ASTM International

ASTM D5741 - 96(2011) standard practice for characterizing surface wind using a wind vane and rotating anemometer


Source: ASTM International

This practice will characterize the distribution of wind with a maximum of utility and a minimum of archive space. Applications of wind data to the fields of air quality, wind engineering, wind energy, agriculture, oceanography, forecasting, aviation, climatology, severe storms, turbulence and diffusion, military, and electrical utilities are satisfied with this practice. When this practice is employed, archive data will be of value to any of these fields of application. The consensus reached for this practice includes representatives of instrument manufacturers which provides a practical acceptance of these theoretical principles used to characterize the wind.

1. Scope

1.1 This practice covers a method for characterizing surface wind speed, wind direction, peak one-minute speeds, peak three-second and peak one-minute speeds, and standard deviations of fluctuation about the means of speed and direction.

1.2 This practice may be used with other kinds of sensors if the response characteristics of the sensors, including their signal conditioners, are equivalent or faster and the measurement uncertainty of the system is equivalent or better than those specified below.

1.3 The characterization prescribed in this practice will provide information on wind acceptable for a wide variety of applications.

Note 1—This practice builds on a consensus reached by the attendees at a workshop sponsored by the Office of the Federal Coordinator for Meteorological Services and Supporting Research in Rockville, MD on Oct. 29–30, 1992.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
D1356 Terminology Relating to Sampling and Analysis of Atmospheres
D5096 Test Method for Determining the Performance of a Cup Anemometer or Propeller Anemometer
D5366 Test Method for Determining the Dynamic Performance of a Wind Vane

Index Terms

anemometer; fastest minute; peak gust; Sigma Theta; Sigma U; wind direction; wind speed; wind vane: Anemometers; Fastest minute; Peak gust; Rotating anemometers; Sigma Theta/U; Wind; Wind vane;

ICS Code

ICS Number Code 07.060 (Geology. Meteorology. Hydrology)

DOI: 10.1520/D5741-96R11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D5741 - 96(2011) standard practice for characterizing surface wind using a wind vane and rotating anemometer. Be the first to comment!