F&J Specialty Products, Inc.

- Model DF-14M - Cart Mounted Mobile Low Volume Air Sampler

From

0

The Model DF-14M cart mounted mobile low volume air sampler with digital flowmeter has an adjustable, aluminum sampling gooseneck. The adjustable gooseneck permits sampling at heights varying from 4’ to 7’ above floor level. Model DF-14M contains state of the art microprocessor electronics, which provides for corrected flow rate measurements, volume totalizations, and an RS232 communications port. It has a large bright LED display.

The DF-14M Air Sampler includes an oil-less, carbon vane vacuum pump with a constant airflow regulator for use where a nearly constant airflow is desirable. The regulator holds a constant pressure drop across an in-line orifice by varying the flow through a bypass valve into the pump. This system allows the pump to work at a minimum pressure drop at all times, permitting it to run cooler, thus extending its lifetime. The oil-less pump requires no lubrication to maintain optimal efficiency during its service life. The pump is mounted on a mobile cart with two rubber wheels to permit mobile transportation of the unit.

The DF-14M Air Sampler is designed for indoor use. The typical operating flow range is 0.5 to 4 CFM (14 to 115 LPM).

  • Bright LED display
  • Flowrate and volume totalizations displayed are corrected to a factory settable Reference Temperature and Pressure (4 options available)
    • Classical STP : 0ºC, 760 mmHg
    • Normal T and P : 20ºC, 760 mmHg
    • Modified Normal T and P : 21,1°(70ºF), 760mmHg
    • Standard Ambient T and P : 25ºC, 760 mmHg
  • Reference or ambient flow conditions are operator selectable
  • Elapsed time meter
  • RS-232 Communication Port w/Operator selectable download frequency for real-time data
  • Storage of elapsed time and volume in the event of power outage
  • Auto Shut-off on time or volume
  • Choices of flow/volume units:
    • SLPM : SL
    • SCMH : SCM
    • SCFM : SCF
  • Display in English or metric units set at factory
  • State of the Art microprocessor electronics
  • Auto zero calibration feature of flow sensor
  • Flow rate accuracy within ± 4% F.S.
  • 110 – 120 VAC, 50/60Hz; single phase

  • PUMP TYPE: Oil-less, carbon vane ¼ HP, 1725 RPM @ 60 Hz
  • MAXIMUM CAPACITY: 4 CFM (115 LPM) @ 0” Hg Pressure drop
  • ULTIMATE VACUUM: 25” (635 mm) Hg @ sea level
  • POWER REQUIREMENTS: 110-120VAC; 50/60Hz; 6 amperes, single phase
  • CIRCUIT BREAKER PROTECTION: 10 amps
  • ELECTRICAL CORD: All temperature, 3 wire, 14 gauge
  • THERMAL OVERLOAD PROTECTION: Furnished as an integral part of the motor
  • CONSTANT AIRFLOW
  • REGULATOR: Aluminum construction with silicone diaphragm; adjustable from 0.5 to 4 CFM (14-115 LPM)
  • DIMENSIONS: 18”L×15”W×4’ – 7’H (46×38×122 - 213 cm)
  • WEIGHT: 67 lbs. (30,4 kg)
  • INSTALLATION CATEGORY: Pollution Degree 2
  • OPERATING TEMP. RANGE: 32º to 104ºF (0º to 40ºC)
  • SAMPLING GOOSENECK: Adjustable 4’ to 7’ (122 cm – 213 cm) sturdy aluminum
  • WHEELS: 8”, hard rubber

ELECTRONIC SPECIFICATIONS:

  • MEASUREMENT ACCURACY:
    • Air flow ± 4% of full scale
    • Temperature ± 2ºF (1,1ºC)
    • Barometric Pressure 2% over measured range
  • CALIBRATION: Factory calibration 1 per year
  • COMMUNICATIONS INTERFACE: RS-232 serial port

ON-BOARD CALCULATIONS:

  • Flow calculation from differential pressure value suing best fit curve method
  • Flow correction for standard temperature and pressure
  • Auto-zero correction utilizing electro-pneumatic method to compensate for offset and drift (automatic, once every minute)
  • OPTIONS:
    • Data Storage Device (P/N: 232FCDSD)
    • 2+ GB Secure Digital Card (P/N: 372239)
    • Flash card Reader (P/N: SDDR-199-A20)

Customer reviews

No reviews were found for F&J - Model DF-14M - Cart Mounted Mobile Low Volume Air Sampler. Be the first to review!