Auto shifting filter press commissioning
Fiter press with auto shifting and drip tray, belt conveyor installation and commissioning .
There are some reminders before starting the filter press friend:
- People must not stand in front of the filter press hydraulic cylinder.
- For the first time,pls set the pressure gage max 10 Mpa to test if the filter press will stop or not when it reachs this pressure, if it don’t stop, pls stop manually immediately and check the problem. after it goes well then set it to up limit 18 Mpa and lower limit 16 Mpa.
- Max feeding pressure is 0.6 Mpa (6 bar ) and max feeding capacity is 3 m3/hour.
- After you add hydraulic oil in the hydraulic station ,for the first time, pls loose the screws or the pressure guage a little to the the air goes out then fasten the screw again.
- There are limits for every next operation, ie only when the head plate (the close plate) hit the limit switch, then the auto pulling plates function will work, if not, the next procedure will not give react when press the buttons.
The auto pulling plate function is usually equipped with big filtering area filter press, it is very convenient for opening the filter plate to discharge the cake. The auto pulling plate is controlled by PLC cabinet, that can save time improve the filtrate efficient.