ASTM F2329 - 11 standard specification for zinc coating, hot-dip, requirements for application to carbon and alloy steel bolts, screws, washers, nuts, and special threaded fasteners

0

Source: ASTM International

This specification covers the requirements for hot-dip zinc coating applied to carbon steel and alloy steel bolts, screws, washers, nuts, and special threaded fasteners applied by the hot-dip coating process. The zinc used for the coating shall conform to the chemical composition required. The following tests shall be made to ensure that the zinc coating is being furnished in accordance with this specification: coating thickness; finish and appearance; embrittlement test; and adhesion test.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers the requirements for hot-dip zinc coating applied to carbon steel and alloy steel bolts, screws, washers, nuts, and special threaded fasteners applied by the hot-dip coating process. Nails and rivets are not included in this specification.

1.2 It is intended to be applicable to fasteners that are centrifuged or otherwise handled to remove excess galvanizing bath metal (free zinc).

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)

ASTM Standards
A153/A153M Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware
A563 Specification for Carbon and Alloy Steel Nuts
B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section
E376 Practice for Measuring Coating Thickness by Magnetic-Field or Eddy-Current (Electromagnetic) Examination Methods
F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
F1789 Terminology for F16 Mechanical Fasteners

Index Terms

coatings, zinc; galvanized coatings; steel zinc coated; steel fastener products, metallic coated; zinc coating fastener products; Carbon; Alloy steel; Fasteners; Hot-dip processed coatings; Zinc coatings;

ICS Code

ICS Number Code 25.220.40 (Metallic coatings)

DOI: 10.1520/F2329-11

ASTM International is a member of CrossRef.

Customer comments

No comments were found for ASTM F2329 - 11 standard specification for zinc coating, hot-dip, requirements for application to carbon and alloy steel bolts, screws, washers, nuts, and special threaded fasteners. Be the first to comment!