Goudsmit Magnetic Systems BV

Magnetic system separates three types of metal at the same time - three-stage magnetic separator removes all metals from waste streams

0

Source: Goudsmit Magnetic Systems BV

Goudsmit has recently designed and produced a compact unit that combines a conventional magnetic separator, high-gradient separator and non-ferrous separator. This three-stage separator removes normal iron parts, followed by weakly magnetic metal parts (including a large variety of stainless steels), and finally non-ferrous metal parts. This all takes place over a distance of approximately 7 metres. Incorporating all three stages in a single compact unit makes it easy to integrate the separator into existing processing lines. This simplifies collection and disposal of the various metal fractions. This compact separator has recently been installed in a WEEE scrap recycling line in the UK.

Recycling industry
The system is specifically built for the recycling industry and intended for use in severe and dirty working environments. The three-stage separator is available with a working width of up to 2000 mm, which allows large quantities of waste to be processed. The complete system consists of a base frame, a vibrating grating, a control unit, and the three-stage separator. The separator consists of a conventional Neoflux® end-roll magnet for the first stage, a high-gradient end-roll magnet for the second stage, and an eddy-current separator for the third stage. Goudsmit has built a test installation for conducting trials, which enable a good estimate of the expected results to be obtained.

Customer comments

No comments were found for Magnetic system separates three types of metal at the same time - three-stage magnetic separator removes all metals from waste streams. Be the first to comment!