ASTM D4049 - 06(2011) standard test method for determining the resistance of lubricating grease to water spray

0

Source: ASTM International

This test method is used to evaluate the ability of a grease to adhere to a metal surface when subjected to direct water spray. The results obtained from the use of this test method suggest correlation in operations involving direct water spray impingement such as steel mill roll neck bearing service. This test method is used for quality control and purchase specifications.

1. Scope

1.1 This test method covers the ability of a grease to adhere to a metal surface when subjected to a water spray under prescribed laboratory conditions.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
D217 Test Methods for Cone Penetration of Lubricating Grease
D1742 Test Method for Oil Separation from Lubricating Grease During Storage
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

Index Terms

grease; spray; water resistance; waterspray: Adhesion--petroleum products; Lubricating grease; Spray applications/testing; Water analysis--petroleum products testing; Water spray method;

ICS Code

ICS Number Code 75.100 (Lubricants, industrial oils and related products)

DOI: 10.1520/D4049-06R11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D4049 - 06(2011) standard test method for determining the resistance of lubricating grease to water spray. Be the first to comment!