air duct equipment in Netherlands

  • Aerox - Injector Odour Control System

    The Aerox-Injector is a highly innovative injection based odour control system that is fitted outside the process gas duct. It has been successfully installed at over 250 locations worldwide in a wide range of industries.

    By Aerox B.V. based in Vleuten, NETHERLANDS.

  • GrowAir - End Cap with Air Opening

    This end cap need to be installed at the end of your duct. The holes will supply some air in the middle pad and haze a fixing point to adjust the duct to the gutter on the end.

    By KE GrowAir B.V. based in Strijen, NETHERLANDS.

  • GrowAir - Plenum with Air Guidance Blades

    The plenum connects the fan or air handling unit with the GrowAir duct and because of the air guidance blades you will have even less turbulence in the first meters of your duct.

    By KE GrowAir B.V. based in Strijen, NETHERLANDS.

  • GrowAir - End Cap with Adjustable Air Opening

    This end cap need to be installed at the end of your duct. The adjustable holes will supply some air in the middle pad and haze a fixing point to adjust the duct to the gutter on the end.

    By KE GrowAir B.V. based in Strijen, NETHERLANDS.

  • GrowAir - Fan

    In semi closed greenhouses it is common to use a corridor to mix the air to create optimal conditions. The air will be transported out of the corridor by a fan into a plenum and air distribution ducts. The fan and the air distribution system have to be in balance with each other to get an optimal working system for gaining optimal conditions to ...

    By KE GrowAir B.V. based in Strijen, NETHERLANDS.

  • Premium

    Boreal Laser - Stack/Duct Probe

    The probe is an engineered solution for our series of GasFinder analyzers toremotely monitor the path average concentrationinside of a stack or duct

    By Boreal Laser Inc. Distributor in NETHERLANDS. from Stack/Duct Probe Product line

  • Model AMS series - Oil Fired Heater

    Oil (diesel or petroleum) is a good alternative, when gas is not available as a fuel for your heaters. The AMS oil heater has closed combustion, which means that flue gasses cannot get in the greenhouse, but leave the greenhouse via an extraction duct after the heat has been maximally extracted from these flue gasses. Fresh outdoor air is also ...

    By Holland Heater Export B.V. based in MC De Lier, NETHERLANDS. from Oil Fired Heater Product line

  • Premium

    Proline - Model t-mass B 150 - Thermal Mass Flowmeter

    The flowmeter for cost-effective measurement and easy monitoring of utility gases. The t-mass B 150 insertion version is suitable for large pipelines or rectangular ventilation ducts. It is designed for the cost-effective measurement of utility gases, in particular compressed air. It is a trending device aimed at sub-metering applications. Its ...

    By Endress Hauser AG Office in Naarden, NETHERLANDS. from Thermal Mass Flowmeter Product line

  • Model DO 2003 - HVAC Datalogger

    The DO2003 is a datalogger portable unit, especially designed to make measurements in the field of air-conditioning, heating, ventilation, environmental comfort, energy saving, both in private and industrial sectors, thanks to a complete series of dedicated probes. It measures air speed and flow in ducts, pipe or vents with hot-wire, vane or Pitot ...

    By Delta OHM - member of the GHM GROUP Office in Soesterberg, NETHERLANDS. from HVAC Datalogger Product line

  • Premium

    OSi - Model OFS-2000 - Emissions/Air Flow Sensor

    OSi's patented Optical Flow Sensor (OFS) makes drift-free measurements across the entire stack, duct or pipe diameter and calculates an accurate average flow reading. It is the only flow sensor that gives a true non-contacting cross-stack flow measurement of the process. The OFS uses our EPA Method 14 approved optical scintillation technology. The ...

    By Optical Scientific Inc. (OSi) Distributor in NETHERLANDS. from Emissions/Air Flow Sensor Product line

  • Premium

    OSi - Model OFS 2000-W - Emissions/Air Flow Sensor

    OSi's patented Optical Flow Sensor (OFS) makes driftfree measurements across the entire stack, duct or pipe diameter and calculates a true average flow reading. The OFS 2000-W model is equipped with Automatic Gain Control (AGC) to compensate for variations in opacity caused by particulate matter or moisture carried in the stack flow. The OFS uses ...

    By Optical Scientific Inc. (OSi) Distributor in NETHERLANDS. from Emissions/Air Flow Sensor Product line

  • SafEye - Model 300 Series - Open Path Duct Mounting Detectors

    he Duct SafEye Open Path Detectors were specially designed and are widely used to monitor ingress of hazardous flammable gas concentrations into air intakes of turbine engines and HVAC air ducts. Duct applications require that the small path across an air inlet responds with a very high sensitivity, full scale of 1 LEL.m for 2-6.6 ft (0.6-2 m) ...

    By Spectrex Inc Distributor in Berkel en Rodenrijs, NETHERLANDS. from Open Path Duct Mounting Detectors Product line

  • Premium

    OSi - Model OFS-2000F - Flare Stack Flow Sensor

    OSi's patented Optical Flow Sensor (OFS) makes drift-free measurements across the entire stack, duct or pipe diameter and calculates an accurate average flow reading. It is the only flow sensor that gives a true non-contacting cross-stack flow measurement of the process. The OFS uses our EPA Method 14 approved optical scintillation technology. The ...

    By Optical Scientific Inc. (OSi) Distributor in NETHERLANDS. from Flare Stack Flow Sensor Product line

  • RoboticsDesign - Model ANATROLLER ARI-50 - Mobile Robots

    The ANATROLLER ARI-50 is a durable, modular, compact, resilient and reliable robot. This robot is highly specialized for air duct cleaning and inspection, and because of its compact size, it is able to clean small ducts (6x6 inches) with ease. The robot is light-weight and fast and is able to carry 4 times its weight and tow an incredible 9 times ...

    By Robotics Design Inc. Distributor in SOESTERBERG, NETHERLANDS. from Mobile Robots Product line

  • Master-Touch - Model Series 9000MP - Multipoint Thermal Mass Flow Meter

    Multipoint Systems are designed to measure gas flows where two or more sensing points are required due to large cross-sectional areas, such as large air intake ducts or air exhaust and flue stacks. These systems can have up to 5 sensors on each probe. Our System Control Panel (SCP) will average all sensors from all probes. Many probes can be ...

    By Eldridge Products, Inc. (EPI) Distributor in Uithoorn, NETHERLANDS. from Multipoint Thermal Mass Flow Meter Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you