ASTM International

ASTM B417 - 11 standard test Method for apparent density of non-free-flowing metal powders using the Carney funnel


Source: ASTM International

This test method provides a guide for evaluation of an important physical characteristic of a powder known as the apparent density. The measured apparent density bears a relationship to the mass of powder that will fill a fixed volume die cavity. The degree of correlation between the results of this test and the performance of powders during use may vary with each particular application. Note, however, that the presence of moisture, oils, stearic acid, stearates, waxes, and the temperature of the powder mass may alter the physical characteristics of the powder.

1. Scope

1.1 This test method covers a procedure for determining the apparent density of non-free-flowing metal powders. It is designed for those metal powders that do not freely flow through the Hall flowmeter funnel.

1.2 With the exception of the values for density and the mass used to determine density, for which the use of the gram per cubic centimeter (g/cm3) and gram (g) units is the longstanding industry practice, the values in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only, and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
B215 Practices for Sampling Metal Powders
B243 Terminology of Powder Metallurgy
B873 Test Method for Measuring Volume of Apparent Density Cup Used in Test Methods B 212, B 329, and B 417

Index Terms

apparent density; Carney; flowmeter funnel; metal powders;

ICS Code

ICS Number Code 77.160 (Powder metallurgy)

DOI: 10.1520/B0417-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM B417 - 11 standard test Method for apparent density of non-free-flowing metal powders using the Carney funnel. Be the first to comment!