dry separation News

  • Innovative Dry Separation/De Dusting Technology of Aggregates waste streams

    Oy Cyclotec Ltd Reports introduction of innovative Dry Separation/De Dusting Technology of Aggregates waste streams previously not attractive for recycling. Up to date due to waste fines contamination most of the fraction smaller then 5-6 mm is not used. Dry screening at 5-6 mm and smaller fractions is not efficient. Wet de dusting methods ...


    By Cyclotec Oy

  • ANDRITZ SEPARATION to supply drying equipment for biosolids recovery plant in California, USA

    International technology Group ANDRITZ has received an order from Kore Infrastructure to supply a paddle dryer for a biosolids recovery plant currently under construction in Rialto, California, USA. In the plant, biosolids from wastewater facilities in Los Angeles and which have normally gone to landfill will be converted into biodiesel and biochar. Start-up is scheduled for the second quarter of ...

  • BATTERY RECYCLING, DRY CELL

    Rabbitt Recycling has launched a battery collection scheme in the UK to collect dry cell batteries for recycling.  This is a patented shredding/separation process, which produces separated metal compounds ideal for the Nickel and Cobalt refining industries.  In the UK this scheme is highly competitive, and in cases where there are segregated quantities of Nickel and Lithium batteries ...


  • High and dry through the Gotthard tunnel

    After 20 years of planning and construction, Switzerland celebrates the completion of the Gotthard Base Tunnel. At 57 kilometers, it’s the world’s longest railroad tunnel. 2,300 meters of solid rock rises above the new line at its deepest point. The construction must not only withstand extreme mountain pressure but also substantial volumes of mountain water must be prevented from ...


    By Endress Hauser

  • Separation Technologies LLC expands to Asia

    Officials at Separation Technologies LLC (ST) announced that they have finalized an agreement for the purchase and installation of a fly ash beneficiation unit at the Yeongheung Power Station by Korea South-East Power Co., Ltd. (KOSEP), a subsidiary of Korea Electric Power Corporation (KEPCO). KEPCO is the largest electric utility in Korea, responsible for 93% of ...


    By Separation Technologies LLC.

  • Efactor3 to offer plastics washing, drying system

    The DRD drying and cleaning system from MAS, which will be available in the United States through Efactor3 LLC, Charlotte, N.C., was introduced during the NPE 2009 event in Chicago in June. MAS (Maschinen- und Anlagenbau Schulz GmbH of Austria) says its dry cleaning system “is a well-proven alternative to water washing plants for plastic recycling.” Cleaning is carried out by the DRD (Double ...


    By eFACTOR3 LLC

  • Foreign Bodies in Food – Magnetic Separation

    With the increasing pressure to ensure that food standards comply with government guidelines and producers provide consumers with optimum quality products, the Magnetic Separation process plays a vital role in removing ferromagnetic and paramagnetic particles ...


    By Eriez Magnetics Europe Ltd

  • Efficient exhaust air purification for drying and painting processes

    Dürr Environmental and Energy Systems optimizes exhaust air purification for the automotive industry and perfectly coordinates it with the latest drying and painting processes. Painting and drying of car bodies produce gaseous pollutants that have to be removed from the air depending on the paint system and statutory requirements. Recuperative incinerators, e.g. the Ecopure TAR from ...

  • Dry soils exacerbated 2006 heatwave in Northern France

    Dry soils and a lack of cloud cover help explain a major heatwave in France, concludes new research. The study indicates that the two drivers were separate, unlinked events that came together at the same time to worsen the 2006 heatwave. Its findings could allow heatwaves to be predicted more accurately to protect public health. Understanding and predicting heatwaves is increasingly important for ...

  • Fast track to magnetic separation equipment

    Eriez Europe, a leading authority in magnetic technologies, based in South Wales, UK is delighted to announce the launch in Europe of the Eriez Xpress programme providing fast shipment on the most common magnetic separation equipment in the industry.  The new Eriez Xpress programme will enable for faster processing of customer requirements. Gareth Meese, sales director at Eriez Europe ...


