sample gas filter News

  • New high performance sample gas cooler

    Bühler Technologies, a leading manufacturer of high quality accessories and systems for the gas analysis, is introducing the PKE 52, a new series of high performance peltier coolers. Depending on the selected heat exchanger, the gas flow can go as high as 500l/h per single stream, or up to 2x 250 l/h per dual stream even under harsh ambient conditions. Analogue to the well known PKE 5 ...


    By Bühler Technologies GmbH

  • New sample gas probe for operating temperatures up to 280°C

    In the process of extractive gas analysis, it is essential to stabilise the operating temperature of the sample stream above a certain level. If the sample gas would undercut these limits, acids could fall out or chemical reactions could take place, e.g. salt or other crystals may be formed. Unexpected acid condensate could increase the corrosive property of the gas or the precipitation of solids ...


    By Bühler Technologies GmbH

  • Panasonic Begins Shipping Samples of New Catalyst for Diesel Exhaust Gas Purification

    Osaka, June 22, 2010 - (ACN Newswire) - Panasonic Corporation announced today it has succeeded in the development of a new catalyst using an alkali metal compound to decompose and purify particulate matter in diesel engine exhaust gas[1], and has begun shipping its samples this month. As diesel emission regulations have become increasingly stringent, particularly in Japan, the US, and Europe, ...


    By Japan Corporate News - JCN

  • Extractive solution for measuring gas

    The monitor is easy to install, with a compact and strategic design made to fit in 19 inch racks. No other operations other than power supply, sample gas tubes and optional purge are required during installation. LaserGas R2P is optimized for extractive measurements in controlled environments. These kinds of measurements are typically used within chemical industry, petrochemical industry, ...


    By NEO Monitors AS

  • Extractive solution for measuring gas

    NEO Monitors launches their new turn-key extractive monitor, LaserGas R2P. The unit serves as sender and receiver of information for measuring gas and eliminates the need for two stacks. The monitor is easy to install, with a compact and strategic design made to fit in 19 inch racks. No other operations other than power supply, sample gas tubes and optional purge are required during ...


    By NEO Monitors AS

  • New advances in air sampling and air flow calibration instruments

    F&J SPECIALTY PRODUCTS, INC. (F&J) has enhanced the usefulness of its “Digital Flowmeter” air sampling systems. F&J has implemented hardware and software modifications that enable a user to select either the reporting of (1) internationally recognized reference temperature (T) and pressure (P) conditions for gas volume values or (2) flow and volume values at local ambient conditions of barometric ...


    By F&J SPECIALTY PRODUCTS, INC.

  • Biogas analyser enhanced with multi-sample points and low-to-high range H2S

    The latest static biogas analyser for Geotech, the GA3000 PLUS, can now optionally monitor up to three sample points and hydrogen sulphide (H2S) ranging from 50 to 10,000 ppm. As before, it analyses methane (CH4), carbon dioxide (CO2) and oxygen (O2). The new developments, as options, enhance the already widely used ATEX Zone 2 certified ...


    By Geotech

  • Spectro Arcos--the ultimate ICP-OES for sample throughput and sensitivity

    It’s Name Tells It All: ARCOS (Advanced Rowland Circle Optical System) New Optics Offer Up to 2-Times Better Resolution Making  Ideal ICP-OES for Line-Rich Matrices and for Ultra-Trace Analysis Kleve, Germany, February - SPECTRO Analytical Instruments unveils the latest state-of-the-art ICP-OES instrument --the SPECTRO ARCOS—at the Pittcon Conference (February 25 to March 1, 2007) in ...

  • Ankersmid Components for Gas Analysis Systems

    Ankersmid have designed, developed and manufactured a complete product portfolio of gas conditioning products. a1-cbiss ltd selected the Ankersmid products to be integrated into the sampling system because of their good reputation and the excellent product features.known for their innovative and high performance gas conditioning and analysis equipment, Ankersmid now supply these gas conditioning ...


    By a1-cbiss

  • ASTM E1216 - 11 standard practice for sampling for particulate contamination by tape lift

    The tape lift provides a rapid and simple technique for removing particles from a surface and determining their number and size distribution. By using statistically determined sample size and locations, an estimate of the surface cleanliness level of large areas can be made. The user shall define the sampling plan. The sampling plan shall consider the importance of surface geometry ...


