ASTM D7253 - 06(2011)e1 standard test method for polyurethane raw materials: determination of acidity as acid number for polyether polyols

0

Source: ASTM International

This test method is suitable for quality control, as a specification test, and for research. Acid numbers indicate the extent of any neutralization reaction of the polyol with acids. The results of this method measure batch-to-batch uniformity and are used as correction factors in calculating true hydroxyl numbers.

1. Scope

1.1 This test method measures the acidic constituents in polyether polyols and reports the results as acid number. The typical acid number range is 0-0.1 mg KOH/g sample. (See Note 1.)

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard.

2. Referenced Documents (purchase separately)

ASTM Standards
D883 Terminology Relating to Plastics
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

Index Terms

acidity; acid number; hydroxyl number; polyether polyols: Polyether polyols; Polyurethane raw materials; Acidity, alkalinity, pH; Acid numbe;

ICS Code

ICS Number Code 19.020 (Test conditions and procedures in general); 83.040.01 (Raw materials for rubber and plastics in general)

DOI: 10.1520/D7253-06R11E01

ASTM International is a member of CrossRef.

ASTM D7253 - 06(2011)e1 standard test method for polyurethane raw materials: determination of acidity as acid number for polyether polyols

This test method is suitable for quality control, as a specification test, and for research. Acid numbers indicate the extent of any neutralization reaction of the polyol with acids. The results of this method measure batch-to-batch uniformity and are used as correction factors in calculating true hydroxyl numbers.

1. Scope

1.1 This test method measures the acidic constituents in polyether polyols and reports the results as acid number. The typical acid number range is 0-0.1 mg KOH/g sample. (See Note 1.)

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this standard.

2. Referenced Documents (purchase separately)

ASTM Standards
D883 Terminology Relating to Plastics
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

Index Terms

acidity; acid number; hydroxyl number; polyether polyols: Polyether polyols; Polyurethane raw materials; Acidity, alkalinity, pH; Acid numbe;

ICS Code

ICS Number Code 19.020 (Test conditions and procedures in general); 83.040.01 (Raw materials for rubber and plastics in general)

DOI: 10.1520/D7253-06R11E01

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D7253 - 06(2011)e1 standard test method for polyurethane raw materials: determination of acidity as acid number for polyether polyols. Be the first to comment!