gas turbine exhaust News

  • Improve Gas Turbine Engine Reliability with Cool Valves and Piping

    Presentations and discussion at meetings of the gas-turbine users groups, such as the 7F, often call into view problems owner/operators are having with the liquid-fuel systems on their dual-fuel engines—in particular, unreliable starts and unreliable fuel transfers from gas to oil. A couple of years ago, the sure solution for some users rarely called to operate on oil was to disable or ...

  • GE Wins Largest Gas Turbine Combined-Cycle Order in India

    Contracts over $750 Million for 2,400-Megawatt Samalkot Power Plant Expansion. Reliance Power Ltd. of India has selected GE’s (NYSE: GE) flexible, efficient power generation technology for a 2,400-megawatt expansion of the Samalkot power plant in the state of Andhra Pradesh, India. This will represent the largest gas turbine combined-cycle project in India’s history and ...


    By General Electric

  • ASTM D7422 - 11 standard test method for evaluation of diesel engine oils in T-12 exhaust gas recirculation diesel engine

    This test method was developed to evaluate the wear performance of engine oils in turbocharged and intercooled four-cycle diesel engines equipped with EGR and running on ultra-low sulfur diesel fuel. Obtain results from used oil analysis and component measurements before and after test. The test method may be used for engine oil specification acceptance when all details of ...


    By ASTM International

  • ASTM D6987 / D6987M - 11 standard test method for evaluation of diesel engine oils in t-10 exhaust gas recirculation diesel engine

    This test method was developed to evaluate the wear performance of engine oils in turbocharged and intercooled four-cycle diesel engines equipped with EGR. Obtain results from used oil analysis and component measurements before and after the test. The test method may be used for engine oil specification acceptance when all details of the procedure are followed. ...


    By ASTM International

  • GE’s Frame 6FA gas turbines to help meet growing power needs of Sabah, Malaysia

    GE (NYSE: GE) will supply three Frame 6FA gas turbines, associated generators and services for the 300-megawatt combined cycle gas-fired power plant project in Sabah, Malaysia. Using natural gas as its primary fuel, the new plant will reinforce Sabah’s energy infrastructure and help the state meet its growing electricity demand, which is increasing by more than 7 percent annually. The ...

  • Turbine Truck Engines Announces Return to OTCBB

    Turbine Truck Engines, Inc. ("TTE") (OTCBB: TTEG), announced the Company's stock quotation coverage has moved from the OTC Markets Group, Inc.'s OTCQB to the Financial Industry Regulatory Authority (FINRA) operated OTC Bulletin Board (OTCBB) under the same symbol "TTEG." The OTCBB is a regulated quotation service that displays real-time quotes, last-sale prices, and volume information in ...


  • DOE Selects Ten Projects to Conduct Advanced Turbine Technology Research

    Ten university projects to conduct advanced turbine technology research under the Office of Fossil Energy’s University Turbine Systems Research (UTSR) Program have been selected by the U.S. Department of Energy (DOE) for additional development. Developing gas turbines that run with greater cleanness and efficiency than current models is of great benefit both to the environment and the power ...


    By US Department of Energy

  • GE Partners with Nanjing Turbine Company to supply technology for new industrial cogeneration plant in China

    GE (NYSE: GE) and its technology partner, Nanjing Turbine & Electric Machinery Company, Ltd., (NTC), will supply two 6F 3-series gas turbines to Chinese power company Guodian Dianli for the Nanxun power plant near Huzhu city in Zhejiang province, China. The new cogeneration plant will provide electricity ...


    By General Electric

  • Hired emissions analyser checks gas rig in Burma

    Following the installation of a turbine on a natural gas rig off the coast of Burma, it was necessary for Siemens Industrial Turbomachinery Ltd (SITL) to analyse emissions from the turbine and a hired Testo 350 XL emissions analyser from Ashtead Technology proved ideal for the application. Based in Lincoln, SITL designs, manufactures, installs and provides life time support for gas turbines used ...


    By Ashtead Technology Ltd

  • A greener way to get electricity from natural gas

    A new type of natural-gas electric power plant proposed by MIT researchers could provide electricity with zero carbon dioxide emissions to the atmosphere, at costs comparable to or less than conventional natural-gas plants, and even to coal-burning plants. But that can only come about if and when a price is set on the emission of carbon dioxide and other greenhouse gases — a step the U.S. ...

