Atmospheric Modeling Equipment Available In Canada
-
Manufactured by TSI Incorporatedbased in USA
number concentration in ambient air. It describes a standardized method not only for the Condensation Particle Counter (CPC), but also for its sampling and conditioning system. The Model 3772200 Sampling System for Atmospheric Aerosol is designed to match the requirements of CEN/TS ...
-
PremiumManufactured by Particle Measuring Systems (PMS)based in USA
The HPD II reduces the pressure of dry, inert, non-toxic, non-flammable gases, such as Clean Dry Air (CDA), nitrogen, carbon dioxide and argon to a level acceptable for the Lasair II 110 and Lasair III 110 aerosol particle counters, which are designed to operate at atmospheric ...
-
PremiumManufactured by For.Tec. Forniture Tecnologiche S.r.l.based in ITALY
Crematory ovens mod. FT have been designed with an innovative technique which allows to maximize the cremation process, thanks to finest refractory materials and systems for heat recovery and reutilization which otherwise would be lost in the ...
-
PremiumManufactured by Qingdao Leice Transient Technology Co., Ltd.based in CHINA
(signal-to-noise ratio), backscattering intensity, ground temperature and humidity, and other data products. It is widely used in meteorological climate research, weather forecasting model assimilation, atmospheric material flux and pollutant area transmission and diffusion research, low-altitude wind shear detection and many other fields. ...
-
Manufactured by VANECbased in USA
The VANEC Model 412 Vent and Blowdown Silencer is designed for use in suppressing the noise associated with venting high-pressure gas or steam to atmospheric pressure. The Model 412 Vent & Blowdown Silencer, when properly applied, will reduce the gas discharge noise to a community acceptable level for dwellings located further than 1,600 ...
-
Manufactured by JP Selecta S.A.based in SPAIN
AISI304 stainless steel external case and top. Stainless steel chamber and lid, with easy opening. INCOLOY special stainless steel heater element, which provides long life, low corrosion and high temperatures resistance. Manual air purge when starting ('MICRO 8' model). Automatic atmospheric purge ('MED 12' and 'MED 20' models). Safety ...
-
Manufactured by Dartek S.Lbased in SPAIN
the framework of a continuous improvement of its features. The MVSI series has been designed to guarantee elevated features in all types of use and atmosphere conditions and complies with the most recent international IEC and EN standards on its use in potentially explosive dust atmospheres. Specially, MVSI model can be used in zones 21 and ...
-
Manufactured by VANECbased in USA
The VANEC Model 316 Intake Silencer is designed for use in suppressing the intake noise from high speed blowers, fans, engines and centrifugal air handling devices with an atmospheric suction. The Model 316 Intake Silencer, when properly applied, will reduce intake noise to a community acceptable level for dwellings located further than 1,600 ...
-
Manufactured by VANECbased in USA
The VANEC Model 316 Intake Silencer is designed for use in suppressing the intake noise from high speed blowers, fans, engines and centrifugal air handling devices with an atmospheric suction. The Model 316 Intake Silencer, when properly applied, will reduce intake noise to a community acceptable level for dwellings located further than 1,600 ...
-
Manufactured by Boreal Laser Inc.based in CANADA
Primary uses of the GasFinder3-OP are to: Continuously monitor gas concentrations over open area sources. Provide immediate and unambiguous detection of gas leaks. Can be combined with weather data and an atmospheric dispersion model to give a measured emission rate. ...
-
Manufactured by Boreal Laser Inc.based in CANADA
. There is no complicated start-up procedure just plug it in and go. Data collection is simple and intuitive (no PhD needed!). The analyzer has the ability to paired with a tilt-pan programmable scanner, meteorological station, and a atmospheric dispersion model to accurately quantify concentrations over a open area source. ...
-
Manufactured by Super Systems India Pvt. Ltd.based in INDIA
The RPS reads the signal from two oxygen probes located in the same furnace, automatically switching the output from the 9120 using the oxygen probe with the highest millivolt output. Additionally a manual selection of the probe is ...
-
Manufactured by Super Systems Inc.based in USA
The RPS reads the signal from two oxygen probes located in the same furnace, automatically switching the output from the 9120 using the oxygen probe with the highest millivolt output. Additionally a manual selection of the probe is ...
-
Manufactured by The Bilco Companybased in USA
LadderUP Safety Posts provide easier, safer ladder access through roof hatches, floor access doors, and manholes. This telescoping post permanently mounts to the top two rungs of any fixed ladder, providing a positive hand-hold and enabling the user to enter or exit an opening in an upright and balanced ...
-
Manufactured by McPhersonbased in USA
The Model 642 soft x-ray source is a compact, convenient to operate source for the 2keV to 50eV region. The unique dual-output of equivalent beams make it a useful source for many comparative applications in addition to wavelength calibration and so on. The two output beams originate from two views of the single emitting spot where the ...
-
Manufactured by CI Systemsbased in USA
CI Systems’ advanced architecture ControlMaster; SR-800N sets a new standard for accuracy and uniformity in blackbody technology. Temperature measurement and calibration are both performed in the radiation head itself and then transferred digitally to the ControlMaster controller. The result is accurate, stable, reliable and NIST- traceable. Temperature is controlled by easily-removable ...
-
Distributed by Preiser Scientific Inc.based in USA
The Preiser Scientific Ash Fusion System is designed to determine ash cone deformation temperatures in coal and coke ash per ASTM Standard D-1857 and ISO Standard 540 (CO/CO2 reducing atmosphere ...
-
Distributed by Preiser Scientific Inc.based in USA
The Preiser Scientific Ash Fusion System is designed to determine ash cone deformation temperatures in coal and coke ash per ASTM Standard D-1857 and ISO Standard 540 (CO/CO2 reducing atmosphere ...
-
Manufactured by Solar Lightbased in USA
Model 540 MICROTOPS II Sunphotometer is a 5 channel hand-held sunphotometer for measuring aerosol optical thickness easily, accurately and dependably. Direct solar radiation at 5 discrete wavelengths is measured and stored. MICROTOPS II Sunphotometer features an accuracy comparable to much larger and more expensive instruments. Optional ...
-
Manufactured by Jiangyin Yimaisheng Hydraulic Machinery Co., Ltd.based in CHINA
that adhere to the chips are efficiently recovered by our scrap briquetting press. The metal briquette machine plays an important role in metal recycling, especial in re-melting the steel briquettes and decrease pollution from the ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you