ASTM International

ASTM D7307 - 06(2011) standard practice for sampling of thermoplastic traffic marking materials


Source: ASTM International

It is important to obtain a truly representative sample of the thermoplastic traffic marking material prior to performing any tests. This can be difficult due to the wide ranges of sizes, shapes, and densities of the individual components that are used in the manufacture of these types of materials. The sample that is obtained using this guide should be representative of the manufactured lot from which it was obtained and can be used for the testing of the chemical and physical properties of the material as required by the governing specification.

1. Scope

1.1 This practice covers the proper field sampling of thermoplastic traffic marking materials to ensure test results are representative of the material being tested.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
D346 Practice for Collection and Preparation of Coke Samples for Laboratory Analysis
D2013 Practice for Preparing Coal Samples for Analysis

Index Terms

sampling; thermoplastic traffic markings Thermoplastic traffic marking material;

ICS Code

ICS Number Code 93.080.30 (Road equipment and installations)

DOI: 10.1520/D7307-06R11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D7307 - 06(2011) standard practice for sampling of thermoplastic traffic marking materials. Be the first to comment!