ASTM D6121 - 11 standard test method for evaluation of load-carrying capacity of lubricants under conditions of low speed and high torque used for final hypoid drive axles

0

Source: ASTM International

This test method measures a lubricant's ability to protect final drive axles from abrasive wear, adhesive wear, plastic deformation, and surface fatigue when subjected to low-speed, high-torque conditions. Lack of protection can lead to premature gear or bearing failure, or both.

This test method is used, or referred to, in the following documents:

American Petroleum Institute (API) Publication 1560.

STP-512A.

SAE J308.

Military Specification MIL-PRF-2105E.

SAE J2360.

1. Scope

1.1 This test method is commonly referred to as the L-37 test. This test method covers a test procedure for evaluating the load-carrying, wear, and extreme pressure properties of a gear lubricant in a hypoid axle under conditions of low-speed, high-torque operation.

1.2 This test method also provides for the running of the low axle temperature (Canadian) L-37 test. The procedure for the low axle temperature (Canadian) L-37 test is identical to the standard L-37 test with the exceptions of the items specifically listed in Annex A6. The procedure modifications listed in Annex A6 refer to the corresponding section of the standard L-37 test method.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3.1 Exceptions—In Table A9.1, the values stated in SI units are to be regarded as standard. Also, no SI unit is provided where there is not a direct SI equivalent.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning information is given in Sections 4 and 7.

2. Referenced Documents (purchase separately)

ASTM Standards
D235 Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

Military Specification
MIL-PRF-2105E Lubricating Oil, Gear, Multipurpose

AGMA National Standard
NomenclatureofGearTo

SAE Standard
SAEJ2360 Lubricating Oil, Gear Multipurpose (Metric) Military Use

Index Terms

abrasive wear; adhesive wear; bearing failure; final drive axle; gear; gear failure; hypoid axle; L-37; lubricants; surface fatigue;: Abrasive wear testing; Adhesive wear; Bearing failure; Final drive axle; Gear failure; Hypoid drive axles; Load-carrying capacity--lubricants; Lubricants; Lubricating oils; Surface fatigue; Torque--petroleum materials/applications;

ICS Code

ICS Number Code 75.100 (Lubricants, industrial oils and related products)

DOI: 10.1520/D6121-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D6121 - 11 standard test method for evaluation of load-carrying capacity of lubricants under conditions of low speed and high torque used for final hypoid drive axles. Be the first to comment!