ASTM International

ASTM D7575 - 11 standard test method for solvent-free membrane recoverable oil and grease by infrared determination


Source: ASTM International

The presence and concentration of oil and grease in domestic and industrial wastewater is of concern to the public because of its deleterious health, environmental, safety, and aesthetic effects.

Regulations and standards have been established that require monitoring of oil and grease in water and wastewater.

Note 1—Different oil and grease materials may have different infrared absorptivities. Certain materials, such as synthetic silicone-based or perfluorinated oils, may have absoptivities inconsistent with those of naturally occurring oil and grease materials. Caution should be taken when testing matrices suspected of containing proportions of these materials. In such cases, laboratory spike samples, laboratory check samples, equivalency testing, or combinations thereof, using these materials in question may be appropriate.

1. Scope

1.1 This test method covers the determination of oil and grease in produced and waste water samples over the concentration range outlined in Table 1 that can be extracted with an infrared-amenable membrane and measured by infrared transmission through the membrane.

1.2 This method defines oil and grease in water as that which is extractable in the test method and measured by infrared transmission.

1.3 The method detection limit (MDL) and recommended reporting range are listed in Table 1.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

TABLE 1 MDL and Reporting Range
Analyte: MDLA (mg/L): Reporting RangeA (mg/L)
Oil and Grease: 1.0: 5–200

A MDL and recommended reporting range determined by Section 12.4, which follows the Code of Federal Regulations, 40 CFR Part 136, Appendix B; limits should be determined by each operator.

2. Referenced Documents (purchase separately)

ASTM Standards
D1129 Terminology Relating to Water
D1193 Specification for Reagent Water
D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water
D5847 Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis
E168 Practices for General Techniques of Infrared Quantitative Analysis
E178 Practice for Dealing With Outlying Observations

EPA Standards

Index Terms

dispersive infrared; filtometric infrared; FTIR; grease; infrared transmission; oil; solid phase extraction; spectroscopy; water: FTIR analysis; Industrial wastewater applications; Infrared (IR) analysis--water; Recoverable elements (from water); Spectroscop ;

ICS Code

ICS Number Code 13.060.50 (Examination of water for chemical substances)

DOI: 10.1520/D7575-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D7575 - 11 standard test method for solvent-free membrane recoverable oil and grease by infrared determination. Be the first to comment!