ASTM B951 - 11 Standard Practice for Codification of Unalloyed Magnesium and Magnesium-Alloys, Cast and Wrought

0

Source: ASTM International

This practice provides a system for the codification of unalloyed magnesium and magnesium alloys in the cast and wrought forms. Code designations shall be based on their chemical composition limits. For alloys, designations shall consist of not more than two letters representing the alloying elements specified in the greatest amount, followed by the respective percentages and a serial letter. The letters that represent the alloying elements are: A for aluminum; C for copper; E for rare earths; J for strontium; K for zirconium; L for lithium; M for manganese; Q for silver; S for silicon; T for tin; V for gadolinium; W for yttrium; and Z for zinc. For unalloyed metals, designations shall consist of the specified minimum purity, followed by a serial letter. For both cases, the full name of the base metal precedes the designation, but is omitted for brevity when the base metal being referred to is obvious.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This practice provides a system for designating unalloyed magnesium and magnesium-alloys that have been used commercially since 1952, and thus is intended to be the registration source for unalloyed magnesium and magnesium-alloys. A record of designations along with the established compositions is given in Table 2.

1.2 The equivalent Unified Numbering System (UNS) alloy designations shown in the appendixes are in accordance with Practice E527.

2. Referenced Documents (purchase separately)

ASTM Standards
B80 Specification for Magnesium-Alloy Sand Castings
B90/B90M Specification for Magnesium-Alloy Sheet and Plate
B91 Specification for Magnesium-Alloy Forgings
B92/B92M Specification for Unalloyed Magnesium Ingot and Stick For Remelting
B93/B93M Specification for Magnesium Alloys in Ingot Form for Sand Castings, Permanent Mold Castings, and Die Castings
B94 Specification for Magnesium-Alloy Die Castings
B107/B107M Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire
B199 Specification for Magnesium-Alloy Permanent Mold Castings
B403 Specification for Magnesium-Alloy Investment Castings
B843 Specification for Magnesium Alloy Anodes for Cathodic Protection
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

Index Terms

magnesium; UNS designations; Unalloyed magnesium; Wrought magnesium alloys; Cast magnesium alloys; Codification; Magnesium alloy castings; Magnesium alloys; Unalloyed magnesium; Wrought magnesium alloys; Cast magnesium alloys; Codification; Magnesium alloy castings; Magnesium alloys;

ICS Code

ICS Number Code 77.150.20 (Magnesium products)

DOI: 10.1520/B0951-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM B951 - 11 Standard Practice for Codification of Unalloyed Magnesium and Magnesium-Alloys, Cast and Wrought. Be the first to comment!