unit will be erected beside the existing units RDK4s and RDK7 and have a net efficiency of > 46% ...

  • E.ON Benelux power station Maasvlakte, Rotterdam - Case Study

    Next Generation Power Production E.ON’s new Maasvlakte power station also known as MPP3 is built in the harbour of the Dutch metropolis Rotterdam. The modern supercritical hard coal fired unit with a capacity of 1100 MW is expected to have a thermal efficiency of more than 46 percent. The new plant built in the vicinity of the existing Maasvlakte station is designed as cogeneration ...

  • Luminant Oak Grove Power Station - Case Study

    Powering Texas Luminant, a subsidiary of Energy Future Holdings Corp. (EFH) -which owns competitive and regulated energy subsidiaries in Texas -is the largest electricity generator in Texas. Unit two of the Oak Grove Power plant near Franklin in Robertson County, TX went online in the middle of 2010. Fluor, the project’s EPC company, completed the plant in 35 months and used ...

  • Importance of measuring UV transmittance (UVT) for UV disinfection

    UV disinfection systems disinfect water using UV light at the 254 nm wavelength. UV light at this wavelength actually destroys the DNA of microbiological material in the water which prevents dangerous viruses such as cryptosporidium and e-coli from reproducing and causing harm. UV Disinfection Dose and UV Transmittance (UVT) The effectiveness of a UV disinfection system is ...


    By Real Tech Inc.

  • Detailed off-gas measurements for improved modelling of the aeration performance at the WWTP of Eindhoven

    At wastewater treatment plants (WWTPs), the aerobic conversion processes in the bioreactor are driven by the presence of dissolved oxygen (DO). Within these conversion processes, the oxygen transfer is a rate limiting step as well as being the largest energy consumer. Despite this high importance, WWTP models often lack detail on the aeration part. An extensive measurement campaign with ...


    By IWA Publishing

  • Power curve measured and verified – Case Study

    In 2010 RSE SpA (Energy System Research Inc.) within a Program Agreement with the Italian Ministry of Economic Development started a measurement campaign on a Libellula wind plant installed in Tuscany. The campaign lasted 1 ½ years and during this time RSE measured the turbine’s power curve following the requirements of the relevant IEC Standard ...


    By Aria s.r.l

  • Helplessly exposed to nature? How lightning storms can be measured

    Each day, there occur about 1,000 thunderstorms with 4-10 million lightning bolts worldwide. In average, 700 people per year are hit by such light discharges, of which 75% of the hits result in long-term damages. Between three and seven cases end fatal. The risk is particularly high in the open field and is fortunately decreasing. The reason for this is that we stay more often inside in cars and ...

  • Treatment of natural rubber processing wastewater using a combination system of a two-stage up-flow anaerobic sludge blanket and down-flow hanging sponge system

    A pilot-scale experiment of natural rubber processing wastewater treatment was conducted using a combination system consisting of a two-stage up-flow anaerobic sludge blanket (UASB) and a down-flow hanging sponge (DHS) reactor for more than 10 months. The system achieved a chemical oxygen demand (COD) removal efficiency of 95.7% ± 1.3% at an organic loading rate of 0.8 kgCOD/(m3.d). Bacterial ...


    By IWA Publishing

  • Beyond Incident Rates: Use the Power of Leading Indicators to Improve EHS Performance

    What if you were driving somewhere, and could only see backwards in the rear-view mirror? Sounds scary, but this is pretty much how traditional Environmental, Health and Safety (EHS) metrics like incident and injury rates have been used for decades to manage performance. Such lagging indicators measure what occurred in the past. They give you a good view of where you’ve been, but not where ...


    By Rivo Software Ltd.

  • Cam correlation analysis using Acoustic discharge measurement

    The low head hydro power plant in Wettingen, Switzerland, is in operation since 1933 and no effective cam optimization has been carried out up to now. The goal of the measuring campaign was to provide data enabling an economic study for a retrofit and upgrade project of the plant and the measurement of the efficiency improvement of turbines after refurbishment. The contribution discusses cam ...


    By HydroVision GmbH

  • By the Numbers

    In a sense, metrology makes the world go around. It can quantify how long it takes the Earth to rotate, and the science of weights and measurements underpins everything from telling time to ensuring the fairness of international trade agreements. Metrologists must be extremely precise in their measurements, according to Alan Steele, Canada’s chief metrologist and the general manager of ...


    By ASTM International

  • The Power of the Moon

    The influence the moon has on life on earth is disputed. However, during an assignment in Southeast Asia, vibration experts from Sulzer were able to clearly confirm that the moon can even affect pumps. With its broad expertise, the Sulzer team was able to solve an unusual case of vibration. Southeast Asia is a key exporter of LNG (liquefied natural gas) to global markets, and it is ...


    By Sulzer

  • The Age of Renewable Power – New IRENA Guide to the Future of Energy

    A new report from the International Renewable Energy Agency (IRENA) aims to assist countries in their transition to renewable energy-based power systems. The Age of Renewable Power, released today on the sidelines of the Innovation for Cool Earth Forum ...

  • Protection Relay for Shaft Current and Voltage

    Introduction The paper deals with the specific protection relay for all types of generators. The instrument, called Shaft Current and Voltage Protection Relay (SCVP) was developed at KONCAR – Electric Engineering Institute Inc. This instrument is a part of Institute's product line used for monitoring and diagnosis of rotating electrical machines. The most important parts ...

  • How to measure the direction of current harmonics?

    If the generation side of the point-of-common-coupling (PCC) is essentially an islanded setup consisting of a few specific generators, then the amount of harmonics resulting from the generation "source" can be readily identified in a mathematical fashion from the relative impedance on the generation side of the PCC compared to the combined impedance on the load side of the PCC. (The source of ...


    By GoHz Inc

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you