ASTM B504 - 90(2011) standard test method for measurement of thickness of metallic coatings by the coulometric method

0

Source: ASTM International

Measurement of the thickness of a coating is essential to assessing its utility and cost.

The coulometric method destroys the coating over a very small (about 0.1 cm2) test area. Therefore its use is limited to applications where a bare spot at the test area is acceptable or the test piece may be destroyed.

1. Scope

1.1 This test method covers the determination of the thickness of metallic coatings by the coulometric method, also known as the anodic solution or electrochemical stripping method.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ISO Standard
ISO2177 Metallic Coatings--Measurement of Coating Thickness--Coulometric Method by Anodic Dissolution

Index Terms

Coating thickness; Coulometry--metallic materials; Surface analysis--electrodeposits/electroplating; Thickness--electrodeposited coatings;

ICS Code

ICS Number Code 17.040.20 (Properties of surfaces)

DOI: 10.1520/B0504-90R11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM B504 - 90(2011) standard test method for measurement of thickness of metallic coatings by the coulometric method. Be the first to comment!