  • FTIR gas analyser supports carbon capture research

    The development of carbon capture and storage (CCS) technologies relies on the accurate measurement of carbon dioxide (CO2) in addition to a wide array of other gases because it is vitally important that the process does not impact upon the emissions of other greenhouse gases and potential pollutants. An advanced FTIR multiparameter gas analyser from Gasmet Technologies is therefore being ...


    By Gasmet Technologies Oy

  • EPA Finalizes Greenhouse Gas Permit for Tenaska Brownsville Generating Plant

    Today, the U.S. Environmental Protection Agency (EPA) issued a final greenhouse gas (GHG) Prevention of Significant Deterioration (PSD) construction permit to Tenaska Brownsville Partners L.P., to construct a natural gas-fired electric generating plant. The Tenaska Brownsville Generating Plant will be located in Brownsville, Cameron County, Texas. “Tenaska’s project takes advantage of ...

  • Burying the climate change problem: greenhouse gas carbon dioxide

    Burying the greenhouse gas carbon dioxide, a byproduct of burning fossil fuels, has been mooted as one geoengineering approach to ameliorating climate change. To be effective, trapping the gas in geological deposits would be the for the very long term, thousands of years. Now, a team in Brazil, writing in the International Journal of Global Warming has reviewed the risk assessments for this ...


    By Inderscience Publishers

  • Carbon capture and storage is imperative to UK gas strategy, says GL Noble Denton executive Vice President at industry lecture

    Carbon capture and storage techniques will become imperative to UK energy generation, as gas becomes the country’s energy game-changer, according to Arthur Stoddart, Executive Vice President at GL Noble Denton. Speaking at Gas in a Low Carbon World, a renowned industry lecture commemorating the life of former British Gas chairman Sir Dennis Rooke, Stoddart suggested that there has been a ...


  • 4 Continuous Emission Monitoring Systems for Egypt

    The GIZA NORTH Power Plant consists of two modules: each module configured in a 2x2x1 arrangement with two Combustion Turbine Generators (CTGs), two Heat Recovery Steam Generators (HRSGs) and one Steam Turbine Generator (STG). Each module has a rated nominal capacity of 750 MW. Scope of supply: 4 (four) CEMS/Shelters, comprising each a MIR9000 with CLD option, an MVS switching system, 2 SEC ...


    By Environnement S.A

  • contec was successfully presented the new COMS at the TPS 2016

    contec Oil Mist Separators (COMS)/Oil Mist Eliminators for the extraction and filtration of oil mist are used for large-scale compressors, gas and steam turbines, generators and other equipment with oil systems to ensure clean, oil-free exhaust air. 99.98 % of solid and liquid particles and aerosols down to 0.1 micron are removed and high-quality oil can be regained. This prevents the leakage of ...

  • Capstone CNG microturbine certified to CARB 2010 for HDDE Urban Bus

    Capstone Turbine Corporation, a clean technology manufacturer of microturbine energy systems, has released configurations of the C30 compressed natural gas (CNG) microturbine that meet or exceed emissions standards, including the U.S. Environmental Protection Agency and California Air Resources Board (CARB) 2010 requirements for On-Road Heavy Duty Diesel Engines (HDDE) for Urban Bus. Test ...


  • contec was successfully presented the new COMS at the TPS 2016

    contec Oil Mist Separator (COMS) type 8.000/762-G08 was successfully presented the new COMS at the TPS 2016 in Houston/USA. contec Oil Mist Separators (COMS)/Oil Mist Eliminators for the extraction and filtration of oil mist are used for large-scale compressors, gas and steam turbines, generators and other equipment with oil systems to ensure clean, oil-free exhaust air. 99.98 % of solid and ...

  • contec Oil Mist Separator (COMS) type 8.000/762-G08 is installed at Noor III project

    The 150 MW Noor III CSP project is a greenfield IPP to be developed as the third project for the Moroccan Agency for Solar Energy (MASEN) in a series of several planned developments at the Ouarzazate Solar Complex. NOOR 3 is a CSP tower, with a capacity of 150 MW and 7 hours of storage. contec Oil Mist Separators (COMS)/Oil Mist Eliminators for the extraction and ...

  • Increase reliability and performance with New JASC products

    It’s So Cool All New Water-Cooled 3-Way Purge Valve The JASC Water-Cooled Three-Way Purge Valve was engineered to prevent liquid fuel coking that typically occurs when valves are exposed to heat for extended periods of time while the turbine is operating on gas fuel. JASC’s new and improved Water-Cooled Three-Way Purge Valve features extensive internal cooling ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you