acoustics monitoring instrument Equipment

Eco Tech - Model Type WK-8 - Multichannel Acoustic Calibrator

Multichannel Acoustic Calibrator Type WK-8 is designed for calibration of multichannel acoustic measurement systems equipped with a half-inch measuring microphones in the field ...

By Eco-Tech based in Warszawa, POLAND. from Acoustic Monitoring Instruments Product line

SoDAR) - Model 101 - Sonic Detection and Ranging Technology

This section is designed to provide a brief introduction to Sonic Detection And Ranging (SoDAR) technology. Please expect it to be revised as part of a continuous improvement process. A SoDAR is an acoustic instrument for monitoring the atmospheric environment similar to SONAR which is used for monitoring the ...

By Radiometrics Corporation (formerly Atmospheric Systems Corporation) based in Boulder, COLORADO (USA). from Technology Product line

Eco Tech - Model Type UF-1 - Ultrasonic Source

Ultrasonic Source Type UF-1 generates ultrasounds signals for acoustical testing of measurement microphones and its wind-screens by under free-field ...

By Eco-Tech based in Warszawa, POLAND. from Measuring Instruments- Ultrasound Measurements Product line

Eco Tech - Model Type STM-1 - Tapping Machine

Tapping Machine Type STM-1 is intended for measurements of acoustic insulation of ceiling in buildings. The unit fulfils Annex A of ISO 140-6/7. These parts of the standard require a tapping machine as a sound source for impact noise measurements. Type STM-1 is available with an optional remote ...

By Eco-Tech based in Warszawa, POLAND. from Measuring Instruments- Building Acoustics Product line

Model DCC-1448 and PQC-3048 - Digital Microphone

Listen offers 2 MEMS digital microphone measurement interfaces from Portland Tool & Die, the laboratory-grade DCC-1448 and the low cost PQC-3048 for production line use. The DCC-1448 and PQC-3048 interface your MEMS microphone to the SoundCheck test system, converting the 1-bit PDM output of a Digital MEMS microphone to the 24-bit, 48kHz PCM signal accepted by audio test systems. This enables ...

By Listen Inc based in Boston, MASSACHUSETTS (USA). from Electronic Interfaces Product line

AWSensors - Model AWS X1 - Modular QCMD System

X1 is a single channel, advanced acoustic QCMD sensing instrument which ...

By Advanced Wave Sensors (AWSensors) based in Paterna, SPAIN. from Instruments Product line

Model A4404-SAB - 4-Channel Vibration Analyser

The A4404 – SAB is a pocket sized 4-channel vibration analyser.This module has been developed for service and analytical operations, similar to the A4400 – VA4 Pro. However, the difference is that the A4404 – SAB connects to a computer. When the A4404 – SAB is connected to any computer by USB and the software VA4 Pro DDS software?is running, you can obtain the same ...

By Applied Maintenance Technology Ltd. based in Pontefract, UNITED KINGDOM.

AWSensors - Model AWS X4 - Advanced Multichannel QCMD System

X4 is a multichannel advanced acoustic QCMD sensing instrument which ...

By Advanced Wave Sensors (AWSensors) based in Paterna, SPAIN. from Instruments Product line

Model MC3122 - 2-Channel Acoustic Measurement Instrument With Gain

MC3122 is a classical Plug-N-Play 2-channel USB data acquisition hardware with two ICCP input channels and two output channels. It is developed for the acoustic measurement in laboratory and field applications. With BSWA VA-Lab software, MC3122 can be used in environmental noise, architectural acoustics, audio ...

By BSWA Technology Co., Ltd. based in Beijing, CHINA. from Real Time Analyzers Product line

EOM - Model MFN-MRS - Multifunction Node-Marine Recovery System

The Multifunction Node-Marine Recovery System (MFN-MRS) has customizable configurations for multiple seafloor instruments and functions as a power and communications node that can integrate with existing seafloor power grids and communication networks. This configuration ensures the delivery of power and ...

By EOM Offshore, LLC based in Pocasset, MASSACHUSETTS (USA).

