ASTM International

ASTM D808 - 11 standard test method for chlorine in new and used petroleum products (High Pressure Decomposition Device Method)


Source: ASTM International

This test method may be used to measure the level of chlorine-containing compounds in petroleum products. This knowledge can be used to predict performance or handling characteristics of the product in question.

This test method can also serve as a qualitative tool for the presence or non-detection of chlorine in petroleum products. In light of the efforts in the industry to prepare chlorine free products, this test method would provide information regarding the chlorine levels, if any, in such products.

1. Scope

1.1 This test method covers the determination of chlorine in lubricating oils and greases, including new and used lubricating oils and greases containing additives, and in additive concentrates. Its range of applicability is 0.1 to 50 m% chlorine. The procedure assumes that compounds containing halogens other than chlorine will not be present.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 The preferred units are mass percent.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Attention is called to specific warning statements incorporated in the test method.

2. Referenced Documents (purchase separately)

ASTM Standards
D1193 Specification for Reagent Water
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
D6299 Practice for Applying Statistical Quality Assurance and Control Charting Techniques to Evaluate Analytical Measurement System Performance

Index Terms

chlorine; high pressure decomposition device: Chlorine content--petroleum products; Combustion--petroleum products; Lubricating grease; Lubricating oils; Oxygen bomb method; Used lubricating oils; Bomb methods;

ICS Code

ICS Number Code 75.080 (Petroleum products in general)

DOI: 10.1520/D0808-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM D808 - 11 standard test method for chlorine in new and used petroleum products (High Pressure Decomposition Device Method). Be the first to comment!