Atomization - Water-Soluble Systems
ODOR ARMOR formulations are diluted with water and then pressurized to 1000 psi to create a fine atomization at each nozzle. When the odor control solution is released, the ultra fine atomized odor control droplets collide with nuisance odor compounds where a series of chemical reactions occur that neutralize the nuisance odor before it migrates off the facility.
All units include thermal protection on the motor circuit and branch circuits and include high quality industrial components from ABB, Danfoss, and CAT Pump. The system can be built into existing environmental controls or can be configured with remote operational control. Pumps are configured with site specific operational accessories to maximize performance, cost efficiency and reliability. This includes a variety of added components to enhance system performance or system control including Programmable Logic Control (PLC) , wind & rain sensors, Variable Frequency Drive (VFD) inverters, inclusion of high efficiency motors, Increased bare pump capacity, low and high pressure safety switches, electric drain valves, and automated air purge capability.
High-pressure atomization systems can be used by installing nozzles on high pressure lines around the exterior of facilities, used as nozzle rings on existing duct work or fans, installed overhead in large covered facilities or as lines running along the perimeter of entry/exit points. The fog does not produce wetness on equipment, people or the grounds due to our high-pressure technology that atomizes the water droplets.