    By ASTM International

  • Syngas Cleaning Station for Gas Analysis

    Remove TAR , Dust & Water vapour Transportable with 3 refillable bubbler Inlet from process Hi-Temperature probe Peltier cooler with 1 heat exchanger Internal Sample pump Gas sample out dry @ 5 ⁰C Max Flow sample out 300 Nl/h Low cost of ownership Cooler maintenance free Universal uses in sampling gas ...


    By ETG Risorse e Tecnologia

  • Free on-site multiparameter gas analysis

    Quantitech Ltd has launched the world’s first truly portable FTIR multicomponent workplace gas analyser and in order to enable prospective users to see the technology for themselves, the company's Dr Andrew Hobson is offering to visit sites and run tests completely free of charge. This offer is available for a limited period of time, but Dr Hobson says, “In the past, field-use instruments for the ...


    By Quantitech Ltd

  • Natural gas wastewater re-use

    When it became apparent the natural gas industry in the Marcellus Shale was going to create a need for treating large quantities of wastewater, the Larson Design Group found itself uniquely positioned to fill that niche creating a subsidiary, TerrAqua Resource Management, which treats for re-use industry wastewater adjacent to its offices at Water Tower Square on Commerce Park Drive. The ...

  • ASTM D6831 - 11 Standard Test Method for Sampling and Determining Particulate Matter in Stack Gases Using an In-Stack, Inertial Microbalance

    The measurement of particulate matter is widely performed to characterize emissions from stationary sources in terms of total emission rates to the atmosphere for regulatory purposes. This test method is particularly well suited for use in performance assessment and optimization of particulate matter ...


    By ASTM International

  • Genie membrane filters protect against Analyser Liquid damage

    When gas is extracted from a gas field, it requires processing before it can be sold. In the natural gas industries, one of the most important, yet difficult and challenging tasks for process engineering is measuring moisture in a multitude of process gases and liquids. Liquids and moisture will naturally make up a proportion of gas samples. In order to make the gas suitable for sale and use, the ...


    By a1-cbiss

  • ASTM D6831 - 11 Standard Test Method for Sampling and Determining Particulate Matter in Stack Gases Using an In-Stack, Inertial Microbalance

    The measurement of particulate matter is widely performed to characterize emissions from stationary sources in terms of total emission rates to the atmosphere for regulatory purposes. This test method is particularly well suited for use in performance ...


    By ASTM International

  • ASTM D6831 - 11 Standard Test Method for Sampling and Determining Particulate Matter in Stack Gases Using an In-Stack, Inertial Microbalance

    The measurement of particulate matter is widely performed to characterize emissions from stationary sources in terms of total emission rates to the atmosphere for regulatory purposes. This test method is particularly well suited for use in performance assessment and optimization of particulate matter control systems, continuous ...


    By ASTM International

  • On-Site Gas Analysis like Never Before

    Gasmet Technologies from Finland is a leading manufacturer of FTIR gas analyzers for demanding industrial gas monitoring applications. The latest addition to the Gasmet product family is the Gasmet Dx-4030, which is the first truly portable FTIR gas analyzer on the market. The key to Gasmet Dx-4030’s unique portability lies in its ingenious construction; the analyzer module is located in a sturdy ...


    By Gasmet Technologies Oy

  • Tanaka Precious Metals Establishes Ultrathin Membrane Processing Technology for Palladium-based Hydrogen Separation (Permeation) Membranes; Starting Provision of Samples to Europe, the US and Asia

    Tokyo, July 14, 2010 - (JCN Newswire) - Tanaka Holdings Co., Ltd. (a company of Tanaka Precious Metals) announced today that Tanaka Kikinzoku Kogyo K.K. (a company of Tanaka Precious Metals) has established an ultrathin membrane processing technology for rolled palladium based foils used for hydrogen separation (permeation) membranes, and will begin provision of samples to Europe, the US and ...


    By Japan Corporate News - JCN

  • Revolutionary FTIR gas analyser now available to rent from Quantitech

    The Gasmet DX-4030, the first truly portable FTIR gas analyser in the world, is now available to hire from specialist environmental instrumentation company Quantitech. The DX-4030 is a revolutionary new analyser based on tried and tested Gasmet technology providing both field-usability and high levels of analytical performance. The DX-4030 employs FTIR (Fourier Transform InfraRed Spectroscopy) ...


    By Quantitech Ltd

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you