ASTM A623 - 11 standard specification for tin mill products, general requirements

0

Source: ASTM International

This specification covers a group of common requirements which shall be applied to tin mill products. The steel shall be made by the open-hearth, electric-furnace, or basic-oxygen process. The steel shall conform to the chemical composition requirements as specified. Tin mill products shall undergo Rockwell testing and shall be in accordance with specified requirements.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers a group of common requirements, which unless otherwise specified in the purchase order or in an individual specification, shall apply to tin mill products.

1.2 In case of any conflict in requirements, the requirements of the purchase order, the individual material specification, and this general specification shall prevail in the sequence named.

Note 1—A complete metric companion to Specification A623 has been developedSpecification A623M; therefore no metric equivalents are presented in this specification.

1.3 The following safety caveat covers Annex A3 through Annex A10 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
A987 Practice for Measuring Shape Characteristics of Tin Mill Products
D1125 Test Methods for Electrical Conductivity and Resistivity of Water
E18 Test Methods for Rockwell Hardness of Metallic Materials
E112 Test Methods for Determining Average Grain Size

U.S. Military Standards
MIL-STD-163 Steel Mill Products, Preparation for Marking and Storage

U.S. Federal Standard
FederalStd.No.123 Marking for Shipment (Civil Agencies)

Index Terms

tin mill products: Abbreviated ratio tables; Aerated media polarization (AMP) test; Alloy-tin couple (ATC) test; Chromium coatings--specifications; Diphenylcarbazide method; Dissolution rate; Iron solution value; Metallic coatings--specifications; Pickle lag test; Tin crystal size test; Tin mill products--specifications; Total surface oil;

ICS Code

ICS Number Code 77.140.50 (Flat steel products and semi-products)

DOI: 10.1520/A0623-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM A623 - 11 standard specification for tin mill products, general requirements. Be the first to comment!