Air Treatment Equipment In Australasia
-
PremiumManufactured by Jacobi Groupbased in SWEDEN
Activated carbons designed for air and gas treatment, covering a diverse set of applications including VOC abatement in air, odour control, solvent recovery, process gas purification, residential and commercial air treatment devices, cigarette filters, and cabin air filters and evaporative loss ...
-
Manufactured by Silex Internationalbased in FRANCE
Silex International provides a complete range and unique equipments for Biological treatment, chemical scrubbing and active carbon absorption ...
-
Manufactured by Silex Internationalbased in FRANCE
Fully made in Stainless steel, the SS Striper is supplied with the following equipments. Standard strippers are supplied with 3 stages: Depending of the flow rate and efficiency required, different stages can be provided. From the top of the stripper, the water comes in and passes through the stages which are opening to allow the ...
-
Manufactured by DELTAwater Solutionsbased in AUSTRALIA
The DELTA Evaporative Air Conditioners Water Treatment range is custom-designed to treat the problems caused by high levels of hardness, salinity, minerals and iron in water in evaporative air-conditioning units. After you install a DELTA Evaporative Air Conditioners Water Treatment unit, your ...
-
Manufactured by Dimplex - a division of the GDC Groupbased in UNITED KINGDOM
This Dimplex air purifier has been designed to improve the quality of air indoors, reducing the presence of polluting agents such as dust, cigarette smoke, unpleasant odours, spores, bacteria, pollen, dust mite residues, pet dander etc. Air goes through an active carbon filter which helps to eliminate odours such as cigarette smoke. The ...
-
Manufactured by MikroPul - a Nederman companybased in USA
Lowering the inlet temperature with evaporative cooling can increase system heat rate, while only causing a relatively small increase in inlet pressure drop. Proper monitoring of wet and dry bulb temperatures will allow most operators to recognize changes in cooler system performance. However, best operation and reliability can also be achieved with periodic inspections by using high-quality ...
-
Manufactured by MikroPul - a Nederman companybased in USA
The operation of combustion gas turbines in cold climates can present a unique problem: inlet icing. Icing can plug static inlet filtration systems, thereby causing the implosion doors to open and the gas turbine to ingest unfiltered air. Icing can also rapidly increase the pressure drop across trash screens and other inlet components, ...
-
Manufactured by Baccara Geva (Australia) Pty Ltdbased in AUSTRALIA
This G1/4" pneumatic FRL (Filter Regulator Lubricator) unit is used to filter out contaminants larger than 5 μm, regulate the output pressure between 0.5 - 10 bar, and lubricate the air with oil. Includes a pressure gauge. The max flow rate is 1200 l/min (always use the flow chart for correct sizing). The semi-auto drain valve will open ...
-
PremiumManufactured by Jacobi Groupbased in SWEDEN
Activated carbon products designed for the oil and gas industry, covering water treatment, vapour treatment, and process applications in petrochemical ...
-
PremiumManufactured by Aerzener Maschinenfabrik GmbHbased in GERMANY
Negative pressure stage with pre-inlet cooling. Proven 3-lobe blower technology for system manufacture for forced conveying in negative pressure up to 80 % vacuum. Oil-free and extremely robust. Belt or direct drive version. Ideal for bulk and silo ...
-
PremiumManufactured by HRS Heat Exchangers Ltd.based in UNITED KINGDOM
HRS Asepticblock Series is a packaged pasteuriser/steriliser and aseptic filler in a compact skid for thermal treatment and aseptic filling within a wide range of products for the food industry, with the same characteristics in quality and aseptic reliability as bigger size ...
-
PremiumManufactured by VPInstrumentsbased in NETHERLANDS
The VPFlowScope® DP is the ultimate measurement tool for saturated compressed air flow measurements. The unique design enables you to take measurements in the discharge pipe of a compressor under 100% saturated conditions. You can combine the probe with two display module types or with a connector cap without ...
-
PremiumManufactured by Aerzener Maschinenfabrik GmbHbased in GERMANY
Robust 3-lobe blower stage for system manufacture. Versatile application. Designed for belt drive. Low pulsation and reduced piping noise. Available in 22 sizes as ...
-
PremiumManufactured by Aerzener Maschinenfabrik GmbHbased in GERMANY
Robust 2- and 3-lobe blower stage for mounting on bulk and silo vehicles with extended pressure differences up to 1.2 bar. Two-sided conveying direction with horizontal or vertical flow. Direct or belt drive version. Proven technology, ...
-
PremiumManufactured by ENVEAbased in FRANCE
The MIR 9000H is a multi-gas analyzer using the Gas Filters Correlation technology (GFC). With its hot measurement principle (180 °C on a hot and humid sample), the MIR 9000H is the perfect tool for the analysis of the main gas parameters in many applications, including DeNOx (SCR / SNCR) and the optimization of flue gas treatment ...
-
Manufactured by AFPRO Filters B.V. - Filtration Groupbased in NETHERLANDS
GP Panel Filter are used as a pre-filter for air treatment cabinets, air conditioning systems and industrial systems. This panel filter is a pleated air filter assembled within a moisture-resistant cardboard frame. Medium: Glass fiber. Gasket: Optional ...
-
Manufactured by Pacific Character Productsbased in AUSTRALIA
SYSTEMS provide a simple, cost effective solution for odour control problems and air treatment. The adsorber is constructed of HDPE for corrosion, weather resistance and durability. All fittings are welded to the tank and vessels up to 50 inches have removable tops for easy service. Larger vessels have a 20 inch manway for access. ...
-
Manufactured by Pacific Character Productsbased in AUSTRALIA
GENERAL CARBON FS Systems provide a simple, cost effective solution for large odour control problems and air treatment applications. The adsorber is made from fiberglass reinforced plastic for corrosion and weather resistance as well as strength and durability. All connections are laminated onto the tank during the hand lay-up process. Two ...
-
Manufactured by Silex Internationalbased in FRANCE
Venting equipment: Especially designed for air treatment in contaminated site, the venting unit allows to pump saturated air from contaminated soil in order to treat it. Air pumped is run to an active carbon filter to discharge hydrocarbon compounds before release to the ...
-
Manufactured by Muntersbased in USA
One single stage or 2 superposed V shaped units on 2 support layers. Flushing systems are installed on either up- and/ or downstream side of the mist eliminators. Target applications are Flue gas desulphurization plants for processes with high turn down ratios, Exhaust air treatment plants, Waste Incineration plants and Inlet and exhaust ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you