Teledyne RD Instruments - Workhorse Monitor ADCP

The MONITOR is Teledyne RD Instruments’ most popular direct-reading Acoustic Doppler Current Profiler (ADCP). The unit is typically bottom frame-mounted and hard-wired to shore to provide real-time monitoring of coastal currents. ...

By Teledyne RD Instruments based in Poway, CALIFORNIA (USA).

Eco Tech - Model Type IFC-1 - Infrasound Calibrator

Infrasound calibrator Type IFC-1 is used to calibration of acoustic measuring instruments adapted to measurements in the infrasound frequency range. The Type IFC-1, when connected to the microphone of the tested instrument generates a sinusoidal sound pressure signal SPL = 94 dB at frequency 10 Hz or 20 Hz in ...

By Eco-Tech based in Warszawa, POLAND. from Measuring Instruments- Infrasound Measurements Product line

Sontek - Model 10-MHz - Acoustic Doppler Velocimeter

The SonTek 10-MHz ADV (Acoustic Doppler Velocimeter) is a proven, accurate solution for high-precision, 3-axis (3D), velocity measurements in a wide variety of settings from the laboratory to the ocean. ADV performance has been shown to compare favorably with laser Doppler systems costing ten times as ...

By SonTek - A Xylem Brand based in San Diego, CALIFORNIA (USA).

Small Device Test Chambers

the sounds from the device under test radiating into the host space. They also provide sound absorptive interior environment to minimize acoustic reflections that will affect the measured sound pressure levels. Small Device Test Chambers available in several standard sizes and can be instrumented with acoustic ...

By VIacoustics based in Austin, TEXAS (USA). from Acoustic Test Chambers Product line

ABS - Cavitation Suceptibility Meter

Research & Development at Dynaflow, Inc. has yielded a new product, the ABS Cavitation Susceptibility MeterTM (ABS-CSMTM) based on an acoustic technique to generate and measure cavitation inception in a liquid. This product is now offered to users to enable quantification of the cavitation susceptibility, ...

By Dynaflow, Inc. based in Jessup, MARYLAND (USA).

Cirrus - Model CR:514 & CR:515 - Acoustic Calibrators - Class 1 and Class 2 with Type Approval

Cirrus manufactures a range of Acoustic Calibrators and adaptors suitable for the field calibration of sound level meters, noise dosimeters and other noise measurement ...

By Cirrus Research plc based in Hunmanby, UNITED KINGDOM. from Acoustic Calibrators Product line

Sound & Vibration Meters - SVAN 955

The SVAN 955 is all digital, Type 1 sound meter along with analyser. Instrument is intended to general acoustic measurements, environmental noise monitoring, occupational health and safety monitoring. Using computational power of its digital signal processor the SVAN 945A can perform real time 1/1 & 1/3 ...

By Wibro-Akustyka WAF based in Ostrów, POLAND.

DTI - Model DT-1202 - Acoustic and Electroacoustic Spectrometer for Particle Size & Zeta Potential Analyzer

The Model DT-1202 is an Acoustic and Electro-Acoustic Spectrometer capable of measuring Particle size distribution and zeta potential in concentrated dispersions and ...

By Dispersion Technology Inc. based in Bedford Hills, NEW YORK (USA).

Heraeus - Model 5 W - Xenon Flash Lamp

Heraeus manufactures a wide range of cool running xenon flash lamps, devices which efficiently convert electrical energy stored in a capacitor into a high intensity light flash. All the lamps use materials which are specially selected for high performance and long life. They are manufactured using high temperature and high vacuum processing, which ensures a high integrity product. Finally, each ...

By Heraeus Holding GmbH based in Hanau, GERMANY. from Optics and Analytics Product line

SVAN - Model 979 - Advanced and Powerful Sound Level Meter and Analyzer

SVAN 979 is a powerful and advanced real-time sound and vibration analyzer for use in acoustical engineering, high-priority monitoring, and safety applications. The SVAN 979 has features and sensitivity commonly found precision laboratory equipment but in a portable sound and vibration meter and ...

By Sensidyne Industrial Health and Safety based in St. Petersburg, FLORIDA (USA). from Sound and Vibration Instruments Product line