SBM Construction

How to maintain the sand making machine equipment in winter?

Source: SBM Construction

How to maintain the sand making machine equipment in winter?

The sand making machine is the main crushing equipment in the sand and gravel production line, and the loss is also very large. Many customers have doubts about the wear of the sand making machine, and it is suspected that it is a quality problem of the sand making machine. Some are caused by improper use during use. Only by paying attention to the maintenance and maintenance of the sand making machine can the sand making machine fully play its role, prolong the service life of the sand making machine equipment, and solve the problem of tight sand and stone materials more effectively. . The following SBM Heavy Industry introduces the maintenance and maintenance of the sand making machine.
The bearings of the sand making equipment are the most prone to wear, and the parts bear most of the load when the equipment is in operation. Therefore, we need to use good lubricants in our work, and keep them clean at all times. If the lubricating oil is not clean, it will increase the wear between bearings, bearings and other parts. In addition, it should be noted that the bearing cannot be overheated, and the overheating will cause the running efficiency of the bearing to decrease, which will affect the normal operation of the equipment. The transmission of the sand making machine equipment, the V-belt should be properly adjusted to ensure that the V-belt is evenly stressed. When driving with a dual motor, it should be properly distributed and the same strength. Maintenance of the transmission gear, long-term friction loss between the transmission gear will also affect the life of the machine. Lubricants used in response to previous bearing problems are also an important one. After using for a period of time, the hatch should be opened to see the inside of the sand making machine, the silo, the lining of the impeller, the wear level of the wear-resistant material, if it is found that the wear should be replaced in time to ensure the work of the sand making machine effectiveness.