ASTM F1914 - 07(2011) standard test methods for short-term indentation and residual indentation of resilient floor covering

0

Source: ASTM International

The indentation and the residual indentation of resilient floor covering is important since the resistance and recovery from indentation reflects on the ability of the resilient floor covering to perform properly after installation.

The indentation of a resilient floor covering shall be measured using a specified type of indentor, flat or spherical, under a specified load and time.

The residual indentation of a resilient floor covering shall be measured after a specified recovery time.

See Table 1 for detailed testing and conditioning requirements by products (specification) type.

1. Scope

1.1 This test method covers procedures to determine short-term indentation and residual indentation of resilient flooring, when subjected to concentrated loads.

1.2 The test methods appear in the following order:

Section
Indentation by McBurney Test: 4 to 10
Indentation and Residual Indentation: 11 to 15

1.3 There are two procedures with their respective apparatus. The first (McBurney Test) is described in Sections 4 to 10 and is restricted to a spherical foot. It is only used for initial indentation measurements of VCT. The second is described in Sections 11 to 15 and has interchangeable feet with variable geometry. It is used to measure initial and residual indentation.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
E2251 Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids
F141 Terminology Relating to Resilient Floor Coverings
F1066 Specification for Vinyl Composition Floor Tile
F1303 Specification for Sheet Vinyl Floor Covering with Backing
F1700 Specification for Solid Vinyl Floor Tile
F1913 Specification for Vinyl Sheet Floor Covering Without Backing

Index Terms

indentation; McBurney; resilient flooring; residual indentation;

ICS Code

ICS Number Code 97.150 (Non-textile floor coverings)

DOI: 10.1520/F1914-07R11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM F1914 - 07(2011) standard test methods for short-term indentation and residual indentation of resilient floor covering. Be the first to comment!