ASTM C1266 - 02(2011) Standard Test Method for Flow Characteristics of Preformed Tape Sealants

0

Source: ASTM International

Tape sealants are tacky, deformable solids, which are used under compression between two or more surfaces of similar or dissimilar substrates in a variety of sealing applications. These tapes are normally supplied in a roll form with a release paper interlever and are hand pressed against a fixed substrate. This procedure is designed to give an indication of the flow characteristics of a tape sealant under controlled temperature and aging conditions with a specified load.

1. Scope

1.1 This test method describes a laboratory procedure for determining the flow characteristics of preformed tape sealants after a specified time, temperature, and load.

1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are provided for information purposes only.

1.3 The committee with jurisdiction of this specification is not aware of any similar specification within ISO or any other organization.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
C717 Terminology of Building Seals and Sealants

Index Terms

flow; preformed tape sealant; rebound; tape; tape flow; Flow and flowrate--sealants; “Flow-out” behavior; Preformed sealant tapes

ICS Code

ICS Number Code 91.100.50 (Binders. Sealing materials)

DOI: 10.1520/C1266-02R11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM C1266 - 02(2011) Standard Test Method for Flow Characteristics of Preformed Tape Sealants. Be the first to comment!