ASTM B830 - 11 standard specification for uniform test methods and frequency

0

Source: ASTM International

This specification covers a standard basis for uniform testing and frequency to determine physical and electrical compliance for aluminum and copper conductors. Diameter, tensile, resistivity and all other material properties shall be tested per specific level and acceptable quality level (AQL) and must meet the corresponding requirements. Any lot of drawing stock/wire that has been sampled and from which the number of specimens failing to comply with the requirements does not equal or exceed the appropriate reject number of the sampling used, shall be considered as complying with requirements of ASTM. Rejected lots may be screened to remove nonconforming production units by testing one specimen form each production unit in the lot for the failing characteristic. Identify and classify product, process, and service characteristics for which statistical techniques will be used as basis for the assurance and control of quality and acceptance or rejection of lots. The process performance index (CPK) shall meet the requirements of the applicable ASTM standard.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers a standard basis for uniform testing and frequency to determine physical and electrical compliance for aluminum and copper drawing stock, and aluminum and copper conductors.

1.2 The values stated in inch-pound units are standard, with the exception of resistivity. The SI equivalents of inch-pound units may be approximate.

2. Referenced Documents (purchase separately)

Other Documents
CanadianStandardsAss CAN/CSA-ISO 9000-1-94 Quality Management Quality Assurance Standards Part 1: Guidelines for Selection and Use

ANSI Standards
ANSI/ASQC Z1.4-1993 Sampling Procedures and Tables for Inspection by Attributes

Index Terms

acceptable quality level (AQL); average outgoing quality (AOQ); control chart; lot; lower specification limit (LSL); process average; process control ratio (CPK); skip-lot inspection; statistical process control (SPC); upper specification limit (USL);

ICS Code

ICS Number Code 19.020 (Test conditions and procedures in general)

DOI: 10.1520/B0830-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM B830 - 11 standard specification for uniform test methods and frequency. Be the first to comment!