    By Eriez Magnetics Europe Ltd

  • ANDRITZ to upgrade Flash Drying for Rottneros Bruk AB, Sweden: Drying capacity increase of more than 50%

    International technology Group ANDRITZ has received an order from Rottneros Bruk AB to upgrade the CTMP pulp drying line at its Rottneros mill, Sweden. After the modernization, the Flash Dryer’s capacity will be increased by more than 50% while at the same time specific heat consumption will be reduced. Start-up is scheduled for the fourth quarter of 2016. ANDRITZ will deliver a customized ...

  • Magnetic Separator Technology Minimizes Compressor Downtime

    Removing Buffer Gas Contamination will reduce Seal FailureMagnetic separator technology is the key to minimizing compressor downtime. Over 80% of centrifugal gas compressors manufactured today are equipped with dry gas seals. Dry gas seals are a non-contact seal with a running gap between the primary and mating seal rings of approximately 3 to 4 microns. Buffer gas is used as a sealing and ...


    By One Eye Industries Inc.

  • New Monster Separation System™ Technology Added

    Costa Mesa, CA – Wastewater facility managers and consulting engineers now have a single source for high quality screens, compactors and grit removal equipment. JWC Environmental’s Monster Separation System can now incorporate a highly-reliable vortex grit removal system named Grit Monster™, or a robust bar screen called Catenary Monster™. JWC signed an agreement this week with Mabarex Inc. of ...


    By JWC Environmental

  • Environment Agency to confirm separate collection legislation in UK

    As set out under the Waste (England and Wales) Regulations, the Environment Agency is concluding a briefing note to stakeholders which will outline how it is likely to oversee the separate collection of recyclable materials as of this month. Under the new regulations which came into effect on the 1st of January 2015, the separate collections of paper, metal, plastic and glass for household and ...


    By GPT Waste Management Ltd

  • Two innovation awards for Dürr`s eco-friendly dry scrubber system

    Dürr has received two awards simultaneously for its new, energy-saving EcoDryScrubber paint booth system. Baden-Württemberg's Environment Minister Tanja Gönner honored Dürr in the category 'Technologies for Emission Reduction, Treatment and Separation' in the state's first-ever Environmental Technology Awards on June 24. At the international automotive paint finishing congress SURCAR, too, the ...

  • Agilent Technologies Introduces New Dry Scroll Vacuum Pump for Range of Applications

    Agilent Technologies Inc. (NYSE: A) today introduced the IDP-15 Dry Scroll Pump, featuring a hermetic, isolated design. With a 60 Hz pumping speed of 15.4 cubic meters per hour, the IDP-15 provides rapid pump-down and is ideal for use in academic, research, ...


    By Agilent Technologies, Inc.

  • ANDRITZ SEPARATION launches new filter cloth fastening system SmartFIX

    ANDRITZ SEPARATION, part of international technology Group ANDRITZ, has developed a new innovative filter cloth fastening system. SmartFIX combines a set of resilient, endless tension strips with an endless polymer filter cloth specially designed for the strips and is designed to replace the existing clamping ring assemblies in most types of filter centrifuges. The advantages are a reduction in ...

  • Baker Hughes introduces the next generation of fluids separation technologies

    Baker Hughes announced today the commercial release of its TRETOLITE™ SNAP fluids separation technologies, designed to help oil and gas operators maintain dry oil and good water quality, while also stabilizing operations and reducing costs—without limiting production—to improve overall ...


    By Baker Hughes

  • ASTM C179 - 11 standard test method for drying and firing linear change of refractory plastic and ramming mix specimens

    This test method is useful in quantitatively rating or ranking both ramming and refractory plastics by their linear stability after heating. This test method is also useful for determining whether a ramming or refractory plastic can be used in a specified application based on linear change criteria. This test method excludes basic and carbon ...


    By ASTM International

  • ASTM C387 / C387M - 11a standard specification for packaged, dry, combined materials for mortar and concrete

    This specification covers the production, properties, packaging, and testing of packaged, dry, combined materials for concrete and mortars. Concrete mixtures covered by this specification includes high-early strength concrete, normal strength concrete, normal weight concrete, high-strength mortar, and mortars for unit masonry. The purchaser shall specify the material desired as ...


    By ASTM International

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you