ASTM D5757 - 11 Standard Test Method for Determination of Attrition and Abrasion of Powdered Catalysts by Air Jets

0

Source: ASTM International

This test method is intended to provide information concerning the ability of a powdered catalyst to resist particle size reduction during use in a fluidized environment.

This test method is suitable for specification acceptance, manufacturing control, and research and development purposes.

1. Scope

1.1 This test method covers the determination of the relative attrition characteristics of powdered catalysts by means of air jet attrition. It is applicable to spherically or irregularly shaped particles which range in size between 10 and 180 m, have skeletal densities between 2.4 and 3.0 g/cm3 (2400 and 3000 kg/m3) (see IEEE/ASTM SI-10) and are insoluble in water. Particles less than 20 m are considered fines.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E456 Terminology Relating to Quality and Statistics
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

Index Terms

abrasion; air jet; attrition; fines; powdered catalysts;

ICS Code

ICS Number Code 71.040.30 (Chemical reagents)

DOI: 10.1520/D5757-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D5757 - 11 Standard Test Method for Determination of Attrition and Abrasion of Powdered Catalysts by Air Jets. Be the first to comment!