Is It Time To Upgrade Your Water Treatment Plant? 4 Signs To Tell
Has your water treatment plant been misbehaving lately? Is it not producing the desired results for quite some time now? Have you been noticing some strange behavior from the machine, slow output rate, and poor water quality? If so, it’s likely that your current equipment has worn out and it might need an upgrade.
Water filtration systems undergo several changes and also become overwhelmed by the volume and the type of water they’re asked to clean. But, when it comes to upgrading it, you cannot really tell. Well, to save you from all the dilemma, we have listed 4 signs which will help you determine the same. Hopefully, this will help clear your heads, so read on!
If your system is stalling, pumping water slowly, or producing cloudy or discoloured water, then you must steer clear! It is likely that your machines may be taking on more water than they can handle. This implies that overloading prevails. It can happen with both wastewater and feed water processing.
If new tanks or machinery which draws on a filtration source have been added to an existing system without more filtration capacity being installed, you might witness overloading. This can be a sign of a system that needs part replacement, filter change, or maintenance as a dirty or contaminated system reduces flow.
In such a case, you can try lowering the rate of input, reducing water pressure, or installing more processing equipment. Moreover, it is always recommended to have a good preventative maintenance schedule in place (including a set schedule for changing the filters in reverse osmosis machinery) as it can help you avoid blockages and overloading.
Poor water quality and strange odours
Does your processed water produce strange odours like that of sulphur or chemical waste? This can be a warning sign! It means that your system is clogged internally or that the machine is not processing water in the manner it should. Polluted wastewater which becomes jammed or stuck can be stagnant, running the risk of a bacterial infection. It can also be a sign that something is leaking into your pipework which shouldn’t.
In addition, if your water reaching the end of the filtration process is cloudy or still full of particles, you should definitely contact a water treatment company and look at having your machinery serviced or replaced.
If the pump of your water treatment plant fails to turn on, it may be an indication of an electrical fault. In such a case, check the breakers and fuses to see that your electrical grid isn’t overloaded or broken. On the contrary, do conduct a check that your facility is properly ventilated and cooled because overheating can trip safety mechanisms designed to stop machines from turning on.
Alarms and Indicators
Today, most filtration systems come equipped with digital monitors and sensors to tell you whenever something is wrong with the equipment. If the alarm trips, do take note of where and what the system trying to indicate is wrong.
Is it the right time to invest in a new water treatment plant?
In addition to looking for any of the aforementioned signs, do make sure to follow this ultimate guide for determining when to replace your water treatment plant.
Determine the current speed, productivity and effectiveness of your system in terms of cost per gallon.
Subtract additional expenses from downtime, maintenance and repairs. By doing this, you will get a real figure of how much your system is costing compared to the benefits of sustaining it.
Compare this figure to the efficiency of a new water purification plant while bearing in mind that a new equipment will require far less maintenance expense.
Analyse the calculated difference between the two figures and decide whether the initial investment is worth the expense.
In most cases, businesses receive a positive ROI when replacing an obsolete equipment which is set to give better future returns in terms of productivity.
Site Link: https://www.tastefulspace.com/blog/2019/10/28/upgrade-your-water-treatment-plant/